[RFC PATCH net-next v4 14/28] net: dsa: qca8k: add priority tweak to qca8337 switch

From: Ansuel Smith <ansuelsmth@gmail.com>
To: Florian Fainelli <f.fainelli@gmail.com>
Cc: Ansuel Smith <ansuelsmth@gmail.com>, Andrew Lunn <andrew@lunn.ch>,
	Vivien Didelot <vivien.didelot@gmail.com>,
	Vladimir Oltean <olteanv@gmail.com>,
	"David S. Miller" <davem@davemloft.net>,
	Jakub Kicinski <kuba@kernel.org>,
	Russell King <linux@armlinux.org.uk>,
	netdev@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: [RFC PATCH net-next v4 14/28] net: dsa: qca8k: add priority tweak to qca8337 switch
Date: Sat,  8 May 2021 02:29:04 +0200	[thread overview]
Message-ID: <20210508002920.19945-14-ansuelsmth@gmail.com> (raw)
In-Reply-To: <20210508002920.19945-1-ansuelsmth@gmail.com>

The port 5 of the qca8337 have some problem in flood condition. The
original legacy driver had some specific buffer and priority settings
for the different port suggested by the QCA switch team. Add this
missing settings to improve switch stability under load condition.
The packet priority tweak is only needed for the qca8337 switch and
other qca8k switch are not affected.

Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
---
 drivers/net/dsa/qca8k.c | 47 +++++++++++++++++++++++++++++++++++++++++
 drivers/net/dsa/qca8k.h | 25 ++++++++++++++++++++++
 2 files changed, 72 insertions(+)

diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index 9c2f09e84364..69fd526344cc 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c
@@ -791,6 +791,7 @@ qca8k_setup(struct dsa_switch *ds)
 {
 	struct qca8k_priv *priv = (struct qca8k_priv *)ds->priv;
 	int ret, i;
+	u32 mask;
 
 	/* Make sure that port 0 is the cpu port */
 	if (!dsa_is_cpu_port(ds, 0)) {
@@ -896,6 +897,51 @@ qca8k_setup(struct dsa_switch *ds)
 		}
 	}
 
+	/* The port 5 of the qca8337 have some problem in flood condition. The
+	 * original legacy driver had some specific buffer and priority settings
+	 * for the different port suggested by the QCA switch team. Add this
+	 * missing settings to improve switch stability under load condition.
+	 * This problem is limited to qca8337 and other qca8k switch are not affected.
+	 */
+	if (priv->switch_id == QCA8K_ID_QCA8337) {
+		for (i = 0; i < QCA8K_NUM_PORTS; i++) {
+			switch (i) {
+			/* The 2 CPU port and port 5 requires some different
+			 * priority than any other ports.
+			 */
+			case 0:
+			case 5:
+			case 6:
+				mask = QCA8K_PORT_HOL_CTRL0_EG_PRI0(0x3) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI1(0x4) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI2(0x4) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI3(0x4) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI4(0x6) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI5(0x8) |
+					QCA8K_PORT_HOL_CTRL0_EG_PORT(0x1e);
+				break;
+			default:
+				mask = QCA8K_PORT_HOL_CTRL0_EG_PRI0(0x3) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI1(0x4) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI2(0x6) |
+					QCA8K_PORT_HOL_CTRL0_EG_PRI3(0x8) |
+					QCA8K_PORT_HOL_CTRL0_EG_PORT(0x19);
+			}
+			qca8k_write(priv, QCA8K_REG_PORT_HOL_CTRL0(i), mask);
+
+			mask = QCA8K_PORT_HOL_CTRL1_ING(0x6) |
+			QCA8K_PORT_HOL_CTRL1_EG_PRI_BUF_EN |
+			QCA8K_PORT_HOL_CTRL1_EG_PORT_BUF_EN |
+			QCA8K_PORT_HOL_CTRL1_WRED_EN;
+			qca8k_rmw(priv, QCA8K_REG_PORT_HOL_CTRL1(i),
+				  QCA8K_PORT_HOL_CTRL1_ING_BUF |
+				  QCA8K_PORT_HOL_CTRL1_EG_PRI_BUF_EN |
+				  QCA8K_PORT_HOL_CTRL1_EG_PORT_BUF_EN |
+				  QCA8K_PORT_HOL_CTRL1_WRED_EN,
+				  mask);
+		}
+	}
+
 	/* Setup our port MTUs to match power on defaults */
 	for (i = 0; i < QCA8K_NUM_PORTS; i++)
 		priv->port_mtu[i] = ETH_FRAME_LEN + ETH_FCS_LEN;
@@ -1581,6 +1627,7 @@ qca8k_sw_probe(struct mdio_device *mdiodev)
 		return -ENODEV;
 	}
 
+	priv->switch_id = id;
 	priv->ds = devm_kzalloc(&mdiodev->dev, sizeof(*priv->ds), GFP_KERNEL);
 	if (!priv->ds)
 		return -ENOMEM;
diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h
index 87a8b10459c6..42d90836dffa 100644
--- a/drivers/net/dsa/qca8k.h
+++ b/drivers/net/dsa/qca8k.h
@@ -168,6 +168,30 @@
 #define   QCA8K_PORT_LOOKUP_STATE			GENMASK(18, 16)
 #define   QCA8K_PORT_LOOKUP_LEARN			BIT(20)
 
+#define QCA8K_REG_PORT_HOL_CTRL0(_i)			(0x970 + (_i) * 0x8)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI0_BUF		GENMASK(3, 0)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI0(x)		((x) << 0)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI1_BUF		GENMASK(7, 4)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI1(x)		((x) << 4)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI2_BUF		GENMASK(11, 8)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI2(x)		((x) << 8)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI3_BUF		GENMASK(15, 12)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI3(x)		((x) << 12)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI4_BUF		GENMASK(19, 16)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI4(x)		((x) << 16)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI5_BUF		GENMASK(23, 20)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PRI5(x)		((x) << 20)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PORT_BUF		GENMASK(29, 24)
+#define   QCA8K_PORT_HOL_CTRL0_EG_PORT(x)		((x) << 24)
+
+#define QCA8K_REG_PORT_HOL_CTRL1(_i)			(0x974 + (_i) * 0x8)
+#define   QCA8K_PORT_HOL_CTRL1_ING_BUF			GENMASK(3, 0)
+#define   QCA8K_PORT_HOL_CTRL1_ING(x)			((x) << 0)
+#define   QCA8K_PORT_HOL_CTRL1_EG_PRI_BUF_EN		BIT(6)
+#define   QCA8K_PORT_HOL_CTRL1_EG_PORT_BUF_EN		BIT(7)
+#define   QCA8K_PORT_HOL_CTRL1_WRED_EN			BIT(8)
+#define   QCA8K_PORT_HOL_CTRL1_EG_MIRROR_EN		BIT(16)
+
 /* Pkt edit registers */
 #define QCA8K_EGRESS_VLAN(x)				(0x0c70 + (4 * (x / 2)))
 
@@ -220,6 +244,7 @@ struct qca8k_match_data {
 };
 
 struct qca8k_priv {
+	u8 switch_id;
 	struct regmap *regmap;
 	struct mii_bus *bus;
 	struct ar8xxx_port_status port_sts[QCA8K_NUM_PORTS];
-- 
2.30.2

