[PATCH] hvmloader/PCI: skip huge BARs in certain calculations

[Jan Beulich <jbeulich@suse.com>]

BARs of size 2Gb and up can't possibly fit below 4Gb: Both the bottom of
the lower 2Gb range and the top of the higher 2Gb range have special
purpose. Don't even have them influence whether to (perhaps) relocate
low RAM.

Reported-by: Neowutran <xen@neowutran.ovh>
Signed-off-by: Jan Beulich <jbeulich@suse.com>
---
If we wanted to fit e.g. multiple 1Gb BARs, it would likely be prudent
to similarly avoid low RAM relocation in the first place. Yet accounting
for things differently depending on how many large BARs there are would
require more intrusive code changes.

That said, I'm open to further lowering of the threshold. That'll
require different justification then, though.

--- a/tools/firmware/hvmloader/pci.c
+++ b/tools/firmware/hvmloader/pci.c
@@ -33,6 +33,13 @@ uint32_t pci_mem_start = HVM_BELOW_4G_MM
 const uint32_t pci_mem_end = RESERVED_MEMBASE;
 uint64_t pci_hi_mem_start = 0, pci_hi_mem_end = 0;
 
+/*
+ * BARs larger than this value are put in 64-bit space unconditionally.  That
+ * is, such BARs also don't play into the determination of how big the lowmem
+ * MMIO hole needs to be.
+ */
+#define HUGE_BAR_THRESH GB(1)
+
 enum virtual_vga virtual_vga = VGA_none;
 unsigned long igd_opregion_pgbase = 0;
 
@@ -286,9 +293,11 @@ void pci_setup(void)
             bars[i].bar_reg = bar_reg;
             bars[i].bar_sz  = bar_sz;
 
-            if ( ((bar_data & PCI_BASE_ADDRESS_SPACE) ==
-                  PCI_BASE_ADDRESS_SPACE_MEMORY) ||
-                 (bar_reg == PCI_ROM_ADDRESS) )
+            if ( is_64bar && bar_sz > HUGE_BAR_THRESH )
+                bar64_relocate = 1;
+            else if ( ((bar_data & PCI_BASE_ADDRESS_SPACE) ==
+                       PCI_BASE_ADDRESS_SPACE_MEMORY) ||
+                      (bar_reg == PCI_ROM_ADDRESS) )
                 mmio_total += bar_sz;
 
             nr_bars++;
@@ -367,7 +376,7 @@ void pci_setup(void)
             pci_mem_start = hvm_info->low_mem_pgend << PAGE_SHIFT;
     }
 
-    if ( mmio_total > (pci_mem_end - pci_mem_start) )
+    if ( mmio_total > (pci_mem_end - pci_mem_start) || bar64_relocate )
     {
         printf("Low MMIO hole not large enough for all devices,"
                " relocating some BARs to 64-bit\n");
@@ -446,8 +455,9 @@ void pci_setup(void)
          *   the code here assumes it to be.)
          * Should either of those two conditions change, this code will break.
          */
-        using_64bar = bars[i].is_64bar && bar64_relocate
-            && (mmio_total > (mem_resource.max - mem_resource.base));
+        using_64bar = bars[i].is_64bar && bar64_relocate &&
+            (mmio_total > (mem_resource.max - mem_resource.base) ||
+             bar_sz > HUGE_BAR_THRESH);
         bar_data = pci_readl(devfn, bar_reg);
 
         if ( (bar_data & PCI_BASE_ADDRESS_SPACE) ==
@@ -467,7 +477,8 @@ void pci_setup(void)
                 resource = &mem_resource;
                 bar_data &= ~PCI_BASE_ADDRESS_MEM_MASK;
             }
-            mmio_total -= bar_sz;
+            if ( bar_sz <= HUGE_BAR_THRESH )
+                mmio_total -= bar_sz;
         }
         else
         {