Re: [PATCH AUTOSEL 4.19 32/73] ARM: dts: imx6sx-sdb: Fix enet phy regulator

[Sasha Levin <sashal@kernel.org>]

On Thu, Nov 15, 2018 at 10:39:44AM +0000, Leonard Crestez wrote:
>On Wed, 2018-11-14 at 17:21 -0500, Sasha Levin wrote:
>> From: Leonard Crestez <leonard.crestez@nxp.com>
>>
>> [ Upstream commit 1ad9fb750a104f51851c092edd7b3553f0218428 ]
>>
>> Bindings for "fixed-regulator" only explicitly support "gpio" property,
>> not "gpios". Fix by correcting the property name.
>>
>> The enet PHYs on imx6sx-sdb needs to be explicitly reset after a power
>> cycle, this can be handled by the phy-reset-gpios property. Sadly this
>> is not handled on suspend: the fec driver turns phy-supply off but
>> doesn't assert phy-reset-gpios again on resume.
>>
>> Since additional phy-level work is required to support powering off the
>> phy in suspend fix the problem by just marking the regulator as
>> "boot-on" "always-on" so that it's never turned off. This behavior is
>> equivalent to older releases.
>>
>> Keep the phy-reset-gpios property on fec anyway because it is a correct
>> description of board design.
>>
>> This issue was exposed by commit efdfeb079cc3 ("regulator: fixed:
>> Convert to use GPIO descriptor only") which causes the "gpios" property
>> to also be parsed. Before that commit the "gpios" property had no
>> effect, PHY reset was only handled in the the bootloader.
>>
>> Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com>
>> Signed-off-by: Shawn Guo <shawnguo@kernel.org>
>
>This is something of a workaround for gpio core changes in 4.20 and
>there is no need for it in older releases.
>
>I don't think you should backport this.

Dropped, thank you.

Thanks,
Sasha