From: Michael Walle <michael@walle.cc>
To: linux-mtd@lists.infradead.org, linux-kernel@vger.kernel.org
Cc: Tudor Ambarus <tudor.ambarus@microchip.com>,
Michael Walle <michael@walle.cc>, Pratyush Yadav <p.yadav@ti.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
Vignesh Raghavendra <vigneshr@ti.com>
Subject: [PATCH] mtd: spi-nor: implement OTP erase for Winbond and similar flashes
Date: Wed, 7 Apr 2021 19:18:58 +0200 [thread overview]
Message-ID: <20210407171858.8132-1-michael@walle.cc> (raw)
Winbond flashes with OTP support provide a command to erase the OTP
data. This might come in handy during development.
This was tested with a Winbond W25Q32JW on a LS1028A SoC with the
NXP FSPI controller.
Signed-off-by: Michael Walle <michael@walle.cc>
---
drivers/mtd/spi-nor/core.c | 4 +-
drivers/mtd/spi-nor/core.h | 4 ++
drivers/mtd/spi-nor/otp.c | 75 ++++++++++++++++++++++++++++++++++-
drivers/mtd/spi-nor/winbond.c | 1 +
4 files changed, 80 insertions(+), 4 deletions(-)
diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index 8cf3cf92129e..3f726a87e5a9 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -166,8 +166,8 @@ static int spi_nor_controller_ops_read_reg(struct spi_nor *nor, u8 opcode,
return nor->controller_ops->read_reg(nor, opcode, buf, len);
}
-static int spi_nor_controller_ops_write_reg(struct spi_nor *nor, u8 opcode,
- const u8 *buf, size_t len)
+int spi_nor_controller_ops_write_reg(struct spi_nor *nor, u8 opcode,
+ const u8 *buf, size_t len)
{
if (spi_nor_protocol_is_dtr(nor->reg_proto))
return -EOPNOTSUPP;
diff --git a/drivers/mtd/spi-nor/core.h b/drivers/mtd/spi-nor/core.h
index e9b6b2e76cdb..648e67bea0b2 100644
--- a/drivers/mtd/spi-nor/core.h
+++ b/drivers/mtd/spi-nor/core.h
@@ -213,6 +213,7 @@ struct spi_nor_otp_ops {
int (*read)(struct spi_nor *nor, loff_t addr, size_t len, u8 *buf);
int (*write)(struct spi_nor *nor, loff_t addr, size_t len, u8 *buf);
int (*lock)(struct spi_nor *nor, unsigned int region);
+ int (*erase)(struct spi_nor *nor, loff_t addr);
int (*is_locked)(struct spi_nor *nor, unsigned int region);
};
@@ -480,6 +481,8 @@ extern const struct spi_nor_manufacturer spi_nor_xmc;
void spi_nor_spimem_setup_op(const struct spi_nor *nor,
struct spi_mem_op *op,
const enum spi_nor_protocol proto);
+int spi_nor_controller_ops_write_reg(struct spi_nor *nor, u8 opcode,
+ const u8 *buf, size_t len);
int spi_nor_write_enable(struct spi_nor *nor);
int spi_nor_write_disable(struct spi_nor *nor);
int spi_nor_set_4byte_addr_mode(struct spi_nor *nor, bool enable);
@@ -505,6 +508,7 @@ ssize_t spi_nor_write_data(struct spi_nor *nor, loff_t to, size_t len,
int spi_nor_otp_read_secr(struct spi_nor *nor, loff_t addr, size_t len, u8 *buf);
int spi_nor_otp_write_secr(struct spi_nor *nor, loff_t addr, size_t len, u8 *buf);
+int spi_nor_otp_erase_secr(struct spi_nor *nor, loff_t addr);
int spi_nor_otp_lock_sr2(struct spi_nor *nor, unsigned int region);
int spi_nor_otp_is_locked_sr2(struct spi_nor *nor, unsigned int region);
diff --git a/drivers/mtd/spi-nor/otp.c b/drivers/mtd/spi-nor/otp.c
index 5021d40dffbf..ea7db4b354f7 100644
--- a/drivers/mtd/spi-nor/otp.c
+++ b/drivers/mtd/spi-nor/otp.c
@@ -8,6 +8,7 @@
#include <linux/log2.h>
#include <linux/mtd/mtd.h>
#include <linux/mtd/spi-nor.h>
+#include <linux/spi/spi-mem.h>
#include "core.h"
@@ -110,6 +111,50 @@ int spi_nor_otp_write_secr(struct spi_nor *nor, loff_t addr, size_t len, u8 *buf
return ret ?: written;
}
+/**
+ * spi_nor_otp_erase_secr() - erase one OTP region
+ * @nor: pointer to 'struct spi_nor'
+ * @to: offset to write to
+ * @len: number of bytes to write
+ * @buf: pointer to src buffer
+ *
+ * Erase one OTP region by using the SPINOR_OP_ESECR commands. This method is
+ * used on GigaDevice and Winbond flashes.
+ *
+ * Return: 0 on success, -errno otherwise
+ */
+int spi_nor_otp_erase_secr(struct spi_nor *nor, loff_t addr)
+{
+ int ret;
+
+ ret = spi_nor_write_enable(nor);
+ if (ret)
+ return ret;
+
+ if (nor->spimem) {
+ struct spi_mem_op op =
+ SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_ESECR, 0),
+ SPI_MEM_OP_ADDR(3, addr, 0),
+ SPI_MEM_OP_NO_DUMMY,
+ SPI_MEM_OP_NO_DATA);
+
+ spi_nor_spimem_setup_op(nor, &op, nor->write_proto);
+
+ ret = spi_mem_exec_op(nor->spimem, &op);
+ } else {
+ nor->bouncebuf[2] = addr & 0xff;
+ nor->bouncebuf[1] = (addr >> 8) & 0xff;
+ nor->bouncebuf[0] = (addr >> 16) & 0xff;
+
+ ret = spi_nor_controller_ops_write_reg(nor, SPINOR_OP_ESECR,
+ nor->bouncebuf, 3);
+ }
+ if (ret)
+ return ret;
+
+ return spi_nor_wait_till_ready(nor);
+}
+
static int spi_nor_otp_lock_bit_cr(unsigned int region)
{
static const int lock_bits[] = { SR2_LB1, SR2_LB2, SR2_LB3 };
@@ -315,12 +360,14 @@ static int spi_nor_mtd_otp_write(struct mtd_info *mtd, loff_t to, size_t len,
return spi_nor_mtd_otp_read_write(mtd, to, len, retlen, buf, true);
}
-static int spi_nor_mtd_otp_lock(struct mtd_info *mtd, loff_t from, size_t len)
+static int spi_nor_mtd_otp_lock_erase(struct mtd_info *mtd, loff_t from,
+ size_t len, bool is_erase)
{
struct spi_nor *nor = mtd_to_spi_nor(mtd);
const struct spi_nor_otp_ops *ops = nor->params->otp.ops;
const size_t rlen = spi_nor_otp_region_len(nor);
unsigned int region;
+ loff_t rstart;
int ret;
if (from < 0 || (from + len) > spi_nor_otp_size(nor))
@@ -336,7 +383,13 @@ static int spi_nor_mtd_otp_lock(struct mtd_info *mtd, loff_t from, size_t len)
while (len) {
region = spi_nor_otp_offset_to_region(nor, from);
- ret = ops->lock(nor, region);
+
+ if (is_erase) {
+ rstart = spi_nor_otp_region_start(nor, region);
+ ret = ops->erase(nor, rstart);
+ } else {
+ ret = ops->lock(nor, region);
+ }
if (ret)
goto out;
@@ -350,6 +403,23 @@ static int spi_nor_mtd_otp_lock(struct mtd_info *mtd, loff_t from, size_t len)
return ret;
}
+static int spi_nor_mtd_otp_lock(struct mtd_info *mtd, loff_t from, size_t len)
+{
+ return spi_nor_mtd_otp_lock_erase(mtd, from, len, false);
+}
+
+static int spi_nor_mtd_otp_erase(struct mtd_info *mtd, loff_t from, size_t len)
+{
+ struct spi_nor *nor = mtd_to_spi_nor(mtd);
+ const struct spi_nor_otp_ops *ops = nor->params->otp.ops;
+
+ /* OTP erase is optional */
+ if (!ops->erase)
+ return -EOPNOTSUPP;
+
+ return spi_nor_mtd_otp_lock_erase(mtd, from, len, true);
+}
+
void spi_nor_otp_init(struct spi_nor *nor)
{
struct mtd_info *mtd = &nor->mtd;
@@ -373,4 +443,5 @@ void spi_nor_otp_init(struct spi_nor *nor)
mtd->_read_user_prot_reg = spi_nor_mtd_otp_read;
mtd->_write_user_prot_reg = spi_nor_mtd_otp_write;
mtd->_lock_user_prot_reg = spi_nor_mtd_otp_lock;
+ mtd->_erase_user_prot_reg = spi_nor_mtd_otp_erase;
}
diff --git a/drivers/mtd/spi-nor/winbond.c b/drivers/mtd/spi-nor/winbond.c
index 9a81c67a60c6..96573f61caf5 100644
--- a/drivers/mtd/spi-nor/winbond.c
+++ b/drivers/mtd/spi-nor/winbond.c
@@ -139,6 +139,7 @@ static int winbond_set_4byte_addr_mode(struct spi_nor *nor, bool enable)
static const struct spi_nor_otp_ops winbond_otp_ops = {
.read = spi_nor_otp_read_secr,
.write = spi_nor_otp_write_secr,
+ .erase = spi_nor_otp_erase_secr,
.lock = spi_nor_otp_lock_sr2,
.is_locked = spi_nor_otp_is_locked_sr2,
};
--
2.20.1
reply other threads:[~2021-04-07 17:19 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210407171858.8132-1-michael@walle.cc \
--to=michael@walle.cc \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=p.yadav@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).