Re: [PATCH v2] PCI: Mark LSI FW643 to avoid bus reset

[Takashi Sakamoto <o-takashi@sakamocchi.jp>]

Hi Bjorn Helgaas,

(C.C.ed to linux1394-devel@lists.sourceforge.net)

I have an objection to applying the change.

I've been using the issued 1394 OHCI hardware in my development for recent
years, while I have never faced the reported trouble. I think there are
any misunderstanding or misjudge somwhow in the review process to apply it.

Would I ask your precise advice to regenerate the reported issue in my
local?

This is my 1394 OHCI hardware.

```
$ sudo lspci -vvvnns 06:00.0
06:00.0 FireWire (IEEE 1394) [0c00]: LSI Corporation FW643 [TrueFire] PCIe 1394b Controller [11c1:5901] (rev 06) (prog-if 10 [OHCI])
        Subsystem: LSI Corporation FW643 [TrueFire] PCIe 1394b Controller [11c1:5900]
        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Interrupt: pin A routed to IRQ 255
        IOMMU group: 17
        Region 0: Memory at fc700000 (64-bit, non-prefetchable) [disabled] [size=4K]
        Capabilities: [44] Power Management version 3
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D3 NoSoftRst- PME-Enable+ DSel=0 DScale=0 PME-
        Capabilities: [4c] MSI: Enable- Count=1/1 Maskable- 64bit+
                Address: 0000000000000000  Data: 0000
        Capabilities: [60] Express (v1) Endpoint, MSI 00
                DevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s <4us, L1 <64us
                        ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset- SlotPowerLimit 0W
                DevCtl: CorrErr+ NonFatalErr+ FatalErr+ UnsupReq+
                        RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
                        MaxPayload 128 bytes, MaxReadReq 512 bytes
                DevSta: CorrErr- NonFatalErr- FatalErr- UnsupReq- AuxPwr+ TransPend-
                LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Exit Latency L0s <512ns, L1 <64us
                        ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp-
                LnkCtl: ASPM Disabled; RCB 64 bytes, Disabled- CommClk+
                        ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
                LnkSta: Speed 2.5GT/s, Width x1
                        TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
        Capabilities: [100 v1] Advanced Error Reporting
                UESta:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
                UEMsk:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
                UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
                CESta:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr-
                CEMsk:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr+
                AERCap: First Error Pointer: 00, ECRCGenCap+ ECRCGenEn- ECRCChkCap+ ECRCChkEn-
                        MultHdrRecCap- MultHdrRecEn- TLPPfxPres- HdrLogCap-
                HeaderLog: 00000000 00000000 00000000 00000000
        Capabilities: [140 v1] Virtual Channel
                Caps:   LPEVC=0 RefClk=100ns PATEntryBits=1
                Arb:    Fixed- WRR32- WRR64- WRR128-
                Ctrl:   ArbSelect=Fixed
                Status: InProgress-
                VC0:    Caps:   PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
                        Arb:    Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
                        Ctrl:   Enable+ ID=0 ArbSelect=Fixed TC/VC=01
                        Status: NegoPending- InProgress-
                VC1:    Caps:   PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
                        Arb:    Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
                        Ctrl:   Enable- ID=1 ArbSelect=Fixed TC/VC=00
                        Status: NegoPending- InProgress-
        Capabilities: [170 v1] Device Serial Number 12-34-56-10-12-30-00-86
        Kernel driver in use: vfio-pci
        Kernel modules: firewire_ohci
```

I use it in the following environment at present:

* Host system
    * AMD Ryzen 5 2400G
    * TUF GAMING X570-PLUS with BIOS 5003 (AGESA ComboV2PI 1.2.0.B)
        * SMT enabled
        * SVM enabled
        * IOMMU enabled
        * Secure boot disabled
    * Ubuntu 24.04 LTS amd64
        * linux-image-6.8.0-11-generic (6.8.0-11.11)
            * default kernel cmdline
        * QEMU 8.2.1 (1:8.2.1+ds-1ubuntu1)
        * Libvert 10.0.0 (10.0.0-2ubuntu1)
* Guest system
    * UEFI using OVMF
        * Seecure boot enabled
    * Ubuntu 24.04 LTS amd64 (the same as above)
        * default kernel cmdline

> Using LSI / Agere FW643 with vfio-pci will exhaust all
> pci_reset_fn_methods, the bus reset at the end causes a broken link
> only recoverable by removing power
> (power-off / suspend + rescan).
> Prevent this bus reset.
> With this change, the device can be assigned to VMs with VFIO.
> Note that it will not be reset, resulting in leaking state between VMs
> and host.
> 
> Signed-off-by: Edmund Raile <edmund.raile@proton.me>
> 
> I sincerely thank you for your patience and explaining
> the background of pci resets which I lacked.
> The commit message and comment now describe it correctly.
> The comment on leaking states was added.
> 
> Usefulness:
> 
> The LSI FW643 PCIe->FireWire 800 interface may be EOL but it is
> the only one that does not use a PCIe->PCI bridge.
> It is reliable and enables FireWire audio interfaces to be used
> on modern machines.
> 
> Virtualization allows for flexible access to professional audio
> software.
> 
> It has been used in at least the following Apple machines:
> MacBookPro10,1
> MacBookPro9,2
> MacBookPro6,2
> MacBookPro5,1
> Macmini6,1
> Macmini3,1
> iMac12,2
> iMac9,1
> iMac8,1
> 
> Implementation:
> 
> PCI_VENDOR_ID_ATT was reused as they are identical.
> 
>  drivers/pci/quirks.c | 13 +++++++++++++
>  1 file changed, 13 insertions(+)
> 
> diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
> index d797df6e5f3e..e0e4ad9e6d50 100644
> --- a/drivers/pci/quirks.c
> +++ b/drivers/pci/quirks.c
> @@ -3765,6 +3765,19 @@ DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_ATHEROS, 0x003e, quirk_no_bus_reset);
>   */
>  DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_CAVIUM, 0xa100, quirk_no_bus_reset);
>  
> +/*
> + * Using LSI / Agere FW643 with vfio-pci will exhaust all
> + * pci_reset_fn_methods, the bus reset at the end causes a broken link
> + * only recoverable by removing power
> + * (power-off / suspend + rescan).
> + * Prevent this bus reset.
> + * With this change, the device can be assigned to VMs with VFIO.
> + * Note that it will not be reset, resulting in leaking state between VMs
> + * and host.
> + */
> +DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_ATT, 0x5900, quirk_no_bus_reset);
> +DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_ATT, 0x5901, quirk_no_bus_reset);
> +
>  /*
>   * Some TI KeyStone C667X devices do not support bus/hot reset.  The PCIESS
>   * automatically disables LTSSM when Secondary Bus Reset is received and


Regards

Takashi Sakamoto