[PATCH] fpga: altera-cvp: Truncated bitstream error support

[tien.sung.ang@intel.com]

From: Ang Tien Sung <tien.sung.ang@intel.com>

To support the error handling of a truncated bitstream sent.
The current AIB CvP firmware is not capable of handling a
data stream smaller than 4096bytes. The firmware's limitation
causes a hung-up as it's DMA engine waits forever for the
completion of the instructed 4096bytes.
To resolve this design limitation, both firmware and CvP
driver made several changes. At the CvP driver, we just
have to ensure that anything lesser than 4096bytes are
padded with extra bytes. The CvP will then, initiate the
tear-down by clearing the START_XFER and CVP_CONFIG bits.
We should also check for CVP_ERROR during the CvP completion.
A send_buf which is always 4096bytes is used to copy the
data during every transaction.

Signed-off-by: Ang Tien Sung <tien.sung.ang@intel.com>
---
 drivers/fpga/altera-cvp.c | 24 +++++++++++++++++++-----
 1 file changed, 19 insertions(+), 5 deletions(-)

diff --git a/drivers/fpga/altera-cvp.c b/drivers/fpga/altera-cvp.c
index 4ffb9da537d8..80edcfb5e5fc 100644
--- a/drivers/fpga/altera-cvp.c
+++ b/drivers/fpga/altera-cvp.c
@@ -81,6 +81,7 @@ struct altera_cvp_conf {
 	u8			numclks;
 	u32			sent_packets;
 	u32			vsec_offset;
+	u8			*send_buf;
 	const struct cvp_priv	*priv;
 };
 
@@ -453,7 +454,11 @@ static int altera_cvp_write(struct fpga_manager *mgr, const char *buf,
 		}
 
 		len = min(conf->priv->block_size, remaining);
-		altera_cvp_send_block(conf, data, len);
+		/* Copy the requested host data into the transmit buffer */
+
+		memcpy(conf->send_buf, data, len);
+		altera_cvp_send_block(conf, (const u32 *)conf->send_buf,
+		conf->priv->block_size);
 		data += len / sizeof(u32);
 		done += len;
 		remaining -= len;
@@ -492,10 +497,13 @@ static int altera_cvp_write_complete(struct fpga_manager *mgr,
 	if (ret)
 		return ret;
 
-	/* STEP 16 - check CVP_CONFIG_ERROR_LATCHED bit */
-	altera_read_config_dword(conf, VSE_UNCOR_ERR_STATUS, &val);
-	if (val & VSE_UNCOR_ERR_CVP_CFG_ERR) {
-		dev_err(&mgr->dev, "detected CVP_CONFIG_ERROR_LATCHED!\n");
+	/*
+	 * STEP 16 - If bitstream error (truncated/miss-matched),
+	 * we shall exit here.
+	 */
+	ret = altera_read_config_dword(conf, VSE_CVP_STATUS, &val);
+	if (ret || (val & VSE_CVP_STATUS_CFG_ERR)) {
+		dev_err(&mgr->dev, "CVP_CONFIG_ERROR!\n");
 		return -EPROTO;
 	}
 
@@ -661,6 +669,12 @@ static int altera_cvp_probe(struct pci_dev *pdev,
 
 	pci_set_drvdata(pdev, mgr);
 
+	/* Allocate the 4096 block size transmit buffer */
+	conf->send_buf = devm_kzalloc(&pdev->dev, conf->priv->block_size, GFP_KERNEL);
+	if (!conf->send_buf) {
+		ret = -ENOMEM;
+		goto err_unmap;
+	}
 	return 0;
 
 err_unmap:
-- 
2.25.1