[PATCH v3 4/9] wifi: rtw88: Add rtw8703b.h

[Fiona Klute <fiona.klute@gmx.de>]

This is the main header for the new rtw88_8703b chip driver.

Acked-by: Ping-Ke Shih <pkshih@realtek.com>
Tested-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Fiona Klute <fiona.klute@gmx.de>
---
 drivers/net/wireless/realtek/rtw88/rtw8703b.h | 102 ++++++++++++++++++
 1 file changed, 102 insertions(+)
 create mode 100644 drivers/net/wireless/realtek/rtw88/rtw8703b.h

diff --git a/drivers/net/wireless/realtek/rtw88/rtw8703b.h b/drivers/net/wireless/realtek/rtw88/rtw8703b.h
new file mode 100644
index 00000000000..3e2da2e6739
--- /dev/null
+++ b/drivers/net/wireless/realtek/rtw88/rtw8703b.h
@@ -0,0 +1,102 @@
+/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
+/* Copyright Fiona Klute <fiona.klute@gmx.de> */
+
+#ifndef __RTW8703B_H__
+#define __RTW8703B_H__
+
+#include "rtw8723x.h"
+
+extern const struct rtw_chip_info rtw8703b_hw_spec;
+
+/* phy status parsing */
+#define VGA_BITS GENMASK(4, 0)
+#define LNA_L_BITS GENMASK(7, 5)
+#define LNA_H_BIT BIT(7)
+/* masks for assembling LNA index from high and low bits */
+#define BIT_LNA_H_MASK BIT(3)
+#define BIT_LNA_L_MASK GENMASK(2, 0)
+
+struct phy_rx_agc_info {
+#ifdef __LITTLE_ENDIAN
+	u8 gain: 7;
+	u8 trsw: 1;
+#else
+	u8 trsw: 1;
+	u8 gain: 7;
+#endif
+} __packed;
+
+/* This struct is called phy_status_rpt_8192cd in the vendor driver,
+ * there might be potential to share it with drivers for other chips
+ * of the same generation.
+ */
+struct phy_status_8703b {
+	struct phy_rx_agc_info path_agc[2];
+	u8 ch_corr[2];
+	u8 cck_sig_qual_ofdm_pwdb_all;
+	/* for CCK: bits 0:4: VGA index, bits 5:7: LNA index (low) */
+	u8 cck_agc_rpt_ofdm_cfosho_a;
+	/* for CCK: bit 7 is high bit of LNA index if long report type */
+	u8 cck_rpt_b_ofdm_cfosho_b;
+	u8 reserved_1;
+	u8 noise_power_db_msb;
+	s8 path_cfotail[2];
+	u8 pcts_mask[2];
+	s8 stream_rxevm[2];
+	u8 path_rxsnr[2];
+	u8 noise_power_db_lsb;
+	u8 reserved_2[3];
+	u8 stream_csi[2];
+	u8 stream_target_csi[2];
+	s8 sig_evm;
+	u8 reserved_3;
+
+#ifdef __LITTLE_ENDIAN
+	u8 antsel_rx_keep_2: 1;
+	u8 sgi_en: 1;
+	u8 rxsc: 2;
+	u8 idle_long: 1;
+	u8 r_ant_train_en: 1;
+	u8 ant_sel_b: 1;
+	u8 ant_sel: 1;
+#else /* __BIG_ENDIAN */
+	u8 ant_sel: 1;
+	u8 ant_sel_b: 1;
+	u8 r_ant_train_en: 1;
+	u8 idle_long: 1;
+	u8 rxsc: 2;
+	u8 sgi_en: 1;
+	u8 antsel_rx_keep_2: 1;
+#endif
+} __packed;
+
+/* Baseband registers */
+#define REG_BB_PWR_SAV5_11N 0x0818
+/* BIT(11) should be 1 for 8703B *and* 8723D, which means LNA uses 4
+ * bit for CCK rates in report, not 3. Vendor driver logs a warning if
+ * it's 0, but handles the case.
+ *
+ * Purpose of other parts of this register is unknown, 8723cs driver
+ * code indicates some other chips use certain bits for antenna
+ * diversity.
+ */
+#define REG_BB_AMP 0x0950
+#define BIT_MASK_RX_LNA (BIT(11))
+
+/* 0xaXX: 40MHz channel settings */
+#define REG_CCK_TXSF2 0x0a24  /* CCK TX filter 2 */
+#define REG_CCK_DBG 0x0a28  /* debug port */
+#define REG_OFDM0_A_TX_AFE 0x0c84
+#define REG_TXIQK_MATRIXB_LSB2_11N 0x0c9c
+#define REG_OFDM0_TX_PSD_NOISE 0x0ce4  /* TX pseudo noise weighting */
+#define REG_IQK_RDY 0x0e90  /* is != 0 when IQK is done */
+
+/* RF registers */
+#define RF_RCK1 0x1E
+
+#define AGG_BURST_NUM 3
+#define AGG_BURST_SIZE 0 /* 1K */
+#define BIT_MASK_AGG_BURST_NUM (GENMASK(3, 2))
+#define BIT_MASK_AGG_BURST_SIZE (GENMASK(5, 4))
+
+#endif /* __RTW8703B_H__ */
--
2.43.0