[PATCH net-next 3/3] net: ethernet: renesas: rswitch: Add phy_power_{on,off}() calling

[Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>]

Some Ethernet PHYs (like marvell10g) will decide the host interface
mode by the media-side speed. So, the rswitch driver needs to
initialize one of the Ethernet SERDES (r8a779f0-eth-serdes) ports
after linked the Ethernet PHY up. The r8a779f0-eth-serdes driver has
.init() for initializing all ports and .power_on() for initializing
each port. So, add phy_power_{on,off} calling for it.

Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
---
 drivers/net/ethernet/renesas/rswitch.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/ethernet/renesas/rswitch.c b/drivers/net/ethernet/renesas/rswitch.c
index ca79ee168206..2f335c95f5a8 100644
--- a/drivers/net/ethernet/renesas/rswitch.c
+++ b/drivers/net/ethernet/renesas/rswitch.c
@@ -1180,6 +1180,10 @@ static void rswitch_mac_link_down(struct phylink_config *config,
 				  unsigned int mode,
 				  phy_interface_t interface)
 {
+	struct net_device *ndev = to_net_dev(config->dev);
+	struct rswitch_device *rdev = netdev_priv(ndev);
+
+	phy_power_off(rdev->serdes);
 }
 
 static void rswitch_mac_link_up(struct phylink_config *config,
@@ -1187,7 +1191,11 @@ static void rswitch_mac_link_up(struct phylink_config *config,
 				phy_interface_t interface, int speed,
 				int duplex, bool tx_pause, bool rx_pause)
 {
+	struct net_device *ndev = to_net_dev(config->dev);
+	struct rswitch_device *rdev = netdev_priv(ndev);
+
 	/* Current hardware cannot change speed at runtime */
+	phy_power_on(rdev->serdes);
 }
 
 static const struct phylink_mac_ops rswitch_phylink_ops = {
-- 
2.25.1