[PATCH] net: mvpp2: typo and cosmetic fixes

From: Antoine Tenart <antoine.tenart@bootlin.com>
To: davem@davemloft.net
Cc: Antoine Tenart <antoine.tenart@bootlin.com>,
	netdev@vger.kernel.org, linux-kernel@vger.kernel.org,
	thomas.petazzoni@bootlin.com, maxime.chevallier@bootlin.com,
	gregory.clement@bootlin.com, miquel.raynal@bootlin.com,
	nadavh@marvell.com, stefanc@marvell.com, ymarkman@marvell.com,
	mw@semihalf.com
Subject: [PATCH] net: mvpp2: typo and cosmetic fixes
Date: Fri, 18 May 2018 14:34:51 +0200	[thread overview]
Message-ID: <20180518123451.31365-1-antoine.tenart@bootlin.com> (raw)

This patch on the Marvell PPv2 driver is only cosmetic. Two typos are
removed as well as other cosmetic fixes, such as extra new lines or tabs
vs spaces.

Suggested-by: Stefan Chulski <stefanc@marvell.com>
Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
---
 drivers/net/ethernet/marvell/mvpp2.c | 12 ++++--------
 1 file changed, 4 insertions(+), 8 deletions(-)

diff --git a/drivers/net/ethernet/marvell/mvpp2.c b/drivers/net/ethernet/marvell/mvpp2.c
index f8ed983bc767..7f54bb0334f1 100644
--- a/drivers/net/ethernet/marvell/mvpp2.c
+++ b/drivers/net/ethernet/marvell/mvpp2.c
@@ -1757,7 +1757,6 @@ static void mvpp2_prs_tcam_ai_update(struct mvpp2_prs_entry *pe,
 	int i, ai_idx = MVPP2_PRS_TCAM_AI_BYTE;
 
 	for (i = 0; i < MVPP2_PRS_AI_BITS; i++) {
-
 		if (!(enable & BIT(i)))
 			continue;
 
@@ -1841,7 +1840,6 @@ static void mvpp2_prs_sram_ai_update(struct mvpp2_prs_entry *pe,
 	int ai_off = MVPP2_PRS_SRAM_AI_OFFS;
 
 	for (i = 0; i < MVPP2_PRS_SRAM_AI_CTRL_BITS; i++) {
-
 		if (!(mask & BIT(i)))
 			continue;
 
@@ -4937,7 +4935,7 @@ static void mvpp22_gop_mask_irq(struct mvpp2_port *port)
 	if (port->gop_id == 0) {
 		val = readl(port->base + MVPP22_XLG_EXT_INT_MASK);
 		val &= ~(MVPP22_XLG_EXT_INT_MASK_XLG |
-		         MVPP22_XLG_EXT_INT_MASK_GIG);
+			 MVPP22_XLG_EXT_INT_MASK_GIG);
 		writel(val, port->base + MVPP22_XLG_EXT_INT_MASK);
 	}
 
@@ -5471,7 +5469,6 @@ static void mvpp2_aggr_txq_pend_desc_add(struct mvpp2_port *port, int pending)
 			   MVPP2_AGGR_TXQ_UPDATE_REG, pending);
 }
 
-
 /* Check if there are enough free descriptors in aggregated txq.
  * If not, update the number of occupied descriptors and repeat the check.
  *
@@ -5551,7 +5548,7 @@ static int mvpp2_txq_reserved_desc_num_proc(struct mvpp2 *priv,
 
 	txq_pcpu->reserved_num += mvpp2_txq_alloc_reserved_desc(priv, txq, req);
 
-	/* OK, the descriptor cound has been updated: check again. */
+	/* OK, the descriptor could have been updated: check again. */
 	if (txq_pcpu->reserved_num < num)
 		return -ENOMEM;
 	return 0;
@@ -6033,7 +6030,7 @@ static int mvpp2_txq_init(struct mvpp2_port *port,
 	/* Calculate base address in prefetch buffer. We reserve 16 descriptors
 	 * for each existing TXQ.
 	 * TCONTS for PON port must be continuous from 0 to MVPP2_MAX_TCONT
-	 * GBE ports assumed to be continious from 0 to MVPP2_MAX_PORTS
+	 * GBE ports assumed to be continuous from 0 to MVPP2_MAX_PORTS
 	 */
 	desc_per_txq = 16;
 	desc = (port->id * MVPP2_MAX_TXQ * desc_per_txq) +
@@ -6603,8 +6600,7 @@ static int mvpp2_tx_frag_process(struct mvpp2_port *port, struct sk_buff *skb,
 		mvpp2_txdesc_size_set(port, tx_desc, frag->size);
 
 		buf_dma_addr = dma_map_single(port->dev->dev.parent, addr,
-					       frag->size,
-					       DMA_TO_DEVICE);
+					      frag->size, DMA_TO_DEVICE);
 		if (dma_mapping_error(port->dev->dev.parent, buf_dma_addr)) {
 			mvpp2_txq_desc_put(txq);
 			goto cleanup;
-- 
2.17.0
