xen-devel.lists.xenproject.org archive mirror
 help / color / mirror / Atom feed
From: Julien Grall <julien@xen.org>
To: Stefano Stabellini <sstabellini@kernel.org>
Cc: Bertrand Marquis <Bertrand.Marquis@arm.com>,
	"xen-devel@lists.xenproject.org" <xen-devel@lists.xenproject.org>,
	Julien Grall <jgrall@amazon.com>,
	Volodymyr Babchuk <Volodymyr_Babchuk@epam.com>
Subject: Re: [PATCH for-next] xen/arm: mm: flush_page_to_ram() only need to clean to PoC
Date: Mon, 22 Feb 2021 20:50:51 +0000	[thread overview]
Message-ID: <ec608001-7663-961b-667c-bcf6397f1864@xen.org> (raw)
In-Reply-To: <alpine.DEB.2.21.2102221220000.3234@sstabellini-ThinkPad-T480s>



On 22/02/2021 20:35, Stefano Stabellini wrote:
> On Mon, 22 Feb 2021, Julien Grall wrote:
>> On 22/02/2021 11:58, Bertrand Marquis wrote:
>>> Hi Julien,
>>>
>>>> On 20 Feb 2021, at 17:54, Julien Grall <julien@xen.org> wrote:
>>>>
>>>> From: Julien Grall <jgrall@amazon.com>
>>>>
>>>> At the moment, flush_page_to_ram() is both cleaning and invalidate to
>>>> PoC the page. However, the cache line can be speculated and pull in the
>>>> cache right after as it is part of the direct map.
>>>
>>> If we go further through this logic maybe all calls to
>>> clean_and_invalidate_dcache_va_range could be transformed in a
>>> clean_dcache_va_range.
>>
>> Likely yes. But I need to go through them one by one to confirm this is fine
>> to do it (it also depends on the caching attributes used). I have sent this
>> one in advance because this was discussed as part of XSA-364.
>>
>>>
>>>>
>>>> So it is pointless to try to invalidate the line in the data cache.
>>>>
>>>
>>> But what about processors which would not speculate ?
>>>
>>> Do you expect any performance optimization here ?
>>
>> When invalidating a line, you effectively remove it from the cache. If the
>> page is going to be access a bit after, then you will have to load from the
>> memory (or another cache).
>>
>> With this change, you would only need to re-fetch the line if it wasn't
>> evicted by the time it is accessed.
>>
>> The line would be clean, so I would expect the eviction to have less an impact
>> over re-fetching the memory.
>>
>>>
>>> If so it might be good to explain it as I am not quite sure I get it.
>>
>> This change is less about performance and more about unnecessary work.
>>
>> The processor is likely going to be more clever than the developper and the
>> exact numbers will vary depending on how the processor decide to manage the
>> cache.
>>
>> In general, we should avoid interferring too much with the cache without a
>> good reason to do it.
>>
>> How about the following commit message:
>>
>> "
>> At the moment, flush_page_to_ram() is both cleaning and invalidate to
>> PoC the page.
>>
>> The goal of flush_page_to_ram() is to prevent corruption when the guest has
>> disabled the cache (the cache line may be dirty) and read the guest to read
>> previous content.
>>
>> Per this defintion, the invalidating the line is not necessary. So
>> invalidating the cache is unnecessary. In fact, it may be counter-productive
>> as the line may be (speculatively) accessed a bit after. So this will incurr
>> an expensive access to the memory.
>>
>> More generally, we should avoid interferring too much with cache. Therefore,
>> flush_page_to_ram() is updated to only clean to PoC the page.
>>
>> The performance impact of this change will depend on your workload/processor.
>> "
>   
>  From a correctness and functionality perspective, we don't need the
> invalidate. If the line is dirty we are writing it back to memory (point
> of coherence) thanks to the clean operations anyway. If somebody writes
> to that location, the processor should evict the old line anyway.

Location as in same physical address or the same set?

For the former, the line is usually bigger than any write. So it is 
unlikely to get evicted.

For the later, it will depend on the content of the other ways in the set.

> The only reason I can think of for doing a "clean and invalidate" rather
> than just a "clean" would be that we are trying to give a hint to the
> processor that the cacheline is soon to be evicted. Assuming that the
> hint even leads to some sort of performance optimization.

This may change which lines get evict as there will be an unused way. 
But we are now down to the territory of micro-optimization.

If that's a problem for someone, then that user should better switch to 
cache coloring because the impact of flush_page_to_ram() will pretty 
small compare to the damage that another domain can do if it shares the 
same set.

> In any case, on the grounds that it is unnecessary, I am OK with this.
> I agree with Julien's proposal of applying this patch "for-next".
> 
> Acked-by: Stefano Stabellini <sstabellini@kernel.org>

Thanks! I am thinking to create a branch next again for queuing 4.15+ 
patches. Would that be fine with you?

Cheers,

-- 
Julien Grall


  reply	other threads:[~2021-02-22 20:51 UTC|newest]

Thread overview: 8+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-02-20 17:54 [PATCH for-next] xen/arm: mm: flush_page_to_ram() only need to clean to PoC Julien Grall
2021-02-22 11:58 ` Bertrand Marquis
2021-02-22 13:37   ` Julien Grall
2021-02-22 13:48     ` Bertrand Marquis
2021-02-22 20:35     ` Stefano Stabellini
2021-02-22 20:50       ` Julien Grall [this message]
2021-02-23  1:22         ` Stefano Stabellini
2021-03-03 18:33           ` Julien Grall

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=ec608001-7663-961b-667c-bcf6397f1864@xen.org \
    --to=julien@xen.org \
    --cc=Bertrand.Marquis@arm.com \
    --cc=Volodymyr_Babchuk@epam.com \
    --cc=jgrall@amazon.com \
    --cc=sstabellini@kernel.org \
    --cc=xen-devel@lists.xenproject.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).