Re: Re: [PATCH v3 0/2] Add Zawrs support and use it for spinlocks

[Andrew Jones <ajones@ventanamicro.com>]

On Fri, Oct 20, 2023 at 12:19:38PM +0200, Andrea Parri wrote:
> (Removing Heiko's @vrull address from Cc:, since it seemed to bounce, keeping
>  his @sntech address.)
> 
> > I had a quick look at your changes, and they look good to me.
> 
> Great.  Thank you for looking them over.
> 
> > Did you agree with Palmer about testing requirements?
> > I.e., do we need to run this on hardware that implements Zawrs in a
> > non-trivial way?
> 
> I didn't quite discuss such specific requirements or hardware implementations,
> but I agree that's a valid concern.  Not that I currently have access to such
> hardware; any further inputs/data will be appreciated.
> 
> > I can try to raise the priority on this here, but can't promise anything.
> > For me it is also ok if you take over this patchset.
> 
> Thanks.  Either way works for me.  No urgency from my side.  I'd say - let us
> leave this up to the community/other reviewers.  (IIUC, Palmer was recovering
> from a certain flu and might need more time than usual to get back here.)
>

Hi everyone,

I'm also interested in seeing this series resurrected and making progress
again. I'd be happy to help out in any way. It's not clear to me if it has
a current owner. If not, then I could start shepherding the patches with
their authorships intact.

I may be able to do some testing on an FPGA too.

Thanks,
drew

_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv