[PATCH v10 00/19] KVM RISC-V Support

[Anup Patel <Anup.Patel@wdc.com>]

This series adds initial KVM RISC-V support. Currently, we are able to boot
RISC-V 64bit Linux Guests with multiple VCPUs.

Few key aspects of KVM RISC-V added by this series are:
1. Minimal possible KVM world-switch which touches only GPRs and few CSRs.
2. Full Guest/VM switch is done via vcpu_get/vcpu_put infrastructure.
3. KVM ONE_REG interface for VCPU register access from user-space.
4. PLIC emulation is done in user-space.
5. Timer and IPI emuation is done in-kernel.
6. MMU notifiers supported.
7. FP lazy save/restore supported.
8. SBI v0.1 emulation for KVM Guest available.
9. Forward unhandled SBI calls to KVM userspace.
10. Hugepage support for Guest/VM

Here's a brief TODO list which we will work upon after this series:
1. SBI v0.2 emulation in-kernel
2. SBI v0.2 hart state management emulation in-kernel
3. In-kernel PLIC emulation
4. ..... and more .....

This series can be found in riscv_kvm_v10 branch at:
https//github.com/avpatel/linux.git

Our work-in-progress KVMTOOL RISC-V port can be found in riscv_v1 branch
at: https//github.com/avpatel/kvmtool.git

The QEMU RISC-V hypervisor emulation is done by Alistair and is available
in mainline/alistair/riscv-hyp-ext-v0.5.1 branch at:
https://github.com/kvm-riscv/qemu.git

To play around with KVM RISC-V, refer KVM RISC-V wiki at:
https://github.com/kvm-riscv/howto/wiki
https://github.com/kvm-riscv/howto/wiki/KVM-RISCV64-on-QEMU

Changes since v9:
 - Squash PATCH19 and PATCH20 into PATCH5
 - Squash PATCH18 into PATCH11
 - Squash PATCH17 into PATCH16
 - Added ONE_REG interface for VCPU timer in PATCH13
 - Use HTIMEDELTA for VCPU timer in PATCH13
 - Updated KVM RISC-V mailing list in MAINTAINERS entry
 - Update KVM kconfig option to depend on RISCV_SBI and MMU
 - Check for SBI v0.2 and SBI v0.2 RFENCE extension at boot-time
 - Use SBI v0.2 RFENCE extension in VMID implementation
 - Use SBI v0.2 RFENCE extension in Stage2 MMU implementation
 - Use SBI v0.2 RFENCE extension in SBI implementation
 - Moved to RISC-V Hypervisor v0.5 draft spec
 - Updated Documentation/virt/kvm/api.txt for timer ONE_REG interface
 - Rebased patches on Linux-5.5-rc3

Changes since v8:
 - Rebased series on Linux-5.4-rc3 and Atish's SBI v0.2 patches
 - Use HRTIMER_MODE_REL instead of HRTIMER_MODE_ABS in timer emulation
 - Fixed kvm_riscv_stage2_map() to handle hugepages
 - Added patch to forward unhandled SBI calls to user-space
 - Added patch for iterative/recursive stage2 page table programming
 - Added patch to remove per-CPU vsip_shadow variable
 - Added patch to fix race-condition in kvm_riscv_vcpu_sync_interrupts()

Changes since v7:
- Rebased series on Linux-5.4-rc1 and Atish's SBI v0.2 patches
- Removed PATCH1, PATCH3, and PATCH20 because these already merged
- Use kernel doc style comments for ISA bitmap functions
- Don't parse X, Y, and Z extension in riscv_fill_hwcap() because it will
  be added in-future
- Mark KVM RISC-V kconfig option as EXPERIMENTAL
- Typo fix in commit description of PATCH6 of v7 series
- Use separate structs for CORE and CSR registers of ONE_REG interface
- Explicitly include asm/sbi.h in kvm/vcpu_sbi.c
- Removed implicit switch-case fall-through in kvm_riscv_vcpu_exit()
- No need to set VSSTATUS.MXR bit in kvm_riscv_vcpu_unpriv_read()
- Removed register for instruction length in kvm_riscv_vcpu_unpriv_read()
- Added defines for checking/decoding instruction length
- Added separate patch to forward unhandled SBI calls to userspace tool

Changes since v6:
- Rebased patches on Linux-5.3-rc7
- Added "return_handled" in struct kvm_mmio_decode to ensure that
  kvm_riscv_vcpu_mmio_return() updates SEPC only once
- Removed trap_stval parameter from kvm_riscv_vcpu_unpriv_read()
- Updated git repo URL in MAINTAINERS entry

Changes since v5:
- Renamed KVM_REG_RISCV_CONFIG_TIMEBASE register to
  KVM_REG_RISCV_CONFIG_TBFREQ register in ONE_REG interface
- Update SPEC in kvm_riscv_vcpu_mmio_return() for MMIO exits
- Use switch case instead of illegal instruction opcode table for simplicity
- Improve comments in stage2_remote_tlb_flush() for a potential remote TLB
  flush optimization
- Handle all unsupported SBI calls in default case of
  kvm_riscv_vcpu_sbi_ecall() function
- Fixed kvm_riscv_vcpu_sync_interrupts() for software interrupts
- Improved unprivilege reads to handle traps due to Guest stage1 page table
- Added separate patch to document RISC-V specific things in
  Documentation/virt/kvm/api.txt

Changes since v4:
- Rebased patches on Linux-5.3-rc5
- Added Paolo's Acked-by and Reviewed-by
- Updated mailing list in MAINTAINERS entry

Changes since v3:
- Moved patch for ISA bitmap from KVM prep series to this series
- Make vsip_shadow as run-time percpu variable instead of compile-time
- Flush Guest TLBs on all Host CPUs whenever we run-out of VMIDs

Changes since v2:
- Removed references of KVM_REQ_IRQ_PENDING from all patches
- Use kvm->srcu within in-kernel KVM run loop
- Added percpu vsip_shadow to track last value programmed in VSIP CSR
- Added comments about irqs_pending and irqs_pending_mask
- Used kvm_arch_vcpu_runnable() in-place-of kvm_riscv_vcpu_has_interrupt()
  in system_opcode_insn()
- Removed unwanted smp_wmb() in kvm_riscv_stage2_vmid_update()
- Use kvm_flush_remote_tlbs() in kvm_riscv_stage2_vmid_update()
- Use READ_ONCE() in kvm_riscv_stage2_update_hgatp() for vmid

Changes since v1:
- Fixed compile errors in building KVM RISC-V as module
- Removed unused kvm_riscv_halt_guest() and kvm_riscv_resume_guest()
- Set KVM_CAP_SYNC_MMU capability only after MMU notifiers are implemented
- Made vmid_version as unsigned long instead of atomic
- Renamed KVM_REQ_UPDATE_PGTBL to KVM_REQ_UPDATE_HGATP
- Renamed kvm_riscv_stage2_update_pgtbl() to kvm_riscv_stage2_update_hgatp()
- Configure HIDELEG and HEDELEG in kvm_arch_hardware_enable()
- Updated ONE_REG interface for CSR access to user-space
- Removed irqs_pending_lock and use atomic bitops instead
- Added separate patch for FP ONE_REG interface
- Added separate patch for updating MAINTAINERS file

Anup Patel (15):
  RISC-V: Export riscv_cpuid_to_hartid_mask() API
  RISC-V: Add bitmap reprensenting ISA features common across CPUs
  RISC-V: Add hypervisor extension related CSR defines
  RISC-V: Add initial skeletal KVM support
  RISC-V: KVM: Implement VCPU create, init and destroy functions
  RISC-V: KVM: Implement VCPU interrupts and requests handling
  RISC-V: KVM: Implement KVM_GET_ONE_REG/KVM_SET_ONE_REG ioctls
  RISC-V: KVM: Implement VCPU world-switch
  RISC-V: KVM: Handle MMIO exits for VCPU
  RISC-V: KVM: Handle WFI exits for VCPU
  RISC-V: KVM: Implement VMID allocator
  RISC-V: KVM: Implement stage2 page table programming
  RISC-V: KVM: Implement MMU notifiers
  RISC-V: KVM: Document RISC-V specific parts of KVM API.
  RISC-V: KVM: Add MAINTAINERS entry

Atish Patra (4):
  RISC-V: KVM: Add timer functionality
  RISC-V: KVM: FP lazy save/restore
  RISC-V: KVM: Implement ONE REG interface for FP registers
  RISC-V: KVM: Add SBI v0.1 support

 Documentation/virt/kvm/api.txt          |  169 +++-
 MAINTAINERS                             |   11 +
 arch/riscv/Kconfig                      |    2 +
 arch/riscv/Makefile                     |    2 +
 arch/riscv/include/asm/csr.h            |   78 +-
 arch/riscv/include/asm/hwcap.h          |   22 +
 arch/riscv/include/asm/kvm_host.h       |  264 ++++++
 arch/riscv/include/asm/kvm_vcpu_timer.h |   44 +
 arch/riscv/include/asm/pgtable-bits.h   |    1 +
 arch/riscv/include/uapi/asm/kvm.h       |  127 +++
 arch/riscv/kernel/asm-offsets.c         |  148 ++++
 arch/riscv/kernel/cpufeature.c          |   83 +-
 arch/riscv/kernel/smp.c                 |    2 +
 arch/riscv/kvm/Kconfig                  |   34 +
 arch/riscv/kvm/Makefile                 |   14 +
 arch/riscv/kvm/main.c                   |   97 +++
 arch/riscv/kvm/mmu.c                    |  762 +++++++++++++++++
 arch/riscv/kvm/tlb.S                    |   43 +
 arch/riscv/kvm/vcpu.c                   | 1013 +++++++++++++++++++++++
 arch/riscv/kvm/vcpu_exit.c              |  639 ++++++++++++++
 arch/riscv/kvm/vcpu_sbi.c               |  171 ++++
 arch/riscv/kvm/vcpu_switch.S            |  382 +++++++++
 arch/riscv/kvm/vcpu_timer.c             |  225 +++++
 arch/riscv/kvm/vm.c                     |   86 ++
 arch/riscv/kvm/vmid.c                   |  120 +++
 drivers/clocksource/timer-riscv.c       |    8 +
 include/clocksource/timer-riscv.h       |   16 +
 include/uapi/linux/kvm.h                |    8 +
 28 files changed, 4558 insertions(+), 13 deletions(-)
 create mode 100644 arch/riscv/include/asm/kvm_host.h
 create mode 100644 arch/riscv/include/asm/kvm_vcpu_timer.h
 create mode 100644 arch/riscv/include/uapi/asm/kvm.h
 create mode 100644 arch/riscv/kvm/Kconfig
 create mode 100644 arch/riscv/kvm/Makefile
 create mode 100644 arch/riscv/kvm/main.c
 create mode 100644 arch/riscv/kvm/mmu.c
 create mode 100644 arch/riscv/kvm/tlb.S
 create mode 100644 arch/riscv/kvm/vcpu.c
 create mode 100644 arch/riscv/kvm/vcpu_exit.c
 create mode 100644 arch/riscv/kvm/vcpu_sbi.c
 create mode 100644 arch/riscv/kvm/vcpu_switch.S
 create mode 100644 arch/riscv/kvm/vcpu_timer.c
 create mode 100644 arch/riscv/kvm/vm.c
 create mode 100644 arch/riscv/kvm/vmid.c
 create mode 100644 include/clocksource/timer-riscv.h

-- 
2.17.1