[PATCH 1/2] mtd: spi-nor: cadence-quadspi: fix timeout handling in wait_for_completion_timeout

From: Nicholas Mc Guire <hofrat@osadl.org>
To: Vignesh R <vigneshr@ti.com>
Cc: Marek Vasut <marek.vasut@gmail.com>,
	David Woodhouse <dwmw2@infradead.org>,
	Brian Norris <computersforpeace@gmail.com>,
	Boris Brezillon <boris.brezillon@bootlin.com>,
	Richard Weinberger <richard@nod.at>,
	linux-mtd@lists.infradead.org, linux-kernel@vger.kernel.org,
	Nicholas Mc Guire <hofrat@osadl.org>
Subject: [PATCH 1/2] mtd: spi-nor: cadence-quadspi: fix timeout handling in wait_for_completion_timeout
Date: Sat, 21 Jul 2018 16:21:51 +0200	[thread overview]
Message-ID: <1532182912-3674-1-git-send-email-hofrat@osadl.org> (raw)

wait_for_completion_timeout returns unsigned long not int so a variable of
proper type is introduced. Further the check for <= 0 is ambiguous and should
be == 0 here.

Signed-off-by: Nicholas Mc Guire <hofrat@osadl.org>
Fixes: ffa639e069fb ("mtd: spi-nor: cadence-quadspi: Add DMA support for direct mode reads")
---

Patch found by experimental coccinelle API conformance checker

Patch was compile tested with: socfpga_defconfig (implies
CONFIG_SPI_CADENCE_QUADSPI=y)

Patch is against 4.18-rc5 (localversion-next is next-20180720)

 drivers/mtd/spi-nor/cadence-quadspi.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
index d7e10b3..79f6a54 100644
--- a/drivers/mtd/spi-nor/cadence-quadspi.c
+++ b/drivers/mtd/spi-nor/cadence-quadspi.c
@@ -953,6 +953,7 @@ static int cqspi_direct_read_execute(struct spi_nor *nor, u_char *buf,
 	enum dma_ctrl_flags flags = DMA_CTRL_ACK | DMA_PREP_INTERRUPT;
 	dma_addr_t dma_src = (dma_addr_t)cqspi->mmap_phys_base + from;
 	int ret = 0;
+	unsigned long timeout;
 	struct dma_async_tx_descriptor *tx;
 	dma_cookie_t cookie;
 	dma_addr_t dma_dst;
@@ -988,9 +989,9 @@ static int cqspi_direct_read_execute(struct spi_nor *nor, u_char *buf,
 	}
 
 	dma_async_issue_pending(cqspi->rx_chan);
-	ret = wait_for_completion_timeout(&cqspi->rx_dma_complete,
-					  msecs_to_jiffies(len));
-	if (ret <= 0) {
+	timeout = wait_for_completion_timeout(&cqspi->rx_dma_complete,
+					      msecs_to_jiffies(len));
+	if (timeout == 0) {
 		dmaengine_terminate_sync(cqspi->rx_chan);
 		dev_err(nor->dev, "DMA wait_for_completion_timeout\n");
 		ret = -ETIMEDOUT;
-- 
2.1.4

