[PATCH] drm/i915: make edp optimize config

[matthew.s.atwood@intel.com]

From: Matt Atwood <matthew.s.atwood@intel.com>

Previously it was assumed that eDP panels would advertise the lowest link
rate required for their singular mode to function. With the introduction
of more advanced features there are advantages to a panel advertising a
higher rate then it needs for a its given mode. For panels that did, the
driver previously used a higher rate then necessary for that mode.

Signed-off-by: Matt Atwood <matthew.s.atwood@intel.com>
---
 drivers/gpu/drm/i915/intel_dp.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index a2eeede..57b309c 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -1766,8 +1766,10 @@ intel_dp_compute_config(struct intel_encoder *encoder,
 		 * configuration, and typically these values correspond to the
 		 * native resolution of the panel.
 		 */
-		min_lane_count = max_lane_count;
-		min_clock = max_clock;
+		if(dpcd[DP_DPCD_REV] < DPCD_REV_14){
+			min_lane_count = max_lane_count;
+			min_clock = max_clock;
+		}
 	}
 
 	for (; bpp >= 6*3; bpp -= 2*3) {
-- 
2.7.4

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx