[PATCH net-next v2 3/8] net: mv88e6xxx: use resolved link config in mac_link_up()

[Russell King <rmk+kernel@armlinux.org.uk>]

Use the resolved link configuration to set the MAC configuration when
mac_link_up() for non-internal-PHY ports.

Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
---
 drivers/net/dsa/mv88e6xxx/chip.c | 75 +++++++++++++++++++++++++-------
 1 file changed, 59 insertions(+), 16 deletions(-)

diff --git a/drivers/net/dsa/mv88e6xxx/chip.c b/drivers/net/dsa/mv88e6xxx/chip.c
index fef3b5e0b291..4a4173e63fa5 100644
--- a/drivers/net/dsa/mv88e6xxx/chip.c
+++ b/drivers/net/dsa/mv88e6xxx/chip.c
@@ -632,25 +632,30 @@ static void mv88e6xxx_mac_config(struct dsa_switch *ds, int port,
 		dev_err(ds->dev, "p%d: failed to configure MAC\n", port);
 }
 
-static void mv88e6xxx_mac_link_force(struct dsa_switch *ds, int port, int link)
+static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port,
+				    unsigned int mode,
+				    phy_interface_t interface)
 {
 	struct mv88e6xxx_chip *chip = ds->priv;
-	int err;
+	const struct mv88e6xxx_ops *ops;
+	int err = 0;
 
-	mv88e6xxx_reg_lock(chip);
-	err = chip->info->ops->port_set_link(chip, port, link);
-	mv88e6xxx_reg_unlock(chip);
+	ops = chip->info->ops;
 
-	if (err)
-		dev_err(chip->dev, "p%d: failed to force MAC link\n", port);
-}
+	/* Internal PHYs propagate their configuration directly to the MAC.
+	 * External PHYs depend on whether the PPU is enabled for this port.
+	 * FIXME: we should be using the PPU enable state here. What about
+	 * an automedia port?
+	 */
+	if (!mv88e6xxx_phy_is_internal(ds, port) && ops->port_set_link) {
+		mv88e6xxx_reg_lock(chip);
+		err = ops->port_set_link(chip, port, LINK_FORCED_DOWN);
+		mv88e6xxx_reg_unlock(chip);
 
-static void mv88e6xxx_mac_link_down(struct dsa_switch *ds, int port,
-				    unsigned int mode,
-				    phy_interface_t interface)
-{
-	if (mode == MLO_AN_FIXED)
-		mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_DOWN);
+		if (err)
+			dev_err(chip->dev,
+				"p%d: failed to force MAC link down\n", port);
+	}
 }
 
 static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port,
@@ -659,8 +664,46 @@ static void mv88e6xxx_mac_link_up(struct dsa_switch *ds, int port,
 				  int speed, int duplex,
 				  bool tx_pause, bool rx_pause)
 {
-	if (mode == MLO_AN_FIXED)
-		mv88e6xxx_mac_link_force(ds, port, LINK_FORCED_UP);
+	struct mv88e6xxx_chip *chip = ds->priv;
+	const struct mv88e6xxx_ops *ops;
+	int err = 0;
+
+	ops = chip->info->ops;
+
+	/* Internal PHYs propagate their configuration directly to the MAC.
+	 * External PHYs depend on whether the PPU is enabled for this port.
+	 * FIXME: we should be using the PPU enable state here. What about
+	 * an automedia port?
+	 */
+	if (!mv88e6xxx_phy_is_internal(ds, port)) {
+		mv88e6xxx_reg_lock(chip);
+		/* FIXME: for an automedia port, should we force the link
+		 * down here - what if the link comes up due to "other" media
+		 * while we're bringing the port up, how is the exclusivity
+		 * handled in the Marvell hardware? E.g. port 4 on 88E6532
+		 * shared between internal PHY and Serdes.
+		 */
+		if (ops->port_set_speed) {
+			err = ops->port_set_speed(chip, port, speed);
+			if (err && err != -EOPNOTSUPP)
+				goto error;
+		}
+
+		if (ops->port_set_duplex) {
+			err = ops->port_set_duplex(chip, port, duplex);
+			if (err && err != -EOPNOTSUPP)
+				goto error;
+		}
+
+		if (ops->port_set_link)
+			err = ops->port_set_link(chip, port, LINK_FORCED_UP);
+error:
+		mv88e6xxx_reg_unlock(chip);
+
+		if (err && err != -EOPNOTSUPP)
+			dev_err(ds->dev,
+				"p%d: failed to configure MAC link up\n", port);
+	}
 }
 
 static int mv88e6xxx_stats_snapshot(struct mv88e6xxx_chip *chip, int port)
-- 
2.20.1