[PATCH v5 12/13] spi: mxic: Use spi_mem_generic_supports_op()

[Miquel Raynal <miquel.raynal@bootlin.com>]

This driver can be simplified a little bit by using
spi_mem_generic_supports_op() instead of the
spi_mem_default/dtr_supports_op() couple. The all_false boolean is
inverted to become a dtr boolean, which checks if at least one of the
operation member uses dtr mode. The idea behind this change is to
simplify the introduction of the pipelined ECC engine.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/spi/spi-mxic.c | 10 +++-------
 1 file changed, 3 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/spi-mxic.c b/drivers/spi/spi-mxic.c
index 485a7f2afb44..5e71aa630504 100644
--- a/drivers/spi/spi-mxic.c
+++ b/drivers/spi/spi-mxic.c
@@ -452,7 +452,7 @@ static ssize_t mxic_spi_mem_dirmap_write(struct spi_mem_dirmap_desc *desc,
 static bool mxic_spi_mem_supports_op(struct spi_mem *mem,
 				     const struct spi_mem_op *op)
 {
-	bool all_false;
+	struct spi_mem_controller_caps caps = {};
 
 	if (op->data.buswidth > 8 || op->addr.buswidth > 8 ||
 	    op->dummy.buswidth > 8 || op->cmd.buswidth > 8)
@@ -465,13 +465,9 @@ static bool mxic_spi_mem_supports_op(struct spi_mem *mem,
 	if (op->addr.nbytes > 7)
 		return false;
 
-	all_false = !op->cmd.dtr && !op->addr.dtr && !op->dummy.dtr &&
-		    !op->data.dtr;
+	caps.dtr = op->cmd.dtr || op->addr.dtr || op->dummy.dtr || op->data.dtr;
 
-	if (all_false)
-		return spi_mem_default_supports_op(mem, op);
-	else
-		return spi_mem_dtr_supports_op(mem, op);
+	return spi_mem_generic_supports_op(mem, op, &caps);
 }
 
 static int mxic_spi_mem_dirmap_create(struct spi_mem_dirmap_desc *desc)
-- 
2.27.0