All of lore.kernel.org
 help / color / mirror / Atom feed
From: Andreas Fenkart <afenkart@gmail.com>
To: Chris Ball <cjb@laptop.org>
Cc: Tony Lindgren <tony@atomide.com>,
	Grant Likely <grant.likely@secretlab.ca>,
	Felipe Balbi <balbi@ti.com>, Balaji T K <balajitk@ti.com>,
	zonque@gmail.com, devicetree@vger.kernel.org,
	linux-doc@vger.kernel.org, linux-mmc@vger.kernel.org,
	linux-omap@vger.kernel.org, Andreas Fenkart <afenkart@gmail.com>
Subject: [PATCH 3/3] mmc: omap_hsmmc: Extend debugfs for SDIO IRQ, GPIO and pinmux.
Date: Mon, 11 Nov 2013 21:06:45 +0100	[thread overview]
Message-ID: <1384200405-8402-4-git-send-email-afenkart@gmail.com> (raw)
In-Reply-To: <1384200405-8402-1-git-send-email-afenkart@gmail.com>

Add SDIO IRQ entries to debugfs entry. Note that PSTATE shows current
state of data lines, incl. SDIO IRQ pending

Signed-off-by: Andreas Fenkart <afenkart@gmail.com>
---
 drivers/mmc/host/omap_hsmmc.c |   19 ++++++++++++++++++-
 1 file changed, 18 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index 5a7fb4b..c4f71d0 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -81,6 +81,7 @@ static void apply_clk_hack(struct device *dev)
 #define OMAP_HSMMC_RSP54	0x0118
 #define OMAP_HSMMC_RSP76	0x011C
 #define OMAP_HSMMC_DATA		0x0120
+#define OMAP_HSMMC_PSTATE	0x0124
 #define OMAP_HSMMC_HCTL		0x0128
 #define OMAP_HSMMC_SYSCTL	0x012C
 #define OMAP_HSMMC_STAT		0x0130
@@ -1794,6 +1795,20 @@ static int omap_hsmmc_regs_show(struct seq_file *s, void *data)
 {
 	struct mmc_host *mmc = s->private;
 	struct omap_hsmmc_host *host = mmc_priv(mmc);
+	bool suspended;
+
+	seq_puts(s, "\n");
+	seq_printf(s, "sdio irq\t%s\n", ((host->flags & HSMMC_SDIO_IRQ_ENABLED)
+					 ? "enabled" : "disabled"));
+	suspended = host->dev->power.runtime_status != RPM_ACTIVE;
+	if (host->flags & HSMMC_SWAKEUP_QUIRK) {
+		seq_printf(s, "pinmux config\t%s\n", (suspended ?
+						      "gpio" : "sdio"));
+		if (suspended)
+			seq_printf(s, "sdio irq pin\t%s\n",
+				   gpio_get_value(mmc_slot(host).gpio_cirq) ?
+				   "high" : "low");
+	}
 
 	if (host->suspended) {
 		seq_printf(s, "host suspended, can't read registers\n");
@@ -1801,9 +1816,11 @@ static int omap_hsmmc_regs_show(struct seq_file *s, void *data)
 	}
 
 	pm_runtime_get_sync(host->dev);
-
+	seq_puts(s, "\nregs:\n");
 	seq_printf(s, "CON:\t\t0x%08x\n",
 			OMAP_HSMMC_READ(host->base, CON));
+	seq_printf(s, "PSTATE:\t\t0x%08x\n",
+		   OMAP_HSMMC_READ(host->base, PSTATE));
 	seq_printf(s, "HCTL:\t\t0x%08x\n",
 			OMAP_HSMMC_READ(host->base, HCTL));
 	seq_printf(s, "SYSCTL:\t\t0x%08x\n",
-- 
1.7.10.4


  parent reply	other threads:[~2013-11-11 20:06 UTC|newest]

Thread overview: 12+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2013-11-11 20:06 [PATCH 0/3] mmc: omap_hsmmc: Enable SDIO IRQ Andreas Fenkart
2013-11-11 20:06 ` [PATCH 1/3] " Andreas Fenkart
     [not found]   ` <1384200405-8402-2-git-send-email-afenkart-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2013-11-12 11:23     ` Michael Trimarchi
2013-11-12 17:22   ` Balaji T K
2013-11-14  9:09     ` Andreas Fenkart
2013-11-11 20:06 ` [PATCH 2/3] mmc: omap_hsmmc: Pin remux workaround to support SDIO interrupt on AM335x Andreas Fenkart
2013-11-12 11:27   ` Michael Trimarchi
2013-11-11 20:06 ` Andreas Fenkart [this message]
     [not found] <1384195979-14726-1-git-send-email-y>
2013-11-11 18:52 ` [PATCH 3/3] mmc: omap_hsmmc: Extend debugfs for SDIO IRQ, GPIO and pinmux afenkart
2013-11-11 19:00   ` Michael Trimarchi
2013-11-11 19:30     ` Andreas Fenkart
  -- strict thread matches above, loose matches on Subject: below --
2013-11-02 20:26 [PATCH 1/3] mmc: omap_hsmmc: Enable SDIO IRQ Andreas Fenkart
2013-11-02 20:26 ` [PATCH 3/3] mmc: omap_hsmmc: Extend debugfs for SDIO IRQ, GPIO and pinmux Andreas Fenkart

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1384200405-8402-4-git-send-email-afenkart@gmail.com \
    --to=afenkart@gmail.com \
    --cc=balajitk@ti.com \
    --cc=balbi@ti.com \
    --cc=cjb@laptop.org \
    --cc=devicetree@vger.kernel.org \
    --cc=grant.likely@secretlab.ca \
    --cc=linux-doc@vger.kernel.org \
    --cc=linux-mmc@vger.kernel.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=tony@atomide.com \
    --cc=zonque@gmail.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.