[PATCH 5/6] mmc: sdhci-brcmstb: Add BCM2712 support

[Andrea della Porta <andrea.porta@suse.com>]

Broadcom BCM2712 SoC has an SDHCI card controller using the SDIO CFG
register block present on other STB chips. Add support for BCM2712
SD capabilities of this chipset.
The silicon is SD Express capable but this driver port does not currently
include that feature yet.
Based on downstream driver by raspberry foundation maintained kernel.

Signed-off-by: Andrea della Porta <andrea.porta@suse.com>
---
 drivers/mmc/host/sdhci-brcmstb.c | 130 +++++++++++++++++++++++++++++++
 1 file changed, 130 insertions(+)

diff --git a/drivers/mmc/host/sdhci-brcmstb.c b/drivers/mmc/host/sdhci-brcmstb.c
index 9053526fa212..907a4947abe5 100644
--- a/drivers/mmc/host/sdhci-brcmstb.c
+++ b/drivers/mmc/host/sdhci-brcmstb.c
@@ -12,6 +12,8 @@
 #include <linux/of.h>
 #include <linux/bitops.h>
 #include <linux/delay.h>
+#include <linux/pinctrl/consumer.h>
+#include <linux/regulator/consumer.h>
 
 #include "sdhci-cqhci.h"
 #include "sdhci-pltfm.h"
@@ -30,15 +32,31 @@
 
 #define SDHCI_ARASAN_CQE_BASE_ADDR		0x200
 
+#define SDIO_CFG_CTRL				0x0
+#define  SDIO_CFG_CTRL_SDCD_N_TEST_EN		BIT(31)
+#define  SDIO_CFG_CTRL_SDCD_N_TEST_LEV		BIT(30)
+
+#define SDIO_CFG_SD_PIN_SEL			0x44
+#define  SDIO_CFG_SD_PIN_SEL_MASK		0x3
+#define  SDIO_CFG_SD_PIN_SEL_SD			BIT(1)
+#define  SDIO_CFG_SD_PIN_SEL_MMC		BIT(0)
+
+#define SDIO_CFG_MAX_50MHZ_MODE			0x1ac
+#define  SDIO_CFG_MAX_50MHZ_MODE_STRAP_OVERRIDE	BIT(31)
+#define  SDIO_CFG_MAX_50MHZ_MODE_ENABLE		BIT(0)
+
 struct sdhci_brcmstb_priv {
 	void __iomem *cfg_regs;
 	unsigned int flags;
 	struct clk *base_clk;
 	u32 base_freq_hz;
+	struct pinctrl *pinctrl;
+	struct pinctrl_state *pins_default;
 };
 
 struct brcmstb_match_priv {
 	void (*hs400es)(struct mmc_host *mmc, struct mmc_ios *ios);
+	void (*cfginit)(struct sdhci_host *host);
 	struct sdhci_ops *ops;
 	const unsigned int flags;
 };
@@ -124,6 +142,42 @@ static void sdhci_brcmstb_hs400es(struct mmc_host *mmc, struct mmc_ios *ios)
 	writel(reg, host->ioaddr + SDHCI_VENDOR);
 }
 
+static void sdhci_bcm2712_set_clock(struct sdhci_host *host, unsigned int clock)
+{
+	u16 clk;
+	u32 reg;
+	bool is_emmc_rate = false;
+	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+	struct sdhci_brcmstb_priv *brcmstb_priv = sdhci_pltfm_priv(pltfm_host);
+
+	host->mmc->actual_clock = 0;
+
+	sdhci_writew(host, 0, SDHCI_CLOCK_CONTROL);
+
+	switch (host->mmc->ios.timing) {
+	case MMC_TIMING_MMC_HS400:
+	case MMC_TIMING_MMC_HS200:
+	case MMC_TIMING_MMC_DDR52:
+	case MMC_TIMING_MMC_HS:
+	is_emmc_rate = true;
+	break;
+	}
+
+	reg = readl(brcmstb_priv->cfg_regs + SDIO_CFG_SD_PIN_SEL);
+	reg &= ~SDIO_CFG_SD_PIN_SEL_MASK;
+	if (is_emmc_rate)
+		reg |= SDIO_CFG_SD_PIN_SEL_MMC;
+	else
+		reg |= SDIO_CFG_SD_PIN_SEL_SD;
+	writel(reg, brcmstb_priv->cfg_regs + SDIO_CFG_SD_PIN_SEL);
+
+	if (clock == 0)
+		return;
+
+	clk = sdhci_calc_clk(host, clock, &host->mmc->actual_clock);
+	sdhci_enable_clk(host, clk);
+}
+
 static void sdhci_brcmstb_set_clock(struct sdhci_host *host, unsigned int clock)
 {
 	u16 clk;
@@ -139,6 +193,17 @@ static void sdhci_brcmstb_set_clock(struct sdhci_host *host, unsigned int clock)
 	sdhci_enable_clk(host, clk);
 }
 
+static void sdhci_brcmstb_set_power(struct sdhci_host *host, unsigned char mode,
+				  unsigned short vdd)
+{
+	if (!IS_ERR(host->mmc->supply.vmmc)) {
+		struct mmc_host *mmc = host->mmc;
+
+		mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, vdd);
+	}
+	sdhci_set_power_noreg(host, mode, vdd);
+}
+
 static void sdhci_brcmstb_set_uhs_signaling(struct sdhci_host *host,
 					    unsigned int timing)
 {
@@ -168,6 +233,36 @@ static void sdhci_brcmstb_set_uhs_signaling(struct sdhci_host *host,
 	sdhci_writew(host, ctrl_2, SDHCI_HOST_CONTROL2);
 }
 
+static void sdhci_brcmstb_cfginit_2712(struct sdhci_host *host)
+{
+	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+	struct sdhci_brcmstb_priv *brcmstb_priv = sdhci_pltfm_priv(pltfm_host);
+	u32 uhs_mask = (MMC_CAP_UHS_SDR50 | MMC_CAP_UHS_SDR104);
+	u32 hsemmc_mask = (MMC_CAP2_HS200_1_8V_SDR | MMC_CAP2_HS200_1_2V_SDR |
+			   MMC_CAP2_HS400_1_8V | MMC_CAP2_HS400_1_2V);
+	u32 reg;
+
+	/*
+	* If we support a speed that requires tuning,
+	* then select the delay line PHY as the clock source.
+	*/
+	if ((host->mmc->caps & uhs_mask) || (host->mmc->caps2 & hsemmc_mask)) {
+		reg = readl(brcmstb_priv->cfg_regs + SDIO_CFG_MAX_50MHZ_MODE);
+		reg &= ~SDIO_CFG_MAX_50MHZ_MODE_ENABLE;
+		reg |= SDIO_CFG_MAX_50MHZ_MODE_STRAP_OVERRIDE;
+		writel(reg, brcmstb_priv->cfg_regs + SDIO_CFG_MAX_50MHZ_MODE);
+	}
+
+	if ((host->mmc->caps & MMC_CAP_NONREMOVABLE) ||
+	    (host->mmc->caps & MMC_CAP_NEEDS_POLL)) {
+		/* Force presence */
+		reg = readl(brcmstb_priv->cfg_regs + SDIO_CFG_CTRL);
+		reg &= ~SDIO_CFG_CTRL_SDCD_N_TEST_LEV;
+		reg |= SDIO_CFG_CTRL_SDCD_N_TEST_EN;
+		writel(reg, brcmstb_priv->cfg_regs + SDIO_CFG_CTRL);
+	}
+}
+
 static void sdhci_brcmstb_dumpregs(struct mmc_host *mmc)
 {
 	sdhci_dumpregs(mmc_priv(mmc));
@@ -200,6 +295,14 @@ static struct sdhci_ops sdhci_brcmstb_ops = {
 	.set_uhs_signaling = sdhci_set_uhs_signaling,
 };
 
+static struct sdhci_ops sdhci_brcmstb_ops_2712 = {
+	.set_clock = sdhci_bcm2712_set_clock,
+	.set_power = sdhci_brcmstb_set_power,
+	.set_bus_width = sdhci_set_bus_width,
+	.reset = sdhci_reset,
+	.set_uhs_signaling = sdhci_set_uhs_signaling,
+};
+
 static struct sdhci_ops sdhci_brcmstb_ops_7216 = {
 	.set_clock = sdhci_brcmstb_set_clock,
 	.set_bus_width = sdhci_set_bus_width,
@@ -237,7 +340,13 @@ static struct brcmstb_match_priv match_priv_74165b0 = {
 	.ops = &sdhci_brcmstb_ops_74165b0,
 };
 
+static const struct brcmstb_match_priv match_priv_2712 = {
+	.cfginit = sdhci_brcmstb_cfginit_2712,
+	.ops = &sdhci_brcmstb_ops_2712,
+};
+
 static const struct of_device_id __maybe_unused sdhci_brcm_of_match[] = {
+	{ .compatible = "brcm,bcm2712-sdhci", .data = &match_priv_2712 },
 	{ .compatible = "brcm,bcm7425-sdhci", .data = &match_priv_7425 },
 	{ .compatible = "brcm,bcm7445-sdhci", .data = &match_priv_7445 },
 	{ .compatible = "brcm,bcm7216-sdhci", .data = &match_priv_7216 },
@@ -314,11 +423,16 @@ static int sdhci_brcmstb_probe(struct platform_device *pdev)
 	struct sdhci_brcmstb_priv *priv;
 	u32 actual_clock_mhz;
 	struct sdhci_host *host;
+	bool no_pinctrl = false;
 	struct clk *clk;
 	struct clk *base_clk = NULL;
 	int res;
 
 	match = of_match_node(sdhci_brcm_of_match, pdev->dev.of_node);
+	if (!match) {
+		dev_err(&pdev->dev, "fail to get matching of_match struct\n");
+		return -EINVAL;
+	}
 	match_priv = match->data;
 
 	dev_dbg(&pdev->dev, "Probe found match for %s\n",  match->compatible);
@@ -354,6 +468,19 @@ static int sdhci_brcmstb_probe(struct platform_device *pdev)
 	if (res)
 		goto err;
 
+	priv->pinctrl = devm_pinctrl_get(&pdev->dev);
+	if (IS_ERR(priv->pinctrl)) {
+			no_pinctrl = true;
+	}
+	priv->pins_default = pinctrl_lookup_state(priv->pinctrl, "default");
+	if (IS_ERR(priv->pins_default)) {
+			dev_dbg(&pdev->dev, "No pinctrl default state\n");
+			no_pinctrl = true;
+	}
+
+	if (no_pinctrl )
+		priv->pinctrl = NULL;
+
 	/*
 	 * Automatic clock gating does not work for SD cards that may
 	 * voltage switch so only enable it for non-removable devices.
@@ -370,6 +497,9 @@ static int sdhci_brcmstb_probe(struct platform_device *pdev)
 	    (host->mmc->caps2 & MMC_CAP2_HS400_ES))
 		host->mmc_host_ops.hs400_enhanced_strobe = match_priv->hs400es;
 
+	if(match_priv->cfginit)
+		match_priv->cfginit(host);
+
 	/*
 	 * Supply the existing CAPS, but clear the UHS modes. This
 	 * will allow these modes to be specified by device tree
-- 
2.35.3