linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Fenghua Yu <fenghua.yu@intel.com>
To: "Thomas Gleixner" <tglx@linutronix.de>,
	"Ingo Molnar" <mingo@elte.hu>,
	"H. Peter Anvin" <hpa@linux.intel.com>
Cc: "Ashok Raj" <ashok.raj@intel.com>,
	"Dave Hansen" <dave.hansen@intel.com>,
	"Rafael Wysocki" <rafael.j.wysocki@intel.com>,
	"Tony Luck" <tony.luck@intel.com>,
	"Alan Cox" <alan@linux.intel.com>,
	"Ravi V Shankar" <ravi.v.shankar@intel.com>,
	"Arjan van de Ven" <arjan@infradead.org>,
	"linux-kernel" <linux-kernel@vger.kernel.org>,
	"x86" <x86@kernel.org>, Fenghua Yu <fenghua.yu@intel.com>
Subject: [RFC PATCH 08/16] x86/split_lock: Set split lock during EFI runtime service
Date: Sun, 27 May 2018 08:45:57 -0700	[thread overview]
Message-ID: <1527435965-202085-9-git-send-email-fenghua.yu@intel.com> (raw)
In-Reply-To: <1527435965-202085-1-git-send-email-fenghua.yu@intel.com>

If kernel enables #AC for split locked accesses, EFI runtime service may
hit #AC exception, treat it as fatal fault, and cause system hang.

To avoid debugging potential buggy EFI runtime service code in firmware,
restore to firmware split lock setting before entering EFI runtime service
and restore to kernel split lock setting after exiting EFI runtime service.

Signed-off-by: Fenghua Yu <fenghua.yu@intel.com>
---
 arch/x86/include/asm/efi.h | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/x86/include/asm/efi.h b/arch/x86/include/asm/efi.h
index cec5fae23eb3..a5604e5a56c1 100644
--- a/arch/x86/include/asm/efi.h
+++ b/arch/x86/include/asm/efi.h
@@ -8,6 +8,7 @@
 #include <asm/tlb.h>
 #include <asm/nospec-branch.h>
 #include <asm/mmu_context.h>
+#include <asm/cpu.h>
 
 /*
  * We map the EFI regions needed for runtime services non-contiguously,
@@ -41,12 +42,14 @@ extern asmlinkage unsigned long efi_call_phys(void *, ...);
 #define arch_efi_call_virt_setup()					\
 ({									\
 	kernel_fpu_begin();						\
+	restore_split_lock_ac_firmware();				\
 	firmware_restrict_branch_speculation_start();			\
 })
 
 #define arch_efi_call_virt_teardown()					\
 ({									\
 	firmware_restrict_branch_speculation_end();			\
+	restore_split_lock_ac_kernel();				\
 	kernel_fpu_end();						\
 })
 
@@ -84,6 +87,7 @@ struct efi_scratch {
 	efi_sync_low_kernel_mappings();					\
 	preempt_disable();						\
 	__kernel_fpu_begin();						\
+	restore_split_lock_ac_firmware();				\
 	firmware_restrict_branch_speculation_start();			\
 									\
 	if (!efi_enabled(EFI_OLD_MEMMAP))				\
@@ -99,6 +103,7 @@ struct efi_scratch {
 		efi_switch_mm(efi_scratch.prev_mm);			\
 									\
 	firmware_restrict_branch_speculation_end();			\
+	restore_split_lock_ac_kernel();				\
 	__kernel_fpu_end();						\
 	preempt_enable();						\
 })
-- 
2.5.0

  parent reply	other threads:[~2018-05-27 15:49 UTC|newest]

Thread overview: 73+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-05-27 15:45 [RFC PATCH 00/16] x86/split_lock: Enable #AC exception for split locked accesses Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 01/16] x86/split_lock: Add CONFIG and enumerate #AC exception for split locked access feature Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 02/16] x86/split_lock: Handle #AC exception for split lock in kernel mode Fenghua Yu
2018-06-21 19:46   ` Peter Zijlstra
2018-06-22 10:49   ` Thomas Gleixner
2018-06-22 11:59     ` Thomas Gleixner
2018-06-22 22:41       ` Fenghua Yu
2018-06-22 22:57         ` Thomas Gleixner
2018-06-22 23:03           ` Thomas Gleixner
2018-06-22 23:18       ` Fenghua Yu
2018-06-23  9:08         ` Thomas Gleixner
2018-06-23  4:20     ` Fenghua Yu
2018-06-23  9:17       ` Thomas Gleixner
2018-06-23 15:05         ` Fenghua Yu
2018-06-24  0:55           ` Thomas Gleixner
2018-06-24  1:17             ` Fenghua Yu
2018-06-24  6:43               ` Thomas Gleixner
2018-05-27 15:45 ` [RFC PATCH 03/16] x86/split_lock: Set up #AC exception for split locked accesses on all CPUs Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 04/16] x86/split_lock: Use non locked bit set instruction in set_cpu_cap Fenghua Yu
2018-06-21 19:55   ` Peter Zijlstra
2018-06-21 20:37     ` Thomas Gleixner
2018-06-27 23:35     ` Fenghua Yu
2018-06-28  7:53       ` Thomas Gleixner
2018-06-28 14:23         ` Fenghua Yu
2018-06-28 14:54           ` Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 05/16] x86/split_lock: Use non atomic set and clear bit instructions in clear_cpufeature() Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 06/16] x86/split_lock: Save #AC setting for split lock in firmware in boot time and restore the setting in reboot Fenghua Yu
2018-06-21 19:58   ` Peter Zijlstra
2018-06-22 15:11     ` Alan Cox
2018-06-26  9:05       ` Peter Zijlstra
2018-06-26  9:40         ` Thomas Gleixner
2018-06-26 11:02         ` Alan Cox
2018-06-26 11:31           ` Peter Zijlstra
2018-05-27 15:45 ` [RFC PATCH 07/16] x86/split_lock: Handle suspend/hibernate and resume Fenghua Yu
2018-05-27 15:45 ` Fenghua Yu [this message]
2018-05-27 15:45 ` [RFC PATCH 09/16] x86/split_lock: Add CONFIG to control #AC for split lock at boot time Fenghua Yu
2018-05-27 15:45 ` [RFC PATCH 10/16] x86/split_lock: Add a debugfs interface to allow user to enable or disable #AC for split lock during run time Fenghua Yu
2018-05-29 18:43   ` Greg KH
2018-05-27 15:46 ` [RFC PATCH 11/16] x86/split_lock: Add CONFIG to control #AC for split lock from kernel at boot time Fenghua Yu
2018-05-27 15:46 ` [RFC PATCH 12/16] x86/split_lock: Add a debugfs interface to allow user to change how to handle split lock in kernel mode during run time Fenghua Yu
2018-05-27 15:46 ` [RFC PATCH 13/16] x86/split_lock: Add debugfs interface to control user mode behavior Fenghua Yu
2018-05-27 15:46 ` [RFC PATCH 14/16] x86/split_lock: Add debugfs interface to show and control firmware setting for split lock Fenghua Yu
2018-05-27 15:46 ` [RFC PATCH 15/16] x86/split_lock: Add CONFIG and debugfs interface for testing #AC for split lock in kernel mode Fenghua Yu
2018-05-27 15:46 ` [RFC PATCH 16/16] x86/split_lock: Add user space split lock test in selftest Fenghua Yu
2018-05-29 16:39 ` [RFC PATCH 00/16] x86/split_lock: Enable #AC exception for split locked accesses Dave Hansen
2018-05-29 17:25   ` Fenghua Yu
2018-05-29 17:28     ` Dave Hansen
2018-05-29 17:40       ` Fenghua Yu
2018-05-29 16:40 ` Dave Hansen
2018-05-29 17:38   ` Fenghua Yu
2018-06-21 20:06   ` Peter Zijlstra
2018-06-21 19:37 ` Peter Zijlstra
2018-06-21 20:18   ` Fenghua Yu
2018-06-21 20:32     ` Thomas Gleixner
2018-06-21 22:00       ` Fenghua Yu
2018-06-21 22:07         ` Peter Zijlstra
2018-06-21 22:08         ` Peter Zijlstra
2018-06-21 22:18           ` Dave Hansen
2018-06-21 22:42             ` Fenghua Yu
2018-06-22  8:11               ` Peter Zijlstra
2018-06-22  9:30               ` Thomas Gleixner
2018-06-21 22:10         ` Peter Zijlstra
2018-06-21 23:05           ` Fenghua Yu
2018-06-22  8:19             ` Peter Zijlstra
2018-06-21 22:11         ` Peter Zijlstra
2018-06-21 22:43           ` Fenghua Yu
2018-06-21 22:13         ` Peter Zijlstra
2018-06-23 18:47           ` Fenghua Yu
2018-06-22  9:18         ` Thomas Gleixner
2018-06-22  9:22         ` Thomas Gleixner
2018-06-22  9:25         ` Thomas Gleixner
2018-06-22  9:28         ` Thomas Gleixner
2018-06-21 20:36     ` Peter Zijlstra

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1527435965-202085-9-git-send-email-fenghua.yu@intel.com \
    --to=fenghua.yu@intel.com \
    --cc=alan@linux.intel.com \
    --cc=arjan@infradead.org \
    --cc=ashok.raj@intel.com \
    --cc=dave.hansen@intel.com \
    --cc=hpa@linux.intel.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=mingo@elte.hu \
    --cc=rafael.j.wysocki@intel.com \
    --cc=ravi.v.shankar@intel.com \
    --cc=tglx@linutronix.de \
    --cc=tony.luck@intel.com \
    --cc=x86@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).