RE: [v3 2/2] dsa: mv88e6xxx: make serdes SGMII/Fiber output amplitude configurable

[Holger Brunck <holger.brunck@hitachienergy.com>]

Hi Marek,

> >
> > > > This gets interesting when PCIe and USB needs to use this
> > > > property, what names are used, and if it is possible to combine
> > > > two different lists?
> > >
> > > I don't think it is possible, I tried that once and couldn't get it to work.
> > >
> > > I am going to try write the proposal. But unfortunately PHY binding
> > > is not converted to YAML yet :(
> > >
> >
> > I saw you recent patches to convert this. Thanks!
> >
> > This make my serdes.yaml obsolete then, correct? Should I then only
> > re-post my driver code, once your patches are accepted?
> 
> Yes, please let's do it this way. It may take some time for Rob to review this,
> though, and he may require some changes.
> 

I saw your v3 patch for the bindings and I would adapt then my patch
accordingly to tx-p2p-microvolt. 

> Also I was thinking whether it wouldn't be better to put the property into a
> separate SerDes PHY node, i.e.
> 
>   switch {
>     compatible = "marvell,mv88e6085";
>     ...
> 
>     ports {
>       port@6 {
>         reg = <0x6>;
>         phy-handle = <&switch_serdes_phy>;
>       };
> 
>       ...
>     };
> 
>     mdio {
>       switch_serdes_phy: ethernet-phy@f {
>         reg = <0xf>;
>         tx-amplitude-microvolt = <1234567>;
>       };
> 
>       ...
>     };
>   };

this would mean in regard to my patch instead of checking directly for the
property in mv88e6xxx_setup_port  I would parse for the phy-handle first
and then for the property? 

Should I wait until your patch is accepted and merged?

Best regards
Holger