From: Faiz Abbas <faiz_abbas@ti.com> To: <linux-arm-kernel@lists.infradead.org>, <linux-kernel@vger.kernel.org>, <devicetree@vger.kernel.org>, <linux-mmc@vger.kernel.org>, <adrian.hunter@intel.com>, <will@kernel.org>, <catalin.marinas@arm.com>, <robh+dt@kernel.org>, <ulf.hansson@linaro.org> Cc: <faiz_abbas@ti.com> Subject: [PATCH 5/7] mmc: sdhci_am654: Update delay chain configuration Date: Fri, 19 Jun 2020 18:27:59 +0530 [thread overview] Message-ID: <20200619125801.9530-6-faiz_abbas@ti.com> (raw) In-Reply-To: <20200619125801.9530-1-faiz_abbas@ti.com> For speed modes where DLL is not enabled write to TXDLYCLK to enable transmitter delay chain mode. Signed-off-by: Faiz Abbas <faiz_abbas@ti.com> --- drivers/mmc/host/sdhci_am654.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/sdhci_am654.c b/drivers/mmc/host/sdhci_am654.c index 8b0f69012d09..f7535ee3a232 100644 --- a/drivers/mmc/host/sdhci_am654.c +++ b/drivers/mmc/host/sdhci_am654.c @@ -61,6 +61,8 @@ #define CALDONE_MASK BIT(CALDONE_SHIFT) #define RETRIM_SHIFT 17 #define RETRIM_MASK BIT(RETRIM_SHIFT) +#define SELDLYTXCLK_SHIFT 17 +#define SELDLYTXCLK_MASK BIT(SELDLYTXCLK_SHIFT) #define DRIVER_STRENGTH_50_OHM 0x0 #define DRIVER_STRENGTH_33_OHM 0x1 @@ -228,8 +230,14 @@ static void sdhci_am654_set_clock(struct sdhci_host *host, unsigned int clock) regmap_update_bits(sdhci_am654->base, PHY_CTRL4, mask, val); - if (timing > MMC_TIMING_UHS_SDR25 && clock > CLOCK_TOO_SLOW_HZ) + if (timing > MMC_TIMING_UHS_SDR25 && clock > CLOCK_TOO_SLOW_HZ) { + regmap_update_bits(sdhci_am654->base, PHY_CTRL5, + SELDLYTXCLK_MASK, 0); sdhci_am654_setup_dll(host, clock); + } else { + regmap_update_bits(sdhci_am654->base, PHY_CTRL5, + SELDLYTXCLK_MASK, 1 << SELDLYTXCLK_SHIFT); + } } static void sdhci_j721e_4bit_set_clock(struct sdhci_host *host, -- 2.17.1
WARNING: multiple messages have this Message-ID (diff)
From: Faiz Abbas <faiz_abbas@ti.com> To: <linux-arm-kernel@lists.infradead.org>, <linux-kernel@vger.kernel.org>, <devicetree@vger.kernel.org>, <linux-mmc@vger.kernel.org>, <adrian.hunter@intel.com>, <will@kernel.org>, <catalin.marinas@arm.com>, <robh+dt@kernel.org>, <ulf.hansson@linaro.org> Cc: faiz_abbas@ti.com Subject: [PATCH 5/7] mmc: sdhci_am654: Update delay chain configuration Date: Fri, 19 Jun 2020 18:27:59 +0530 [thread overview] Message-ID: <20200619125801.9530-6-faiz_abbas@ti.com> (raw) In-Reply-To: <20200619125801.9530-1-faiz_abbas@ti.com> For speed modes where DLL is not enabled write to TXDLYCLK to enable transmitter delay chain mode. Signed-off-by: Faiz Abbas <faiz_abbas@ti.com> --- drivers/mmc/host/sdhci_am654.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/sdhci_am654.c b/drivers/mmc/host/sdhci_am654.c index 8b0f69012d09..f7535ee3a232 100644 --- a/drivers/mmc/host/sdhci_am654.c +++ b/drivers/mmc/host/sdhci_am654.c @@ -61,6 +61,8 @@ #define CALDONE_MASK BIT(CALDONE_SHIFT) #define RETRIM_SHIFT 17 #define RETRIM_MASK BIT(RETRIM_SHIFT) +#define SELDLYTXCLK_SHIFT 17 +#define SELDLYTXCLK_MASK BIT(SELDLYTXCLK_SHIFT) #define DRIVER_STRENGTH_50_OHM 0x0 #define DRIVER_STRENGTH_33_OHM 0x1 @@ -228,8 +230,14 @@ static void sdhci_am654_set_clock(struct sdhci_host *host, unsigned int clock) regmap_update_bits(sdhci_am654->base, PHY_CTRL4, mask, val); - if (timing > MMC_TIMING_UHS_SDR25 && clock > CLOCK_TOO_SLOW_HZ) + if (timing > MMC_TIMING_UHS_SDR25 && clock > CLOCK_TOO_SLOW_HZ) { + regmap_update_bits(sdhci_am654->base, PHY_CTRL5, + SELDLYTXCLK_MASK, 0); sdhci_am654_setup_dll(host, clock); + } else { + regmap_update_bits(sdhci_am654->base, PHY_CTRL5, + SELDLYTXCLK_MASK, 1 << SELDLYTXCLK_SHIFT); + } } static void sdhci_j721e_4bit_set_clock(struct sdhci_host *host, -- 2.17.1 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2020-06-19 12:58 UTC|newest] Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top 2020-06-19 12:57 [PATCH 0/7] Add support for SD card in AM654x-evm Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas 2020-06-19 12:57 ` [PATCH 1/7] dt-bindings: mmc: sdhci-am654: Add ti,clkbuf-sel binding Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas 2020-06-19 12:57 ` [PATCH 2/7] mmc: sdhci_am654: Add flag for PHY calibration Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas 2020-06-19 12:57 ` [PATCH 3/7] mmc: sdhci_am654: Add Support for SR2.0 Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas 2020-06-19 12:57 ` [PATCH 4/7] mmc: sdhci_am654: Fix conditions for enabling dll Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas 2020-06-19 12:57 ` Faiz Abbas [this message] 2020-06-19 12:57 ` [PATCH 5/7] mmc: sdhci_am654: Update delay chain configuration Faiz Abbas 2020-06-19 12:58 ` [PATCH 6/7] mmc: sdhci_am654: Add support for clkbuf_sel property Faiz Abbas 2020-06-19 12:58 ` Faiz Abbas 2020-06-19 12:58 ` [PATCH 7/7] arm64: defconfig: Enable AM654x SDHCI controller Faiz Abbas 2020-06-19 12:58 ` Faiz Abbas 2020-07-16 12:19 ` Faiz Abbas 2020-07-16 12:19 ` Faiz Abbas 2020-07-16 13:25 ` Sekhar Nori 2020-07-16 13:25 ` Sekhar Nori 2020-07-16 18:28 ` Arnd Bergmann 2020-07-16 18:28 ` Arnd Bergmann 2020-07-17 8:38 ` Faiz Abbas 2020-07-17 8:38 ` Faiz Abbas 2020-07-17 11:20 ` Tero Kristo 2020-07-17 11:20 ` Tero Kristo 2020-07-17 13:09 ` Arnd Bergmann 2020-07-17 13:09 ` Arnd Bergmann 2020-07-17 13:36 ` Faiz Abbas 2020-07-17 13:36 ` Faiz Abbas 2020-07-17 13:43 ` Tero Kristo 2020-07-17 13:43 ` Tero Kristo 2020-07-03 7:27 ` [PATCH 0/7] Add support for SD card in AM654x-evm Faiz Abbas 2020-07-03 7:27 ` Faiz Abbas 2020-07-06 14:48 ` Ulf Hansson 2020-07-06 14:48 ` Ulf Hansson
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20200619125801.9530-6-faiz_abbas@ti.com \ --to=faiz_abbas@ti.com \ --cc=adrian.hunter@intel.com \ --cc=catalin.marinas@arm.com \ --cc=devicetree@vger.kernel.org \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-mmc@vger.kernel.org \ --cc=robh+dt@kernel.org \ --cc=ulf.hansson@linaro.org \ --cc=will@kernel.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.