From: Rocky Liao <rjliao@codeaurora.org>
To: marcel@holtmann.org, johan.hedberg@gmail.com
Cc: linux-kernel@vger.kernel.org, linux-bluetooth@vger.kernel.org,
linux-arm-msm@vger.kernel.org, Rocky Liao <rjliao@codeaurora.org>
Subject: [PATCH v3] Bluetooth: btusb: Add Qualcomm Bluetooth SoC WCN6855 support
Date: Fri, 25 Sep 2020 17:08:29 +0800 [thread overview]
Message-ID: <20200925090829.3088-1-rjliao@codeaurora.org> (raw)
In-Reply-To: <20200914092744.17464-1-rjliao@codeaurora.org>
This patch add support for WCN6855 i.e. patch and nvm download
support.
Signed-off-by: Rocky Liao <rjliao@codeaurora.org>
---
drivers/bluetooth/btusb.c | 66 +++++++++++++++++++++++++++++++--------
1 file changed, 53 insertions(+), 13 deletions(-)
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 9f294b941943..e888e4c02d69 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -59,6 +59,7 @@ static struct usb_driver btusb_driver;
#define BTUSB_MEDIATEK 0x200000
#define BTUSB_WIDEBAND_SPEECH 0x400000
#define BTUSB_VALID_LE_STATES 0x800000
+#define BTUSB_QCA_WCN6855 0x1000000
static const struct usb_device_id btusb_table[] = {
/* Generic Bluetooth USB device */
@@ -291,6 +292,10 @@ static const struct usb_device_id blacklist_table[] = {
{ USB_DEVICE(0x13d3, 0x3501), .driver_info = BTUSB_QCA_ROME |
BTUSB_WIDEBAND_SPEECH },
+ /* QCA WCN6855 chipset */
+ { USB_DEVICE(0x0cf3, 0xe600), .driver_info = BTUSB_QCA_WCN6855 |
+ BTUSB_WIDEBAND_SPEECH },
+
/* Broadcom BCM2035 */
{ USB_DEVICE(0x0a5c, 0x2009), .driver_info = BTUSB_BCM92035 },
{ USB_DEVICE(0x0a5c, 0x200a), .driver_info = BTUSB_WRONG_SCO_MTU },
@@ -3409,6 +3414,27 @@ static int btusb_set_bdaddr_ath3012(struct hci_dev *hdev,
return 0;
}
+static int btusb_set_bdaddr_wcn6855(struct hci_dev *hdev,
+ const bdaddr_t *bdaddr)
+{
+ struct sk_buff *skb;
+ u8 buf[6];
+ long ret;
+
+ memcpy(buf, bdaddr, sizeof(bdaddr_t));
+
+ skb = __hci_cmd_sync_ev(hdev, 0xfc14, sizeof(buf), buf,
+ HCI_EV_CMD_COMPLETE, HCI_INIT_TIMEOUT);
+ if (IS_ERR(skb)) {
+ ret = PTR_ERR(skb);
+ bt_dev_err(hdev, "Change address command failed (%ld)", ret);
+ return ret;
+ }
+ kfree_skb(skb);
+
+ return 0;
+}
+
#define QCA_DFU_PACKET_LEN 4096
#define QCA_GET_TARGET_VERSION 0x09
@@ -3428,7 +3454,8 @@ struct qca_version {
} __packed;
struct qca_rampatch_version {
- __le16 rom_version;
+ __le16 rom_version_high;
+ __le16 rom_version_low;
__le16 patch_version;
} __packed;
@@ -3440,12 +3467,14 @@ struct qca_device_info {
};
static const struct qca_device_info qca_devices_table[] = {
- { 0x00000100, 20, 4, 10 }, /* Rome 1.0 */
- { 0x00000101, 20, 4, 10 }, /* Rome 1.1 */
- { 0x00000200, 28, 4, 18 }, /* Rome 2.0 */
- { 0x00000201, 28, 4, 18 }, /* Rome 2.1 */
- { 0x00000300, 28, 4, 18 }, /* Rome 3.0 */
- { 0x00000302, 28, 4, 18 }, /* Rome 3.2 */
+ { 0x00000100, 20, 4, 8 }, /* Rome 1.0 */
+ { 0x00000101, 20, 4, 8 }, /* Rome 1.1 */
+ { 0x00000200, 28, 4, 16 }, /* Rome 2.0 */
+ { 0x00000201, 28, 4, 16 }, /* Rome 2.1 */
+ { 0x00000300, 28, 4, 16 }, /* Rome 3.0 */
+ { 0x00000302, 28, 4, 16 }, /* Rome 3.2 */
+ { 0x00130100, 40, 4, 16 }, /* WCN6855 1.0 */
+ { 0x00130200, 40, 4, 16 } /* WCN6855 2.0 */
};
static int btusb_qca_send_vendor_req(struct usb_device *udev, u8 request,
@@ -3547,8 +3576,8 @@ static int btusb_setup_qca_load_rampatch(struct hci_dev *hdev,
{
struct qca_rampatch_version *rver;
const struct firmware *fw;
- u32 ver_rom, ver_patch;
- u16 rver_rom, rver_patch;
+ u32 ver_rom, ver_patch, rver_rom;
+ u16 rver_rom_low, rver_rom_high, rver_patch;
char fwname[64];
int err;
@@ -3567,9 +3596,16 @@ static int btusb_setup_qca_load_rampatch(struct hci_dev *hdev,
bt_dev_info(hdev, "using rampatch file: %s", fwname);
rver = (struct qca_rampatch_version *)(fw->data + info->ver_offset);
- rver_rom = le16_to_cpu(rver->rom_version);
+ rver_rom_low = le16_to_cpu(rver->rom_version_low);
rver_patch = le16_to_cpu(rver->patch_version);
+ if (ver_rom & ~0xffffU) {
+ rver_rom_high = le16_to_cpu(rver->rom_version_high);
+ rver_rom = le32_to_cpu(rver_rom_high << 16 | rver_rom_low);
+ } else {
+ rver_rom = rver_rom_low;
+ }
+
bt_dev_info(hdev, "QCA: patch rome 0x%x build 0x%x, "
"firmware rome 0x%x build 0x%x",
rver_rom, rver_patch, ver_rom, ver_patch);
@@ -3643,9 +3679,6 @@ static int btusb_setup_qca(struct hci_dev *hdev)
return err;
ver_rom = le32_to_cpu(ver.rom_version);
- /* Don't care about high ROM versions */
- if (ver_rom & ~0xffffU)
- return 0;
for (i = 0; i < ARRAY_SIZE(qca_devices_table); i++) {
if (ver_rom == qca_devices_table[i].rom_version)
@@ -4081,6 +4114,13 @@ static int btusb_probe(struct usb_interface *intf,
btusb_check_needs_reset_resume(intf);
}
+ if (id->driver_info & BTUSB_QCA_WCN6855) {
+ data->setup_on_usb = btusb_setup_qca;
+ hdev->set_bdaddr = btusb_set_bdaddr_wcn6855;
+ hdev->cmd_timeout = btusb_qca_cmd_timeout;
+ set_bit(HCI_QUIRK_SIMULTANEOUS_DISCOVERY, &hdev->quirks);
+ }
+
if (id->driver_info & BTUSB_AMP) {
/* AMP controllers do not support SCO packets */
data->isoc = NULL;
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
next prev parent reply other threads:[~2020-09-25 9:08 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-09-04 6:21 [PATCH v1] Bluetooth: btusb: Add Qualcomm Bluetooth SoC WCN6855 support Rocky Liao
2020-09-14 9:27 ` [PATCH v2] " Rocky Liao
2020-09-14 13:28 ` Marcel Holtmann
2020-09-15 9:29 ` Rocky Liao
2020-09-15 13:57 ` Marcel Holtmann
2020-09-16 2:02 ` Rocky Liao
2020-09-15 10:09 ` kernel test robot
2020-09-25 9:08 ` Rocky Liao [this message]
2020-09-25 16:08 ` [PATCH v3] " Marcel Holtmann
2020-09-28 2:11 ` Rocky Liao
2020-09-29 4:23 ` [PATCH v4] " Rocky Liao
2020-09-29 6:17 ` Marcel Holtmann
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200925090829.3088-1-rjliao@codeaurora.org \
--to=rjliao@codeaurora.org \
--cc=johan.hedberg@gmail.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-bluetooth@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=marcel@holtmann.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.