[PATCH 1/2] mmc: tmio: Add data timeout error detection

[Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>]

From: Masaharu Hayakawa <masaharu.hayakawa.ry@renesas.com>

Currently, busy timeout is not checked for data transfer command. But,
if the temperature condition changes, the data cannot be acquired
correctly and timeout may occur. Also, we could reproduce an issue by
using mmc_test driver (e.g. "Correct xfer_size at write (start
failure)"). Therefore, this adds timeout error check.

Signed-off-by: Masaharu Hayakawa <masaharu.hayakawa.ry@renesas.com>
[saito: rework commit message.]
Signed-off-by: Takeshi Saito <takeshi.saito.xv@renesas.com>
[shimoda: rebase, add commit description]
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
 drivers/mmc/host/tmio_mmc_core.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/host/tmio_mmc_core.c b/drivers/mmc/host/tmio_mmc_core.c
index 942b8375..21492b5 100644
--- a/drivers/mmc/host/tmio_mmc_core.c
+++ b/drivers/mmc/host/tmio_mmc_core.c
@@ -477,8 +477,10 @@ static void tmio_mmc_data_irq(struct tmio_mmc_host *host, unsigned int stat)
 	if (!data)
 		goto out;
 
-	if (stat & TMIO_STAT_CRCFAIL || stat & TMIO_STAT_STOPBIT_ERR ||
-	    stat & TMIO_STAT_TXUNDERRUN)
+	if (stat & TMIO_STAT_DATATIMEOUT)
+		data->error = -ETIMEDOUT;
+	else if (stat & TMIO_STAT_CRCFAIL || stat & TMIO_STAT_STOPBIT_ERR ||
+		 stat & TMIO_STAT_TXUNDERRUN)
 		data->error = -EILSEQ;
 	if (host->dma_on && (data->flags & MMC_DATA_WRITE)) {
 		u32 status = sd_ctrl_read16_and_16_as_32(host, CTL_STATUS);
-- 
2.7.4