From: Robert Marko <robert.marko@sartura.hr>
To: andrew@lunn.ch, f.fainelli@gmail.com, hkallweit1@gmail.com,
linux@armlinux.org.uk, linux-kernel@vger.kernel.org,
netdev@vger.kernel.org, agross@kernel.org,
bjorn.andersson@linaro.org, robh+dt@kernel.org,
mark.rutland@arm.com, linux-arm-msm@vger.kernel.org,
devicetree@vger.kernel.org
Cc: Robert Marko <robert.marko@sartura.hr>,
Christian Lamparter <chunkeey@gmail.com>,
Luka Perkov <luka.perkov@sartura.hr>
Subject: [PATCH v3 1/3] net: phy: mdio: add IPQ40xx MDIO driver
Date: Wed, 15 Apr 2020 17:02:43 +0200 [thread overview]
Message-ID: <20200415150244.2737206-1-robert.marko@sartura.hr> (raw)
This patch adds the driver for the MDIO interface
inside of Qualcomm IPQ40xx series SoC-s.
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
Signed-off-by: Robert Marko <robert.marko@sartura.hr>
Cc: Luka Perkov <luka.perkov@sartura.hr>
---
Changes from v2 to v3:
* Rename registers
* Remove unnecessary variable initialisations
* Switch to readl_poll_timeout() instead of custom solution
* Drop unused header
Changes from v1 to v2:
* Remove magic default value
* Remove lockdep_assert_held
* Add C45 check
* Simplify the driver
* Drop device and mii_bus structs from private struct
* Use devm_mdiobus_alloc_size()
drivers/net/phy/Kconfig | 7 ++
drivers/net/phy/Makefile | 1 +
drivers/net/phy/mdio-ipq40xx.c | 160 +++++++++++++++++++++++++++++++++
3 files changed, 168 insertions(+)
create mode 100644 drivers/net/phy/mdio-ipq40xx.c
diff --git a/drivers/net/phy/Kconfig b/drivers/net/phy/Kconfig
index 3fa33d27eeba..23bb5db033e3 100644
--- a/drivers/net/phy/Kconfig
+++ b/drivers/net/phy/Kconfig
@@ -157,6 +157,13 @@ config MDIO_I2C
This is library mode.
+config MDIO_IPQ40XX
+ tristate "Qualcomm IPQ40xx MDIO interface"
+ depends on HAS_IOMEM && OF_MDIO
+ help
+ This driver supports the MDIO interface found in Qualcomm
+ IPQ40xx series Soc-s.
+
config MDIO_IPQ8064
tristate "Qualcomm IPQ8064 MDIO interface support"
depends on HAS_IOMEM && OF_MDIO
diff --git a/drivers/net/phy/Makefile b/drivers/net/phy/Makefile
index 2f5c7093a65b..36aafc6128c4 100644
--- a/drivers/net/phy/Makefile
+++ b/drivers/net/phy/Makefile
@@ -37,6 +37,7 @@ obj-$(CONFIG_MDIO_CAVIUM) += mdio-cavium.o
obj-$(CONFIG_MDIO_GPIO) += mdio-gpio.o
obj-$(CONFIG_MDIO_HISI_FEMAC) += mdio-hisi-femac.o
obj-$(CONFIG_MDIO_I2C) += mdio-i2c.o
+obj-$(CONFIG_MDIO_IPQ40XX) += mdio-ipq40xx.o
obj-$(CONFIG_MDIO_IPQ8064) += mdio-ipq8064.o
obj-$(CONFIG_MDIO_MOXART) += mdio-moxart.o
obj-$(CONFIG_MDIO_MSCC_MIIM) += mdio-mscc-miim.o
diff --git a/drivers/net/phy/mdio-ipq40xx.c b/drivers/net/phy/mdio-ipq40xx.c
new file mode 100644
index 000000000000..acf1230341bd
--- /dev/null
+++ b/drivers/net/phy/mdio-ipq40xx.c
@@ -0,0 +1,160 @@
+// SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause
+/* Copyright (c) 2015, The Linux Foundation. All rights reserved. */
+/* Copyright (c) 2020 Sartura Ltd. */
+
+#include <linux/delay.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/io.h>
+#include <linux/iopoll.h>
+#include <linux/of_address.h>
+#include <linux/of_mdio.h>
+#include <linux/phy.h>
+#include <linux/platform_device.h>
+
+#define MDIO_ADDR_REG 0x44
+#define MDIO_DATA_WRITE_REG 0x48
+#define MDIO_DATA_READ_REG 0x4c
+#define MDIO_CMD_REG 0x50
+#define MDIO_CMD_ACCESS_BUSY BIT(16)
+#define MDIO_CMD_ACCESS_START BIT(8)
+#define MDIO_CMD_ACCESS_CODE_READ 0
+#define MDIO_CMD_ACCESS_CODE_WRITE 1
+
+#define IPQ40XX_MDIO_TIMEOUT 10000
+#define IPQ40XX_MDIO_SLEEP 10
+
+struct ipq40xx_mdio_data {
+ void __iomem *membase;
+};
+
+static int ipq40xx_mdio_wait_busy(struct mii_bus *bus)
+{
+ struct ipq40xx_mdio_data *priv = bus->priv;
+ unsigned int busy;
+
+ return readl_poll_timeout(priv->membase + MDIO_CMD_REG, busy,
+ (busy & MDIO_CMD_ACCESS_BUSY) == 0,
+ IPQ40XX_MDIO_SLEEP, IPQ40XX_MDIO_TIMEOUT);
+}
+
+static int ipq40xx_mdio_read(struct mii_bus *bus, int mii_id, int regnum)
+{
+ struct ipq40xx_mdio_data *priv = bus->priv;
+ unsigned int cmd;
+
+ /* Reject clause 45 */
+ if (regnum & MII_ADDR_C45)
+ return -EOPNOTSUPP;
+
+ if (ipq40xx_mdio_wait_busy(bus))
+ return -ETIMEDOUT;
+
+ /* issue the phy address and reg */
+ writel((mii_id << 8) | regnum, priv->membase + MDIO_ADDR_REG);
+
+ cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_READ;
+
+ /* issue read command */
+ writel(cmd, priv->membase + MDIO_CMD_REG);
+
+ /* Wait read complete */
+ if (ipq40xx_mdio_wait_busy(bus))
+ return -ETIMEDOUT;
+
+ /* Read and return data */
+ return readl(priv->membase + MDIO_DATA_READ_REG);
+}
+
+static int ipq40xx_mdio_write(struct mii_bus *bus, int mii_id, int regnum,
+ u16 value)
+{
+ struct ipq40xx_mdio_data *priv = bus->priv;
+ unsigned int cmd;
+
+ /* Reject clause 45 */
+ if (regnum & MII_ADDR_C45)
+ return -EOPNOTSUPP;
+
+ if (ipq40xx_mdio_wait_busy(bus))
+ return -ETIMEDOUT;
+
+ /* issue the phy address and reg */
+ writel((mii_id << 8) | regnum, priv->membase + MDIO_ADDR_REG);
+
+ /* issue write data */
+ writel(value, priv->membase + MDIO_DATA_WRITE_REG);
+
+ cmd = MDIO_CMD_ACCESS_START | MDIO_CMD_ACCESS_CODE_WRITE;
+ /* issue write command */
+ writel(cmd, priv->membase + MDIO_CMD_REG);
+
+ /* Wait write complete */
+ if (ipq40xx_mdio_wait_busy(bus))
+ return -ETIMEDOUT;
+
+ return 0;
+}
+
+static int ipq40xx_mdio_probe(struct platform_device *pdev)
+{
+ struct ipq40xx_mdio_data *priv;
+ struct mii_bus *bus;
+ int ret;
+
+ bus = devm_mdiobus_alloc_size(&pdev->dev, sizeof(*priv));
+ if (!bus)
+ return -ENOMEM;
+
+ priv = bus->priv;
+
+ priv->membase = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(priv->membase))
+ return PTR_ERR(priv->membase);
+
+ bus->name = "ipq40xx_mdio";
+ bus->read = ipq40xx_mdio_read;
+ bus->write = ipq40xx_mdio_write;
+ bus->parent = &pdev->dev;
+ snprintf(bus->id, MII_BUS_ID_SIZE, "%s%d", pdev->name, pdev->id);
+
+ ret = of_mdiobus_register(bus, pdev->dev.of_node);
+ if (ret) {
+ dev_err(&pdev->dev, "Cannot register MDIO bus!\n");
+ return ret;
+ }
+
+ platform_set_drvdata(pdev, bus);
+
+ return 0;
+}
+
+static int ipq40xx_mdio_remove(struct platform_device *pdev)
+{
+ struct mii_bus *bus = platform_get_drvdata(pdev);
+
+ mdiobus_unregister(bus);
+
+ return 0;
+}
+
+static const struct of_device_id ipq40xx_mdio_dt_ids[] = {
+ { .compatible = "qcom,ipq40xx-mdio" },
+ { }
+};
+MODULE_DEVICE_TABLE(of, ipq40xx_mdio_dt_ids);
+
+static struct platform_driver ipq40xx_mdio_driver = {
+ .probe = ipq40xx_mdio_probe,
+ .remove = ipq40xx_mdio_remove,
+ .driver = {
+ .name = "ipq40xx-mdio",
+ .of_match_table = ipq40xx_mdio_dt_ids,
+ },
+};
+
+module_platform_driver(ipq40xx_mdio_driver);
+
+MODULE_DESCRIPTION("IPQ40XX MDIO interface driver");
+MODULE_AUTHOR("Qualcomm Atheros");
+MODULE_LICENSE("Dual BSD/GPL");
--
2.26.0
next reply other threads:[~2020-04-15 15:05 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-04-15 15:02 Robert Marko [this message]
2020-04-15 15:02 ` [PATCH v3 2/3] dt-bindings: add Qualcomm IPQ4019 MDIO bindings Robert Marko
2020-04-15 23:49 ` Andrew Lunn
2020-04-15 23:55 ` Florian Fainelli
2020-04-16 8:43 ` Robert Marko
2020-04-28 15:09 ` Rob Herring
2020-04-28 16:40 ` Robert Marko
2020-04-15 15:02 ` [PATCH v3 3/3] ARM: dts: qcom: ipq4019: add MDIO node Robert Marko
2020-04-15 23:51 ` Andrew Lunn
2020-04-15 23:56 ` Florian Fainelli
2020-04-15 23:48 ` [PATCH v3 1/3] net: phy: mdio: add IPQ40xx MDIO driver Andrew Lunn
2020-04-16 8:43 ` Robert Marko
2020-04-15 23:57 ` Florian Fainelli
2020-04-16 7:28 ` Leon Romanovsky
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200415150244.2737206-1-robert.marko@sartura.hr \
--to=robert.marko@sartura.hr \
--cc=agross@kernel.org \
--cc=andrew@lunn.ch \
--cc=bjorn.andersson@linaro.org \
--cc=chunkeey@gmail.com \
--cc=devicetree@vger.kernel.org \
--cc=f.fainelli@gmail.com \
--cc=hkallweit1@gmail.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=luka.perkov@sartura.hr \
--cc=mark.rutland@arm.com \
--cc=netdev@vger.kernel.org \
--cc=robh+dt@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).