[PATCH] clk: imx: lpcg-scu: SW workaround for errata (e10858)

From: peng.fan@nxp.com
To: sboyd@kernel.org, shawnguo@kernel.org, s.hauer@pengutronix.de,
	festevam@gmail.com, abel.vesa@nxp.com
Cc: kernel@pengutronix.de, linux-imx@nxp.com, Anson.Huang@nxp.com,
	linux-clk@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
	linux-kernel@vger.kernel.org, aisheng.dong@nxp.com,
	Peng Fan <peng.fan@nxp.com>
Subject: [PATCH] clk: imx: lpcg-scu: SW workaround for errata (e10858)
Date: Tue,  8 Sep 2020 17:14:47 +0800	[thread overview]
Message-ID: <1599556487-31364-1-git-send-email-peng.fan@nxp.com> (raw)

From: Peng Fan <peng.fan@nxp.com>

Back-to-back LPCG writes can be ignored by the LPCG register due to
a HW bug. The writes need to be separated by at least 4 cycles of
the gated clock.

The workaround is implemented as follows:
1. For clocks running greater than or equal to 24MHz, a read
followed by the write will provide sufficient delay.
2. For clocks running below 24MHz, add a delay of 4 clock cylces
after the write to the LPCG register.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
---
 drivers/clk/imx/clk-lpcg-scu.c | 31 +++++++++++++++++++++++++++++--
 1 file changed, 29 insertions(+), 2 deletions(-)

diff --git a/drivers/clk/imx/clk-lpcg-scu.c b/drivers/clk/imx/clk-lpcg-scu.c
index 1f0e44f921ae..6ee9d2caedf2 100644
--- a/drivers/clk/imx/clk-lpcg-scu.c
+++ b/drivers/clk/imx/clk-lpcg-scu.c
@@ -6,6 +6,7 @@
 
 #include <linux/bits.h>
 #include <linux/clk-provider.h>
+#include <linux/delay.h>
 #include <linux/err.h>
 #include <linux/io.h>
 #include <linux/slab.h>
@@ -38,6 +39,31 @@ struct clk_lpcg_scu {
 
 #define to_clk_lpcg_scu(_hw) container_of(_hw, struct clk_lpcg_scu, hw)
 
+/* e10858 -LPCG clock gating register synchronization errata */
+static void do_lpcg_workaround(u32 rate, void __iomem *reg, u32 val)
+{
+	writel(val, reg);
+
+	if (rate >= 24000000 || rate == 0) {
+		u32 reg1;
+
+		/*
+		 * The time taken to access the LPCG registers from the AP core
+		 * through the interconnect is longer than the minimum delay
+		 * of 4 clock cycles required by the errata.
+		 * Adding a readl will provide sufficient delay to prevent
+		 * back-to-back writes.
+		 */
+		reg1 = readl(reg);
+	} else {
+		/*
+		 * For clocks running below 24MHz, wait a minimum of
+		 * 4 clock cycles.
+		 */
+		ndelay(4 * (DIV_ROUND_UP(1000000000, rate)));
+	}
+}
+
 static int clk_lpcg_scu_enable(struct clk_hw *hw)
 {
 	struct clk_lpcg_scu *clk = to_clk_lpcg_scu(hw);
@@ -54,7 +80,8 @@ static int clk_lpcg_scu_enable(struct clk_hw *hw)
 		val |= CLK_GATE_SCU_LPCG_HW_SEL;
 
 	reg |= val << clk->bit_idx;
-	writel(reg, clk->reg);
+
+	do_lpcg_workaround(clk_hw_get_rate(hw), clk->reg, reg);
 
 	spin_unlock_irqrestore(&imx_lpcg_scu_lock, flags);
 
@@ -71,7 +98,7 @@ static void clk_lpcg_scu_disable(struct clk_hw *hw)
 
 	reg = readl_relaxed(clk->reg);
 	reg &= ~(CLK_GATE_SCU_LPCG_MASK << clk->bit_idx);
-	writel(reg, clk->reg);
+	do_lpcg_workaround(clk_hw_get_rate(hw), clk->reg, reg);
 
 	spin_unlock_irqrestore(&imx_lpcg_scu_lock, flags);
 }
-- 
2.28.0

