[PATCH] drm/i915/edp: get the panel delay before powering up

[Dave Airlie <airlied@gmail.com>]

In order to setup the i2c channel, we power up the panel
via ironlake_edp_panel_vdd_on, however it requires
intel_dp->panel_power_up_delay to be initialised,
which hasn't been setup yet.

So move things around so we set the panel power up
values first then init the i2c stuff.

This is one step to fixing the eDP panel in the MBP
from uninitialised state.

Signed-off-by: Dave Airlie <airlied@redhat.com>
---
 drivers/gpu/drm/i915/intel_dp.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index a6c426a..ace757a 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -2533,14 +2533,10 @@ intel_dp_init(struct drm_device *dev, int output_reg)
 			break;
 	}
 
-	intel_dp_i2c_init(intel_dp, intel_connector, name);
-
 	/* Cache some DPCD data in the eDP case */
 	if (is_edp(intel_dp)) {
-		bool ret;
 		struct edp_power_seq	cur, vbt;
 		u32 pp_on, pp_off, pp_div;
-		struct edid *edid;
 
 		pp_on = I915_READ(PCH_PP_ON_DELAYS);
 		pp_off = I915_READ(PCH_PP_OFF_DELAYS);
@@ -2591,6 +2587,13 @@ intel_dp_init(struct drm_device *dev, int output_reg)
 
 		DRM_DEBUG_KMS("backlight on delay %d, off delay %d\n",
 			      intel_dp->backlight_on_delay, intel_dp->backlight_off_delay);
+	}
+
+	intel_dp_i2c_init(intel_dp, intel_connector, name);
+
+	if (is_edp(intel_dp)) {
+		bool ret;
+		struct edid *edid;
 
 		ironlake_edp_panel_vdd_on(intel_dp);
 		ret = intel_dp_get_dpcd(intel_dp);
-- 
1.7.11.2