From: Fabien Parent <fparent@baylibre.com>
To: matthias.bgg@gmail.com, linux-arm-kernel@lists.infradead.org,
linux-mediatek@lists.infradead.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org
Cc: Fabien Parent <fparent@baylibre.com>
Subject: [PATCH v3 2/2] arm64: dts: mediatek: add pumpkin board dts
Date: Sat, 29 Feb 2020 18:04:01 +0100 [thread overview]
Message-ID: <20200229170401.1287324-2-fparent@baylibre.com> (raw)
In-Reply-To: <20200229170401.1287324-1-fparent@baylibre.com>
The pumpkin board is made by Gossamer Engineering and is using
a MediaTek SoC. The board currently comes in two available version:
MT8516 SoC and MT8167 SoC.
The board provides the following IOs: eMMC, NAND, SD card, USB type-A,
Ethernet, Wi-Fi, Bluetooth, Audio (jack out, 2 PDM port, 1 analog in),
serial over USB, and an expansion header.
Additionally there is a HDMI port, DSI port, and camera port only
on the MT8167 version of the board.
The board can be powered by battery and/or via a USB Type-C port and
is using a PMIC MT6392.
The eMMC and NAND are sharing pins and cannot be used together.
This commit is adding the basic boot support for the Pumpkin MT8516
board on the eMMC.
Signed-off-by: Fabien Parent <fparent@baylibre.com>
---
V3:
* Fix warnings from dtbs_check and checkpatch.pl
* Add FW optee nodes
* Add usb0 and usb0_phy nodes
V2:
* Remove dependency on PMIC MT6392 to make it easier to merge the DTS
until the PMIC code is merged.
* Rename a bunch of label to make them more straighforward
* Use names for keycode instead of magic values
* Add chosen for serial port
---
arch/arm64/boot/dts/mediatek/Makefile | 1 +
.../boot/dts/mediatek/mt8516-pumpkin.dts | 20 ++
.../boot/dts/mediatek/pumpkin-common.dtsi | 221 ++++++++++++++++++
3 files changed, 242 insertions(+)
create mode 100644 arch/arm64/boot/dts/mediatek/mt8516-pumpkin.dts
create mode 100644 arch/arm64/boot/dts/mediatek/pumpkin-common.dtsi
diff --git a/arch/arm64/boot/dts/mediatek/Makefile b/arch/arm64/boot/dts/mediatek/Makefile
index 458bbc422a94..2f8967cb8717 100644
--- a/arch/arm64/boot/dts/mediatek/Makefile
+++ b/arch/arm64/boot/dts/mediatek/Makefile
@@ -8,3 +8,4 @@ dtb-$(CONFIG_ARCH_MEDIATEK) += mt7622-rfb1.dtb
dtb-$(CONFIG_ARCH_MEDIATEK) += mt7622-bananapi-bpi-r64.dtb
dtb-$(CONFIG_ARCH_MEDIATEK) += mt8173-evb.dtb
dtb-$(CONFIG_ARCH_MEDIATEK) += mt8183-evb.dtb
+dtb-$(CONFIG_ARCH_MEDIATEK) += mt8516-pumpkin.dtb
diff --git a/arch/arm64/boot/dts/mediatek/mt8516-pumpkin.dts b/arch/arm64/boot/dts/mediatek/mt8516-pumpkin.dts
new file mode 100644
index 000000000000..cce642c53812
--- /dev/null
+++ b/arch/arm64/boot/dts/mediatek/mt8516-pumpkin.dts
@@ -0,0 +1,20 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2019 BayLibre, SAS.
+ * Author: Fabien Parent <fparent@baylibre.com>
+ */
+
+/dts-v1/;
+
+#include "mt8516.dtsi"
+#include "pumpkin-common.dtsi"
+
+/ {
+ model = "Pumpkin MT8516";
+ compatible = "mediatek,mt8516";
+
+ memory@40000000 {
+ device_type = "memory";
+ reg = <0 0x40000000 0 0x40000000>;
+ };
+};
diff --git a/arch/arm64/boot/dts/mediatek/pumpkin-common.dtsi b/arch/arm64/boot/dts/mediatek/pumpkin-common.dtsi
new file mode 100644
index 000000000000..a31093d7142b
--- /dev/null
+++ b/arch/arm64/boot/dts/mediatek/pumpkin-common.dtsi
@@ -0,0 +1,221 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2019 BayLibre, SAS.
+ * Author: Fabien Parent <fparent@baylibre.com>
+ */
+
+#include <dt-bindings/gpio/gpio.h>
+
+/ {
+ aliases {
+ serial0 = &uart0;
+ };
+
+ chosen {
+ stdout-path = "serial0:921600n8";
+ };
+
+ firmware {
+ optee: optee@4fd00000 {
+ compatible = "linaro,optee-tz";
+ method = "smc";
+ };
+ };
+
+ gpio-keys {
+ compatible = "gpio-keys";
+ input-name = "gpio-keys";
+ pinctrl-names = "default";
+ pinctrl-0 = <&gpio_keys_default>;
+
+ volume-up {
+ gpios = <&pio 42 GPIO_ACTIVE_LOW>;
+ label = "volume_up";
+ linux,code = <115>;
+ wakeup-source;
+ debounce-interval = <15>;
+ };
+
+ volume-down {
+ gpios = <&pio 43 GPIO_ACTIVE_LOW>;
+ label = "volume_down";
+ linux,code = <114>;
+ wakeup-source;
+ debounce-interval = <15>;
+ };
+ };
+};
+
+&i2c0 {
+ clock-div = <2>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c0_pins_a>;
+ status = "okay";
+
+ tca6416: gpio@20 {
+ compatible = "ti,tca6416";
+ reg = <0x20>;
+ rst-gpio = <&pio 65 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&tca6416_pins>;
+
+ gpio-controller;
+ #gpio-cells = <2>;
+
+ eint20_mux_sel0 {
+ gpio-hog;
+ gpios = <0 0>;
+ input;
+ line-name = "eint20_mux_sel0";
+ };
+
+ expcon_mux_sel1 {
+ gpio-hog;
+ gpios = <1 0>;
+ input;
+ line-name = "expcon_mux_sel1";
+ };
+
+ mrg_di_mux_sel2 {
+ gpio-hog;
+ gpios = <2 0>;
+ input;
+ line-name = "mrg_di_mux_sel2";
+ };
+
+ sd_sdio_mux_sel3 {
+ gpio-hog;
+ gpios = <3 0>;
+ input;
+ line-name = "sd_sdio_mux_sel3";
+ };
+
+ sd_sdio_mux_ctrl7 {
+ gpio-hog;
+ gpios = <7 0>;
+ output-low;
+ line-name = "sd_sdio_mux_ctrl7";
+ };
+
+ hw_id0 {
+ gpio-hog;
+ gpios = <8 0>;
+ input;
+ line-name = "hw_id0";
+ };
+
+ hw_id1 {
+ gpio-hog;
+ gpios = <9 0>;
+ input;
+ line-name = "hw_id1";
+ };
+
+ hw_id2 {
+ gpio-hog;
+ gpios = <10 0>;
+ input;
+ line-name = "hw_id2";
+ };
+
+ fg_int_n {
+ gpio-hog;
+ gpios = <11 0>;
+ input;
+ line-name = "fg_int_n";
+ };
+
+ usba_pwr_en {
+ gpio-hog;
+ gpios = <12 0>;
+ output-high;
+ line-name = "usba_pwr_en";
+ };
+
+ wifi_3v3_pg {
+ gpio-hog;
+ gpios = <13 0>;
+ input;
+ line-name = "wifi_3v3_pg";
+ };
+
+ cam_rst {
+ gpio-hog;
+ gpios = <14 0>;
+ output-low;
+ line-name = "cam_rst";
+ };
+
+ cam_pwdn {
+ gpio-hog;
+ gpios = <15 0>;
+ output-low;
+ line-name = "cam_pwdn";
+ };
+ };
+};
+
+&i2c2 {
+ clock-div = <2>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c2_pins_a>;
+ status = "okay";
+};
+
+&uart0 {
+ status = "okay";
+};
+
+&usb0 {
+ status = "okay";
+ dr_mode = "peripheral";
+
+ usb_con: connector {
+ compatible = "usb-c-connector";
+ label = "USB-C";
+ };
+};
+
+&usb0_phy {
+ status = "okay";
+};
+
+&pio {
+ gpio_keys_default: gpiodefault {
+ pins_cmd_dat {
+ pinmux = <MT8516_PIN_42_KPCOL0__FUNC_GPIO42>,
+ <MT8516_PIN_43_KPCOL1__FUNC_GPIO43>;
+ bias-pull-up;
+ input-enable;
+ };
+ };
+
+ i2c0_pins_a: i2c0@0 {
+ pins1 {
+ pinmux = <MT8516_PIN_58_SDA0__FUNC_SDA0_0>,
+ <MT8516_PIN_59_SCL0__FUNC_SCL0_0>;
+ bias-disable;
+ };
+ };
+
+ i2c2_pins_a: i2c2@0 {
+ pins1 {
+ pinmux = <MT8516_PIN_60_SDA2__FUNC_SDA2_0>,
+ <MT8516_PIN_61_SCL2__FUNC_SCL2_0>;
+ bias-disable;
+ };
+ };
+
+ tca6416_pins: pinmux_tca6416_pins {
+ gpio_mux_rst_n_pin {
+ pinmux = <MT8516_PIN_65_UTXD1__FUNC_GPIO65>;
+ output-high;
+ };
+
+ gpio_mux_int_n_pin {
+ pinmux = <MT8516_PIN_64_URXD1__FUNC_GPIO64>;
+ input-enable;
+ bias-pull-up;
+ };
+ };
+};
--
2.25.0
next prev parent reply other threads:[~2020-02-29 17:04 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-02-29 17:04 [PATCH v3 1/2] arm64: dts: mediatek: add dtsi for MT8516 Fabien Parent
2020-02-29 17:04 ` Fabien Parent [this message]
2020-02-29 23:35 ` [PATCH v3 2/2] arm64: dts: mediatek: add pumpkin board dts Matthias Brugger
2020-02-29 23:31 ` [PATCH v3 1/2] arm64: dts: mediatek: add dtsi for MT8516 Matthias Brugger
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200229170401.1287324-2-fparent@baylibre.com \
--to=fparent@baylibre.com \
--cc=devicetree@vger.kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=matthias.bgg@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).