[PATCH 01/18] arm64: dts: renesas: beacon kit: Configure programmable clocks

[Adam Ford <aford173@gmail.com>]

When the board was added, clock drivers were being updated done at
the same time to allow the versaclock driver to properly configure
the modes.  Unforutnately, the updates were not applied to the board
files at the time they should have been, so do it now.

Signed-off-by: Adam Ford <aford173@gmail.com>
---
 .../dts/renesas/beacon-renesom-baseboard.dtsi | 35 +++++++++++++++++--
 .../boot/dts/renesas/beacon-renesom-som.dtsi  | 26 ++++++++++++++
 2 files changed, 58 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/renesas/beacon-renesom-baseboard.dtsi b/arch/arm64/boot/dts/renesas/beacon-renesom-baseboard.dtsi
index e66b5b36e489..3c84e060c69f 100644
--- a/arch/arm64/boot/dts/renesas/beacon-renesom-baseboard.dtsi
+++ b/arch/arm64/boot/dts/renesas/beacon-renesom-baseboard.dtsi
@@ -5,6 +5,7 @@
 
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/input/input.h>
+#include <dt-bindings/clk/versaclock.h>
 
 / {
 	backlight_lvds: backlight-lvds {
@@ -294,12 +295,12 @@ &du_out_rgb {
 &ehci0 {
 	dr_mode = "otg";
 	status = "okay";
-	clocks = <&cpg CPG_MOD 703>, <&cpg CPG_MOD 704>;
+	clocks = <&cpg CPG_MOD 703>, <&cpg CPG_MOD 704>, <&versaclock5 3>;
 };
 
 &ehci1 {
 	status = "okay";
-	clocks = <&cpg CPG_MOD 703>, <&cpg CPG_MOD 704>;
+	clocks = <&cpg CPG_MOD 703>, <&cpg CPG_MOD 704>, <&versaclock5 3>;
 };
 
 &hdmi0 {
@@ -373,12 +374,40 @@ versaclock6_bb: clock-controller@6a {
 		#clock-cells = <1>;
 		clocks = <&x304_clk>;
 		clock-names = "xin";
-		/* CSI0_MCLK, CSI1_MCLK, AUDIO_CLKIN, USB_HUB_MCLK_BB */
+		clock-output-names = "versaclock6_bb.out0_sel_i2cb",
+				      "versaclock6_bb.out1",
+				      "versaclock6_bb.out2",
+				      "versaclock6_bb.out3",
+				      "versaclock6_bb.out4";
 		assigned-clocks = <&versaclock6_bb 1>,
 				   <&versaclock6_bb 2>,
 				   <&versaclock6_bb 3>,
 				   <&versaclock6_bb 4>;
 		assigned-clock-rates =	<24000000>, <24000000>, <24000000>, <24576000>;
+
+		OUT1 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <1800000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT2 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <1800000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT3 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <3300000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT4 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <3300000>;
+			idt,slew-percent = <100>;
+		};
 	};
 };
 
diff --git a/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
index 8ac167aa18f0..449ff5937fc6 100644
--- a/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
+++ b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
@@ -4,6 +4,7 @@
  */
 
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/clk/versaclock.h>
 
 / {
 	memory@48000000 {
@@ -170,7 +171,32 @@ versaclock5: versaclock_som@6a {
 				   <&versaclock5 2>,
 				   <&versaclock5 3>,
 				   <&versaclock5 4>;
+
 		assigned-clock-rates = <33333333>, <33333333>, <50000000>, <125000000>;
+
+		OUT1 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <1800000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT2 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <1800000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT3 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <1800000>;
+			idt,slew-percent = <100>;
+		};
+
+		OUT4 {
+			idt,mode = <VC5_CMOS>;
+			idt,voltage-microvolts = <3300000>;
+			idt,slew-percent = <100>;
+		};
 	};
 };
 
-- 
2.25.1