Re: [PATCH v2] hwmon: Driver for temperature sensors on SATA drives

[Linus Walleij <linus.walleij@linaro.org>]

On Sun, Jan 12, 2020 at 1:03 PM Gabriel C <nix.or.die@gmail.com> wrote:
> Am So., 12. Jan. 2020 um 12:22 Uhr schrieb Linus Walleij
> <linus.walleij@linaro.org>:
> >
> > On Sun, Jan 12, 2020 at 12:18 PM Gabriel C <nix.or.die@gmail.com> wrote:
> >
> > > What I've noticed however is the nvme temperature low/high values on
> > > the Sensors X are strange here.
> > (...)
> > > Sensor 1:     +27.9°C  (low  = -273.1°C, high = +65261.8°C)
> > > Sensor 2:     +29.9°C  (low  = -273.1°C, high = +65261.8°C)
> > (...)
> > > Sensor 1:     +23.9°C  (low  = -273.1°C, high = +65261.8°C)
> > > Sensor 2:     +25.9°C  (low  = -273.1°C, high = +65261.8°C)
> >
> > That doesn't look strange to me. It seems like reasonable defaults
> > from the firmware if either it doesn't really log the min/max temperatures
> > or hasn't been through a cycle of updating these yet. Just set both
> > to absolute min/max temperatures possible.
>
> Ok I'll check that.
>
> Do you mean by setting the temperatures to use a lmsensors config?
> Or is there a way to set these with a nvme command?

Not that I know of.

The min/max are the minumum and maximum temperatures the
device has experienced during this power-on cycle.

(If I understood things right!)

If the device firmware doesn't log that, or the firmware hasn't
ran through a log point, it makes sense to report absolute
min/max of the scales.

Yours,
Linus Walleij