* Wireguard speed
@ 2021-04-16 7:49 Роман Строганов
0 siblings, 0 replies; only message in thread
From: Роман Строганов @ 2021-04-16 7:49 UTC (permalink / raw)
Help with speed in the wireguard vpn.
There are 2 routers linksys with openwrt 19.07.7. And the wireguard
tunnel between them.
If the link between the Wan of both routers is 1 gigabit/s, then the
speed inside the tunnel is 300-370 Mb/s, which I think is good. I
understand that these are simple routers, not servers.
This is done for the test.
In real life, the speed between the feasts will be limited to 100 Mb/s.
I decided to do a test and lowered the speed on the switch ports
(routers connected through a gigabit switch) to 100 Mb/s. After that,
the speed between routers through wg is 30-40 Mb/s. Processors on
routers are loaded at 25-25%. Once I am on a channel in 100 Mb/s.
received speeds between routers 85-90 Mb/s. So such speeds are possible
on the wireguard.
After that, something went wrong with the electricity and the routers
were rebooted. I didn't have time to save the settings.
From memory, I set everything up again, but now I can't achieve high
I measure iperf3 installed on the routers themselves.
How can I get ~ 80-90 Mb/s again via 100 Mb/s channel?
I will be grateful for any help in setting the speed wireguard
p.s Forgive my English. I do not know him well and use a translator
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2021-04-17 0:10 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-04-16 7:49 Wireguard speed Роман Строганов
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).