[PATCH v7 4/8] drivers: thermal: tsens: Release device in success path

[Amit Kucheria <amit.kucheria@linaro.org>]

We don't currently call put_device in case of successfully initialising
the device. So we hold the reference and keep the device pinned forever.

Allow control to fall through so we can use same code for success and
error paths to put_device.

As a part of this fixup, change devm_ioremap_resource to act on the same
device pointer as that used to allocate regmap memory. That ensures that
we are free to release op->dev after examining its resources.

Signed-off-by: Amit Kucheria <amit.kucheria@linaro.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
---
 drivers/thermal/qcom/tsens-common.c | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c
index f044788681c48..fd3b56d523411 100644
--- a/drivers/thermal/qcom/tsens-common.c
+++ b/drivers/thermal/qcom/tsens-common.c
@@ -603,7 +603,7 @@ int __init init_common(struct tsens_priv *priv)
 		/* DT with separate SROT and TM address space */
 		priv->tm_offset = 0;
 		res = platform_get_resource(op, IORESOURCE_MEM, 1);
-		srot_base = devm_ioremap_resource(&op->dev, res);
+		srot_base = devm_ioremap_resource(dev, res);
 		if (IS_ERR(srot_base)) {
 			ret = PTR_ERR(srot_base);
 			goto err_put_device;
@@ -621,7 +621,7 @@ int __init init_common(struct tsens_priv *priv)
 	}
 
 	res = platform_get_resource(op, IORESOURCE_MEM, 0);
-	tm_base = devm_ioremap_resource(&op->dev, res);
+	tm_base = devm_ioremap_resource(dev, res);
 	if (IS_ERR(tm_base)) {
 		ret = PTR_ERR(tm_base);
 		goto err_put_device;
@@ -688,8 +688,6 @@ int __init init_common(struct tsens_priv *priv)
 	tsens_enable_irq(priv);
 	tsens_debug_init(op);
 
-	return 0;
-
 err_put_device:
 	put_device(&op->dev);
 	return ret;
-- 
2.20.1