* [PATCH] ARM: dts: imx7: Unify temp-grade and speed-grade nodes
@ 2019-12-12 13:38 Fabio Estevam
2019-12-23 6:27 ` Shawn Guo
0 siblings, 1 reply; 2+ messages in thread
From: Fabio Estevam @ 2019-12-12 13:38 UTC (permalink / raw)
To: shawnguo
Cc: robh+dt, kernel, linux-imx, linux-arm-kernel, devicetree, Fabio Estevam
The following warning is seen when building with W=1:
arch/arm/boot/dts/imx7s.dtsi:551.39-553.7: Warning (unique_unit_address): /soc/aips-bus@30000000/ocotp-ctrl@30350000/temp-grade@10: duplicate unit-address (also used in node /soc/aips-bus@30000000/ocotp-ctrl@30350000/speed-grade@10)
Since temp-grade and speed-grade point to the same node, replace them by
a single one to avoid the duplicate unit-address warning.
Signed-off-by: Fabio Estevam <festevam@gmail.com>
---
arch/arm/boot/dts/imx7d.dtsi | 2 +-
arch/arm/boot/dts/imx7s.dtsi | 9 ++-------
2 files changed, 3 insertions(+), 8 deletions(-)
diff --git a/arch/arm/boot/dts/imx7d.dtsi b/arch/arm/boot/dts/imx7d.dtsi
index d8acd7cc7918..92f6d0c2a74f 100644
--- a/arch/arm/boot/dts/imx7d.dtsi
+++ b/arch/arm/boot/dts/imx7d.dtsi
@@ -12,7 +12,7 @@
clock-frequency = <996000000>;
operating-points-v2 = <&cpu0_opp_table>;
#cooling-cells = <2>;
- nvmem-cells = <&cpu_speed_grade>;
+ nvmem-cells = <&fuse_grade>;
nvmem-cell-names = "speed_grade";
};
diff --git a/arch/arm/boot/dts/imx7s.dtsi b/arch/arm/boot/dts/imx7s.dtsi
index 1b812f4e7453..05d099da5a02 100644
--- a/arch/arm/boot/dts/imx7s.dtsi
+++ b/arch/arm/boot/dts/imx7s.dtsi
@@ -152,8 +152,7 @@
interrupt-parent = <&gpc>;
interrupts = <GIC_SPI 49 IRQ_TYPE_LEVEL_HIGH>;
fsl,tempmon = <&anatop>;
- nvmem-cells = <&tempmon_calib>,
- <&tempmon_temp_grade>;
+ nvmem-cells = <&tempmon_calib>, <&fuse_grade>;
nvmem-cell-names = "calib", "temp_grade";
clocks = <&clks IMX7D_PLL_SYS_MAIN_CLK>;
};
@@ -548,11 +547,7 @@
reg = <0x3c 0x4>;
};
- tempmon_temp_grade: temp-grade@10 {
- reg = <0x10 0x4>;
- };
-
- cpu_speed_grade: speed-grade@10 {
+ fuse_grade: temp-grade@10 {
reg = <0x10 0x4>;
};
};
--
2.17.1
^ permalink raw reply related [flat|nested] 2+ messages in thread
* Re: [PATCH] ARM: dts: imx7: Unify temp-grade and speed-grade nodes
2019-12-12 13:38 [PATCH] ARM: dts: imx7: Unify temp-grade and speed-grade nodes Fabio Estevam
@ 2019-12-23 6:27 ` Shawn Guo
0 siblings, 0 replies; 2+ messages in thread
From: Shawn Guo @ 2019-12-23 6:27 UTC (permalink / raw)
To: Fabio Estevam; +Cc: robh+dt, kernel, linux-imx, linux-arm-kernel, devicetree
On Thu, Dec 12, 2019 at 10:38:00AM -0300, Fabio Estevam wrote:
> The following warning is seen when building with W=1:
>
> arch/arm/boot/dts/imx7s.dtsi:551.39-553.7: Warning (unique_unit_address): /soc/aips-bus@30000000/ocotp-ctrl@30350000/temp-grade@10: duplicate unit-address (also used in node /soc/aips-bus@30000000/ocotp-ctrl@30350000/speed-grade@10)
>
> Since temp-grade and speed-grade point to the same node, replace them by
> a single one to avoid the duplicate unit-address warning.
>
> Signed-off-by: Fabio Estevam <festevam@gmail.com>
> ---
> arch/arm/boot/dts/imx7d.dtsi | 2 +-
> arch/arm/boot/dts/imx7s.dtsi | 9 ++-------
> 2 files changed, 3 insertions(+), 8 deletions(-)
>
> diff --git a/arch/arm/boot/dts/imx7d.dtsi b/arch/arm/boot/dts/imx7d.dtsi
> index d8acd7cc7918..92f6d0c2a74f 100644
> --- a/arch/arm/boot/dts/imx7d.dtsi
> +++ b/arch/arm/boot/dts/imx7d.dtsi
> @@ -12,7 +12,7 @@
> clock-frequency = <996000000>;
> operating-points-v2 = <&cpu0_opp_table>;
> #cooling-cells = <2>;
> - nvmem-cells = <&cpu_speed_grade>;
> + nvmem-cells = <&fuse_grade>;
> nvmem-cell-names = "speed_grade";
> };
>
> diff --git a/arch/arm/boot/dts/imx7s.dtsi b/arch/arm/boot/dts/imx7s.dtsi
> index 1b812f4e7453..05d099da5a02 100644
> --- a/arch/arm/boot/dts/imx7s.dtsi
> +++ b/arch/arm/boot/dts/imx7s.dtsi
> @@ -152,8 +152,7 @@
> interrupt-parent = <&gpc>;
> interrupts = <GIC_SPI 49 IRQ_TYPE_LEVEL_HIGH>;
> fsl,tempmon = <&anatop>;
> - nvmem-cells = <&tempmon_calib>,
> - <&tempmon_temp_grade>;
> + nvmem-cells = <&tempmon_calib>, <&fuse_grade>;
> nvmem-cell-names = "calib", "temp_grade";
> clocks = <&clks IMX7D_PLL_SYS_MAIN_CLK>;
> };
> @@ -548,11 +547,7 @@
> reg = <0x3c 0x4>;
> };
>
> - tempmon_temp_grade: temp-grade@10 {
> - reg = <0x10 0x4>;
> - };
> -
> - cpu_speed_grade: speed-grade@10 {
> + fuse_grade: temp-grade@10 {
Rename the node to fuse-grade too?
Shawn
> reg = <0x10 0x4>;
> };
> };
> --
> 2.17.1
>
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2019-12-23 6:28 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2019-12-12 13:38 [PATCH] ARM: dts: imx7: Unify temp-grade and speed-grade nodes Fabio Estevam
2019-12-23 6:27 ` Shawn Guo
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).