[PATCH net-next v3 09/10] arm64: dts: marvell: 8040-db: describe the 10G interfaces as fixed-link

From: Antoine Tenart <antoine.tenart@bootlin.com>
To: davem@davemloft.net, kishon@ti.com, linux@armlinux.org.uk,
	gregory.clement@bootlin.com, andrew@lunn.ch,
	jason@lakedaemon.net, sebastian.hesselbarth@gmail.com
Cc: Antoine Tenart <antoine.tenart@bootlin.com>,
	netdev@vger.kernel.org, linux-kernel@vger.kernel.org,
	thomas.petazzoni@bootlin.com, maxime.chevallier@bootlin.com,
	miquel.raynal@bootlin.com, nadavh@marvell.com,
	stefanc@marvell.com, ymarkman@marvell.com, mw@semihalf.com,
	linux-arm-kernel@lists.infradead.org
Subject: [PATCH net-next v3 09/10] arm64: dts: marvell: 8040-db: describe the 10G interfaces as fixed-link
Date: Thu, 17 May 2018 10:29:38 +0200	[thread overview]
Message-ID: <20180517082939.14598-10-antoine.tenart@bootlin.com> (raw)
In-Reply-To: <20180517082939.14598-1-antoine.tenart@bootlin.com>

This patch adds a fixed-link node to both 10G interfaces of the 8040-db
board. This is required as the mvpp2 driver now uses phylink. The best
solution would have been to describe the SFP cages but they are not
wired correctly, and thus unusable, so we chose to use fixed-link
instead.

Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
---
 arch/arm64/boot/dts/marvell/armada-8040-db.dts | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-8040-db.dts b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
index 5689fb23bbab..1bac437369a1 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-db.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-db.dts
@@ -177,6 +177,11 @@
 &cp0_eth0 {
 	status = "okay";
 	phy-mode = "10gbase-kr";
+
+	fixed-link {
+		speed = <10000>;
+		full-duplex;
+	};
 };
 
 &cp0_eth2 {
@@ -303,6 +308,11 @@
 &cp1_eth0 {
 	status = "okay";
 	phy-mode = "10gbase-kr";
+
+	fixed-link {
+		speed = <10000>;
+		full-duplex;
+	};
 };
 
 &cp1_eth1 {
-- 
2.17.0
