[RESEND PATCH V3 2/5] arm64: dts: qcom: pm8350c: Add temp-alarm support

[satya priya <skakit@codeaurora.org>]

Add temp-alarm node for PM8350C pmic and also modify gpio
node to add gpio ranges and "qcom,spmi-gpio" compatible.

Signed-off-by: satya priya <skakit@codeaurora.org>
---
 arch/arm64/boot/dts/qcom/pm8350c.dtsi | 32 +++++++++++++++++++++++++++++++-
 1 file changed, 31 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
index 2b9b75e..e1b75ae 100644
--- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -13,13 +13,43 @@
 		#address-cells = <1>;
 		#size-cells = <0>;
 
+		pm8350c_temp_alarm: temp-alarm@a00 {
+			compatible = "qcom,spmi-temp-alarm";
+			reg = <0xa00>;
+			interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+			#thermal-sensor-cells = <0>;
+		};
+
 		pm8350c_gpios: gpio@8800 {
-			compatible = "qcom,pm8350c-gpio";
+			compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
 			reg = <0x8800>;
 			gpio-controller;
+			gpio-ranges = <&pm8350c_gpios 0 0 9>;
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
 		};
 	};
 };
+
+&thermal_zones {
+	pm8350c_thermal: pm8350c-thermal {
+		polling-delay-passive = <100>;
+		polling-delay = <0>;
+		thermal-sensors = <&pm8350c_temp_alarm>;
+
+		trips {
+			pm8350c_trip0: trip0 {
+				temperature = <95000>;
+				hysteresis = <0>;
+				type = "passive";
+			};
+
+			pm8350c_crit: pm8350c-crit {
+				temperature = <115000>;
+				hysteresis = <0>;
+				type = "critical";
+			};
+		};
+	};
+};
-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member 
of Code Aurora Forum, hosted by The Linux Foundation