All of lore.kernel.org
 help / color / mirror / Atom feed
From: shengjiu.wang@nxp.com
To: timur@kernel.org, nicoleotsuka@gmail.com, Xiubo.Lee@gmail.com,
	festevam@gmail.com, broonie@kernel.org,
	alsa-devel@alsa-project.org
Cc: linuxppc-dev@lists.ozlabs.org, linux-kernel@vger.kernel.org
Subject: [PATCH V2 2/2] ASoC: fsl_esai: recover the channel swap after xrun
Date: Wed,  3 Jul 2019 14:42:05 +0800	[thread overview]
Message-ID: <c29639336b6b32fa781bdddad30287f8b76d5e0b.1562136119.git.shengjiu.wang@nxp.com> (raw)
In-Reply-To: <cover.1562136119.git.shengjiu.wang@nxp.com>
In-Reply-To: <cover.1562136119.git.shengjiu.wang@nxp.com>

From: Shengjiu Wang <shengjiu.wang@nxp.com>

There is chip errata ERR008000, the reference doc is
(https://www.nxp.com/docs/en/errata/IMX6DQCE.pdf),

The issue is "While using ESAI transmit or receive and
an underrun/overrun happens, channel swap may occur.
The only recovery mechanism is to reset the ESAI."

This issue exist in imx3/imx5/imx6(partial) series.

In this commit add a tasklet to handle reset of ESAI
after xrun happens to recover the channel swap.

Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
---
 sound/soc/fsl/fsl_esai.c | 76 ++++++++++++++++++++++++++++++++++++++++
 1 file changed, 76 insertions(+)

diff --git a/sound/soc/fsl/fsl_esai.c b/sound/soc/fsl/fsl_esai.c
index 20039ae9893b..8c92e49ad6d8 100644
--- a/sound/soc/fsl/fsl_esai.c
+++ b/sound/soc/fsl/fsl_esai.c
@@ -32,6 +32,7 @@
  * @extalclk: esai clock source to derive HCK, SCK and FS
  * @fsysclk: system clock source to derive HCK, SCK and FS
  * @spbaclk: SPBA clock (optional, depending on SoC design)
+ * @task: tasklet to handle the reset operation
  * @fifo_depth: depth of tx/rx FIFO
  * @slot_width: width of each DAI slot
  * @slots: number of slots
@@ -42,6 +43,7 @@
  * @sck_div: if using PSR/PM dividers for SCKx clock
  * @slave_mode: if fully using DAI slave mode
  * @synchronous: if using tx/rx synchronous mode
+ * @reset_at_xrun: flags for enable reset operaton
  * @name: driver name
  */
 struct fsl_esai {
@@ -53,6 +55,7 @@ struct fsl_esai {
 	struct clk *extalclk;
 	struct clk *fsysclk;
 	struct clk *spbaclk;
+	struct tasklet_struct task;
 	u32 fifo_depth;
 	u32 slot_width;
 	u32 slots;
@@ -65,6 +68,7 @@ struct fsl_esai {
 	bool sck_div[2];
 	bool slave_mode;
 	bool synchronous;
+	bool reset_at_xrun;
 	char name[32];
 };
 
@@ -73,8 +77,16 @@ static irqreturn_t esai_isr(int irq, void *devid)
 	struct fsl_esai *esai_priv = (struct fsl_esai *)devid;
 	struct platform_device *pdev = esai_priv->pdev;
 	u32 esr;
+	u32 saisr;
 
 	regmap_read(esai_priv->regmap, REG_ESAI_ESR, &esr);
+	regmap_read(esai_priv->regmap, REG_ESAI_SAISR, &saisr);
+
+	if ((saisr & (ESAI_SAISR_TUE | ESAI_SAISR_ROE)) &&
+	    esai_priv->reset_at_xrun) {
+		dev_dbg(&pdev->dev, "reset module for xrun\n");
+		tasklet_schedule(&esai_priv->task);
+	}
 
 	if (esr & ESAI_ESR_TINIT_MASK)
 		dev_dbg(&pdev->dev, "isr: Transmission Initialized\n");
@@ -634,10 +646,17 @@ static void fsl_esai_trigger_start(struct fsl_esai *esai_priv, bool tx)
 			   ESAI_xSMB_xS_MASK, ESAI_xSMB_xS(mask));
 	regmap_update_bits(esai_priv->regmap, REG_ESAI_xSMA(tx),
 			   ESAI_xSMA_xS_MASK, ESAI_xSMA_xS(mask));
+
+	/* Enable Exception interrupt */
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_xCR(tx),
+			   ESAI_xCR_xEIE_MASK, ESAI_xCR_xEIE);
 }
 
 static void fsl_esai_trigger_stop(struct fsl_esai *esai_priv, bool tx)
 {
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_xCR(tx),
+			   ESAI_xCR_xEIE_MASK, 0);
+
 	regmap_update_bits(esai_priv->regmap, REG_ESAI_xCR(tx),
 			   tx ? ESAI_xCR_TE_MASK : ESAI_xCR_RE_MASK, 0);
 	regmap_update_bits(esai_priv->regmap, REG_ESAI_xSMA(tx),
@@ -652,6 +671,53 @@ static void fsl_esai_trigger_stop(struct fsl_esai *esai_priv, bool tx)
 			   ESAI_xFCR_xFR, 0);
 }
 
+static void fsl_esai_reset(unsigned long arg)
+{
+	struct fsl_esai *esai_priv = (struct fsl_esai *)arg;
+	u32 saisr, tfcr, rfcr;
+
+	/* save the registers */
+	regmap_read(esai_priv->regmap, REG_ESAI_TFCR, &tfcr);
+	regmap_read(esai_priv->regmap, REG_ESAI_RFCR, &rfcr);
+
+	/* stop the tx & rx */
+	fsl_esai_trigger_stop(esai_priv, 1);
+	fsl_esai_trigger_stop(esai_priv, 0);
+
+	/* reset the esai, and restore the registers */
+	fsl_esai_init(esai_priv);
+
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_TCR,
+			   ESAI_xCR_xPR_MASK,
+			   ESAI_xCR_xPR);
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_RCR,
+			   ESAI_xCR_xPR_MASK,
+			   ESAI_xCR_xPR);
+
+	/* restore registers by regcache_sync */
+	fsl_esai_register_restore(esai_priv);
+
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_TCR,
+			   ESAI_xCR_xPR_MASK, 0);
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_RCR,
+			   ESAI_xCR_xPR_MASK, 0);
+
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_PRRC,
+			   ESAI_PRRC_PDC_MASK,
+			   ESAI_PRRC_PDC(ESAI_GPIO));
+	regmap_update_bits(esai_priv->regmap, REG_ESAI_PCRC,
+			   ESAI_PCRC_PC_MASK,
+			   ESAI_PCRC_PC(ESAI_GPIO));
+
+	regmap_read(esai_priv->regmap, REG_ESAI_SAISR, &saisr);
+
+	/* restart tx / rx, if they already enabled */
+	if (tfcr & ESAI_xFCR_xFEN)
+		fsl_esai_trigger_start(esai_priv, 1);
+	if (rfcr & ESAI_xFCR_xFEN)
+		fsl_esai_trigger_start(esai_priv, 0);
+}
+
 static int fsl_esai_trigger(struct snd_pcm_substream *substream, int cmd,
 			    struct snd_soc_dai *dai)
 {
@@ -856,6 +922,10 @@ static int fsl_esai_probe(struct platform_device *pdev)
 	esai_priv->pdev = pdev;
 	snprintf(esai_priv->name, sizeof(esai_priv->name), "%pOFn", np);
 
+	if (of_device_is_compatible(np, "fsl,vf610-esai") ||
+	    of_device_is_compatible(np, "fsl,imx35-esai"))
+		esai_priv->reset_at_xrun = true;
+
 	/* Get the addresses and IRQ */
 	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 	regs = devm_ioremap_resource(&pdev->dev, res);
@@ -955,6 +1025,9 @@ static int fsl_esai_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	tasklet_init(&esai_priv->task, fsl_esai_reset,
+		     (unsigned long)esai_priv);
+
 	pm_runtime_enable(&pdev->dev);
 
 	regcache_cache_only(esai_priv->regmap, true);
@@ -968,7 +1041,10 @@ static int fsl_esai_probe(struct platform_device *pdev)
 
 static int fsl_esai_remove(struct platform_device *pdev)
 {
+	struct fsl_esai *esai_priv = platform_get_drvdata(pdev);
+
 	pm_runtime_disable(&pdev->dev);
+	tasklet_kill(&esai_priv->task);
 
 	return 0;
 }
-- 
2.21.0


  parent reply	other threads:[~2019-07-03  6:51 UTC|newest]

Thread overview: 15+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-07-03  6:42 [PATCH V2 0/2] recover the channel swap after xrun shengjiu.wang
2019-07-03  6:42 ` [PATCH V2 1/2] ASoC: fsl_esai: Wrap some operations to be functions shengjiu.wang
2019-07-03  9:10   ` Nicolin Chen
2019-07-03  9:10     ` Nicolin Chen
2019-07-03  6:42 ` shengjiu.wang [this message]
2019-07-03  9:32   ` [PATCH V2 2/2] ASoC: fsl_esai: recover the channel swap after xrun Nicolin Chen
2019-07-03  9:32     ` Nicolin Chen
2019-07-03 20:56   ` Cezary Rojewski
2019-07-03 20:56     ` Cezary Rojewski
2019-07-05  7:03 S.j. Wang
2019-07-05  7:03 ` S.j. Wang
2019-07-09  0:58 ` Nicolin Chen
2019-07-09  0:58   ` Nicolin Chen
2019-07-09  3:38 S.j. Wang
2019-07-09  3:38 ` S.j. Wang

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=c29639336b6b32fa781bdddad30287f8b76d5e0b.1562136119.git.shengjiu.wang@nxp.com \
    --to=shengjiu.wang@nxp.com \
    --cc=Xiubo.Lee@gmail.com \
    --cc=alsa-devel@alsa-project.org \
    --cc=broonie@kernel.org \
    --cc=festevam@gmail.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linuxppc-dev@lists.ozlabs.org \
    --cc=nicoleotsuka@gmail.com \
    --cc=timur@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.