From: Lucas Tanure <tanureal@opensource.cirrus.com>
To: James Schulman <james.schulman@cirrus.com>,
David Rhodes <david.rhodes@cirrus.com>,
Mark Brown <broonie@kernel.org>,
Liam Girdwood <lgirdwood@gmail.com>
Cc: Richard Fitzgerald <rf@opensource.cirrus.com>,
<alsa-devel@alsa-project.org>, <patches@opensource.cirrus.com>,
Lucas Tanure <tanureal@opensource.cirrus.com>,
<linux-kernel@vger.kernel.org>
Subject: [PATCH 11/15] ASoC: cs42l42: Use bclk from hw_params if set_sysclk was not called
Date: Tue, 2 Mar 2021 17:04:50 +0000 [thread overview]
Message-ID: <20210302170454.39679-12-tanureal@opensource.cirrus.com> (raw)
In-Reply-To: <20210302170454.39679-1-tanureal@opensource.cirrus.com>
Add support for reading the source clock from snd_soc_params_to_bclk
so the machine driver is not required to call cs42l42_set_sysclk
Signed-off-by: Lucas Tanure <tanureal@opensource.cirrus.com>
---
sound/soc/codecs/cs42l42.c | 17 +++++++++++++----
sound/soc/codecs/cs42l42.h | 1 +
2 files changed, 14 insertions(+), 4 deletions(-)
diff --git a/sound/soc/codecs/cs42l42.c b/sound/soc/codecs/cs42l42.c
index 8345f52ec9d58..7898a2d52a3b7 100644
--- a/sound/soc/codecs/cs42l42.c
+++ b/sound/soc/codecs/cs42l42.c
@@ -556,10 +556,16 @@ static int cs42l42_pll_config(struct snd_soc_component *component)
{
struct cs42l42_private *cs42l42 = snd_soc_component_get_drvdata(component);
int i;
+ u32 clk;
u32 fsync;
+ if (!cs42l42->sclk)
+ clk = cs42l42->bclk;
+ else
+ clk = cs42l42->sclk;
+
for (i = 0; i < ARRAY_SIZE(pll_ratio_table); i++) {
- if (pll_ratio_table[i].sclk == cs42l42->sclk) {
+ if (pll_ratio_table[i].sclk == clk) {
/* Configure the internal sample rate */
snd_soc_component_update_bits(component, CS42L42_MCLK_CTL,
CS42L42_INTERNAL_FS_MASK,
@@ -579,12 +585,12 @@ static int cs42l42_pll_config(struct snd_soc_component *component)
(pll_ratio_table[i].mclk_div <<
CS42L42_MCLKDIV_SHIFT));
/* Set up the LRCLK */
- fsync = cs42l42->sclk / cs42l42->srate;
- if (((fsync * cs42l42->srate) != cs42l42->sclk)
+ fsync = clk / cs42l42->srate;
+ if (((fsync * cs42l42->srate) != clk)
|| ((fsync % 2) != 0)) {
dev_err(component->dev,
"Unsupported sclk %d/sample rate %d\n",
- cs42l42->sclk,
+ clk,
cs42l42->srate);
return -EINVAL;
}
@@ -756,6 +762,7 @@ static int cs42l42_pcm_hw_params(struct snd_pcm_substream *substream,
unsigned int val = 0;
cs42l42->srate = params_rate(params);
+ cs42l42->bclk = snd_soc_params_to_bclk(params);
switch(substream->stream) {
case SNDRV_PCM_STREAM_CAPTURE:
@@ -888,6 +895,8 @@ static struct snd_soc_dai_driver cs42l42_dai = {
.rates = SNDRV_PCM_RATE_8000_192000,
.formats = CS42L42_FORMATS,
},
+ .symmetric_rate = 1,
+ .symmetric_sample_bits = 1,
.ops = &cs42l42_ops,
};
diff --git a/sound/soc/codecs/cs42l42.h b/sound/soc/codecs/cs42l42.h
index 267c2b616e57d..1df9577e367c1 100644
--- a/sound/soc/codecs/cs42l42.h
+++ b/sound/soc/codecs/cs42l42.h
@@ -772,6 +772,7 @@ struct cs42l42_private {
struct completion pdn_done;
struct snd_soc_jack jack;
int irq;
+ int bclk;
u32 sclk;
u32 srate;
u8 plug_state;
--
2.30.1
next prev parent reply other threads:[~2021-03-02 20:44 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-03-02 17:04 [PATCH 00/15] Report jack and button detection + Capture Support Lucas Tanure
2021-03-02 17:04 ` [PATCH 01/15] ASoC: cs42l42: Don't enable/disable regulator at Bias Level Lucas Tanure
2021-03-02 17:04 ` [PATCH 02/15] ASoC: cs42l42: Always wait at least 3ms after reset Lucas Tanure
2021-03-02 17:04 ` [PATCH 03/15] ASoC: cs42l42: Remove power if the driver is being removed Lucas Tanure
2021-03-02 17:12 ` Mark Brown
2021-03-02 17:04 ` [PATCH 04/15] ASoC: cs42l42: Disable regulators if probe fails Lucas Tanure
2021-03-02 17:04 ` [PATCH 05/15] ASoC: cs42l42: Fix Bitclock polarity inversion Lucas Tanure
2021-03-02 17:15 ` Mark Brown
2021-03-02 17:04 ` [PATCH 06/15] ASoC: cs42l42: Provide finer control on playback path Lucas Tanure
2021-03-02 17:04 ` [PATCH 07/15] ASoC: cs42l42: Set clock source for both ways of stream Lucas Tanure
2021-03-03 0:02 ` kernel test robot
2021-03-02 17:04 ` [PATCH 08/15] ASoC: cs42l42: Fix channel width support Lucas Tanure
2021-03-02 17:20 ` Mark Brown
2021-03-02 17:04 ` [PATCH 09/15] ASoC: cs42l42: Add Capture Support Lucas Tanure
2021-03-02 17:04 ` [PATCH 10/15] ASoC: cs42l42: Report jack and button detection Lucas Tanure
2021-03-02 17:29 ` Mark Brown
2021-03-02 17:04 ` Lucas Tanure [this message]
2021-03-02 17:04 ` [PATCH 12/15] ASoC: cs42l42: Wait at least 150us after writing SCLK_PRESENT Lucas Tanure
2021-03-02 17:30 ` Mark Brown
2021-03-02 22:56 ` kernel test robot
2021-03-02 22:56 ` [PATCH] ASoC: cs42l42: fix semicolon.cocci warnings kernel test robot
2021-03-02 17:04 ` [PATCH 13/15] ASoC: cs42l42: Only start PLL if it is needed Lucas Tanure
2021-03-02 17:04 ` [PATCH 14/15] ASoC: cs42l42: Wait for PLL to lock before switching to it Lucas Tanure
2021-03-02 17:04 ` [PATCH 15/15] ASoC: cs42l42: Fix mixer volume control Lucas Tanure
2021-03-02 17:30 ` Mark Brown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210302170454.39679-12-tanureal@opensource.cirrus.com \
--to=tanureal@opensource.cirrus.com \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@kernel.org \
--cc=david.rhodes@cirrus.com \
--cc=james.schulman@cirrus.com \
--cc=lgirdwood@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=patches@opensource.cirrus.com \
--cc=rf@opensource.cirrus.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).