[PATCH] bus: mhi: core: Fix check for syserr at power_up

From: Jeffrey Hugo <jhugo@codeaurora.org>
To: manivannan.sadhasivam@linaro.org, hemantk@codeaurora.org
Cc: bbhatt@codeaurora.org, loic.poulain@linaro.org,
	linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org,
	Jeffrey Hugo <jhugo@codeaurora.org>
Subject: [PATCH] bus: mhi: core: Fix check for syserr at power_up
Date: Fri, 12 Feb 2021 14:27:23 -0700	[thread overview]
Message-ID: <1613165243-23359-1-git-send-email-jhugo@codeaurora.org> (raw)

The check to see if we have reset the device after detecting syserr at
power_up is inverted.  wait_for_event_timeout() returns 0 on failure,
and a positive value on success.  The check is looking for non-zero
as a failure, which is likely to incorrectly cause a device init failure
if syserr was detected at power_up.  Fix this.

Fixes: e18d4e9fa79b ("bus: mhi: core: Handle syserr during power_up")
Signed-off-by: Jeffrey Hugo <jhugo@codeaurora.org>
---
 drivers/bus/mhi/core/pm.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/bus/mhi/core/pm.c b/drivers/bus/mhi/core/pm.c
index 681960c..36ab7aa 100644
--- a/drivers/bus/mhi/core/pm.c
+++ b/drivers/bus/mhi/core/pm.c
@@ -1092,7 +1092,7 @@ int mhi_async_power_up(struct mhi_controller *mhi_cntrl)
 							   &val) ||
 					!val,
 				msecs_to_jiffies(mhi_cntrl->timeout_ms));
-		if (ret) {
+		if (!ret) {
 			ret = -EIO;
 			dev_info(dev, "Failed to reset MHI due to syserr state\n");
 			goto error_bhi_offset;
-- 
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.

