* how to pick good data when mismatch_count shows failure
@ 2010-06-14 14:31 Richard Ray
0 siblings, 0 replies; only message in thread
From: Richard Ray @ 2010-06-14 14:31 UTC (permalink / raw)
To: linux-raid
From /etc/sysconfig/raid-check
This allows the sysadmin to inspect the data in the sector
and the data that would be produced by rebuilding the
sector from redundant information and pick the correct
data to keep.
In the case that mismatch_count is not 0 how would I go about 'picking'
the correct data. If possible please point me to documentation and/or
tools
Using CentOS 5.5 and ext3 fs
Thanks
Richard
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2010-06-14 14:31 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2010-06-14 14:31 how to pick good data when mismatch_count shows failure Richard Ray
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.