Re: [PATCH net-next v1] net: phy: tja11xx: add cable-test support

[Oleksij Rempel <o.rempel@pengutronix.de>]

[-- Attachment #1: Type: text/plain, Size: 1678 bytes --]

On Wed, May 13, 2020 at 08:01:40PM +0200, Andrew Lunn wrote:
> > What would be the best place to do a test before the link is getting up?
> > Can it be done in the phy core, or it should be done in the PHY driver?
> > 
> > So far, no action except of logging these errors is needed. 
> 
> You could do it in the config_aneg callback.

In this case I get two test cycles if the test was requested from user
space: from .cable_test_get_status and from .config_aneg

> A kernel log entry is not very easy to use. You might want to see how
> easy it is to send a cable test result to userspace. Anything which is
> interested in this information can then listen for it. All the needed
> code is there, you will just need to rearrange it a bit.

Indeed. I discovered" ethtool --monitor" for me. And the code is some
thing like this:
	ethnl_cable_test_alloc(phydev);
	phydev->drv->cable_test_start(phydev);
	usleep_range(100, 200);
	phydev->drv->cable_test_get_status(phydev, &finished);
	if (finished)
		ethnl_cable_test_finished(phydev);


Beside, what do you think about new result codes:
  ETHTOOL_A_CABLE_RESULT_CODE_POLARITY - if cable polarity is wrong (-
  connected to +)
  ETHTOOL_A_CABLE_RESULT_CODE_ACTIVE_PARTNER - the link partner is active.
     The TJA1102 is able to detect it if partner link is master.

Regards,
Oleksij

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 833 bytes --]