From: Andre Przywara <andre.przywara@arm.com> To: Vasily Khoruzhick <anarsoul@gmail.com>, Yangtao Li <tiny.windzz@gmail.com>, Chen-Yu Tsai <wens@csie.org>, Jernej Skrabec <jernej.skrabec@gmail.com>, Samuel Holland <samuel@sholland.org> Cc: "Rafael J . Wysocki" <rafael@kernel.org>, Daniel Lezcano <daniel.lezcano@linaro.org>, Zhang Rui <rui.zhang@intel.com>, Lukasz Luba <lukasz.luba@arm.com>, Rob Herring <robh+dt@kernel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>, Conor Dooley <conor+dt@kernel.org>, Martin Botka <martin.botka@somainline.org>, Maksim Kiselev <bigunclemax@gmail.com>, Bob McChesney <bob@electricworry.net>, linux-pm@vger.kernel.org, devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-sunxi@lists.linux.dev Subject: [PATCH v4 6/7] thermal: sun8i: add support for H616 THS controller Date: Fri, 9 Feb 2024 14:42:20 +0000 [thread overview] Message-ID: <20240209144221.3602382-7-andre.przywara@arm.com> (raw) In-Reply-To: <20240209144221.3602382-1-andre.przywara@arm.com> From: Martin Botka <martin.botka@somainline.org> Add support for the thermal sensor found in H616 SoCs, is the same as the H6 thermal sensor controller, but with four sensors. Also the registers readings are wrong, unless a bit in the first SYS_CFG register cleared, so set exercise the SRAM regmap to take care of that. Signed-off-by: Martin Botka <martin.botka@somainline.org> Signed-off-by: Andre Przywara <andre.przywara@arm.com> --- drivers/thermal/sun8i_thermal.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+) diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c index 8a9d2bdc71ece..172410a9e0274 100644 --- a/drivers/thermal/sun8i_thermal.c +++ b/drivers/thermal/sun8i_thermal.c @@ -683,6 +683,20 @@ static const struct ths_thermal_chip sun20i_d1_ths = { .calc_temp = sun8i_ths_calc_temp, }; +static const struct ths_thermal_chip sun50i_h616_ths = { + .sensor_num = 4, + .has_bus_clk_reset = true, + .needs_sram = true, + .ft_deviation = 8000, + .offset = 263655, + .scale = 810, + .temp_data_base = SUN50I_H6_THS_TEMP_DATA, + .calibrate = sun50i_h6_ths_calibrate, + .init = sun50i_h6_thermal_init, + .irq_ack = sun50i_h6_irq_ack, + .calc_temp = sun8i_ths_calc_temp, +}; + static const struct of_device_id of_ths_match[] = { { .compatible = "allwinner,sun8i-a83t-ths", .data = &sun8i_a83t_ths }, { .compatible = "allwinner,sun8i-h3-ths", .data = &sun8i_h3_ths }, @@ -692,6 +706,7 @@ static const struct of_device_id of_ths_match[] = { { .compatible = "allwinner,sun50i-h5-ths", .data = &sun50i_h5_ths }, { .compatible = "allwinner,sun50i-h6-ths", .data = &sun50i_h6_ths }, { .compatible = "allwinner,sun20i-d1-ths", .data = &sun20i_d1_ths }, + { .compatible = "allwinner,sun50i-h616-ths", .data = &sun50i_h616_ths }, { /* sentinel */ }, }; MODULE_DEVICE_TABLE(of, of_ths_match); -- 2.25.1
WARNING: multiple messages have this Message-ID (diff)
From: Andre Przywara <andre.przywara@arm.com> To: Vasily Khoruzhick <anarsoul@gmail.com>, Yangtao Li <tiny.windzz@gmail.com>, Chen-Yu Tsai <wens@csie.org>, Jernej Skrabec <jernej.skrabec@gmail.com>, Samuel Holland <samuel@sholland.org> Cc: "Rafael J . Wysocki" <rafael@kernel.org>, Daniel Lezcano <daniel.lezcano@linaro.org>, Zhang Rui <rui.zhang@intel.com>, Lukasz Luba <lukasz.luba@arm.com>, Rob Herring <robh+dt@kernel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>, Conor Dooley <conor+dt@kernel.org>, Martin Botka <martin.botka@somainline.org>, Maksim Kiselev <bigunclemax@gmail.com>, Bob McChesney <bob@electricworry.net>, linux-pm@vger.kernel.org, devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-sunxi@lists.linux.dev Subject: [PATCH v4 6/7] thermal: sun8i: add support for H616 THS controller Date: Fri, 9 Feb 2024 14:42:20 +0000 [thread overview] Message-ID: <20240209144221.3602382-7-andre.przywara@arm.com> (raw) In-Reply-To: <20240209144221.3602382-1-andre.przywara@arm.com> From: Martin Botka <martin.botka@somainline.org> Add support for the thermal sensor found in H616 SoCs, is the same as the H6 thermal sensor controller, but with four sensors. Also the registers readings are wrong, unless a bit in the first SYS_CFG register cleared, so set exercise the SRAM regmap to take care of that. Signed-off-by: Martin Botka <martin.botka@somainline.org> Signed-off-by: Andre Przywara <andre.przywara@arm.com> --- drivers/thermal/sun8i_thermal.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+) diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c index 8a9d2bdc71ece..172410a9e0274 100644 --- a/drivers/thermal/sun8i_thermal.c +++ b/drivers/thermal/sun8i_thermal.c @@ -683,6 +683,20 @@ static const struct ths_thermal_chip sun20i_d1_ths = { .calc_temp = sun8i_ths_calc_temp, }; +static const struct ths_thermal_chip sun50i_h616_ths = { + .sensor_num = 4, + .has_bus_clk_reset = true, + .needs_sram = true, + .ft_deviation = 8000, + .offset = 263655, + .scale = 810, + .temp_data_base = SUN50I_H6_THS_TEMP_DATA, + .calibrate = sun50i_h6_ths_calibrate, + .init = sun50i_h6_thermal_init, + .irq_ack = sun50i_h6_irq_ack, + .calc_temp = sun8i_ths_calc_temp, +}; + static const struct of_device_id of_ths_match[] = { { .compatible = "allwinner,sun8i-a83t-ths", .data = &sun8i_a83t_ths }, { .compatible = "allwinner,sun8i-h3-ths", .data = &sun8i_h3_ths }, @@ -692,6 +706,7 @@ static const struct of_device_id of_ths_match[] = { { .compatible = "allwinner,sun50i-h5-ths", .data = &sun50i_h5_ths }, { .compatible = "allwinner,sun50i-h6-ths", .data = &sun50i_h6_ths }, { .compatible = "allwinner,sun20i-d1-ths", .data = &sun20i_d1_ths }, + { .compatible = "allwinner,sun50i-h616-ths", .data = &sun50i_h616_ths }, { /* sentinel */ }, }; MODULE_DEVICE_TABLE(of, of_ths_match); -- 2.25.1 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2024-02-09 14:42 UTC|newest] Thread overview: 30+ messages / expand[flat|nested] mbox.gz Atom feed top 2024-02-09 14:42 [PATCH v4 0/7] add support for H616 thermal system Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-09 14:42 ` [PATCH v4 1/7] soc: sunxi: sram: export register 0 for THS on H616 Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-14 20:29 ` Jernej Škrabec 2024-02-14 20:29 ` Jernej Škrabec 2024-02-15 1:28 ` Andre Przywara 2024-02-15 1:28 ` Andre Przywara 2024-02-15 21:18 ` Jernej Škrabec 2024-02-15 21:18 ` Jernej Škrabec 2024-02-09 14:42 ` [PATCH v4 2/7] dt-bindings: thermal: sun8i: Add H616 THS controller Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-11 16:31 ` Krzysztof Kozlowski 2024-02-11 16:31 ` Krzysztof Kozlowski 2024-02-09 14:42 ` [PATCH v4 3/7] thermal: sun8i: explain unknown H6 register value Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-14 20:31 ` Jernej Škrabec 2024-02-14 20:31 ` Jernej Škrabec 2024-02-09 14:42 ` [PATCH v4 4/7] thermal: sun8i: extend H6 calibration to support 4 sensors Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-14 20:35 ` Jernej Škrabec 2024-02-14 20:35 ` Jernej Škrabec 2024-02-09 14:42 ` [PATCH v4 5/7] thermal: sun8i: add SRAM register access code Andre Przywara 2024-02-09 14:42 ` Andre Przywara 2024-02-15 21:24 ` Jernej Škrabec 2024-02-15 21:24 ` Jernej Škrabec 2024-02-09 14:42 ` Andre Przywara [this message] 2024-02-09 14:42 ` [PATCH v4 6/7] thermal: sun8i: add support for H616 THS controller Andre Przywara 2024-02-09 14:42 ` [PATCH v4 7/7] arm64: dts: allwinner: h616: Add thermal sensor and zones Andre Przywara 2024-02-09 14:42 ` Andre Przywara
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20240209144221.3602382-7-andre.przywara@arm.com \ --to=andre.przywara@arm.com \ --cc=anarsoul@gmail.com \ --cc=bigunclemax@gmail.com \ --cc=bob@electricworry.net \ --cc=conor+dt@kernel.org \ --cc=daniel.lezcano@linaro.org \ --cc=devicetree@vger.kernel.org \ --cc=jernej.skrabec@gmail.com \ --cc=krzysztof.kozlowski+dt@linaro.org \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-pm@vger.kernel.org \ --cc=linux-sunxi@lists.linux.dev \ --cc=lukasz.luba@arm.com \ --cc=martin.botka@somainline.org \ --cc=rafael@kernel.org \ --cc=robh+dt@kernel.org \ --cc=rui.zhang@intel.com \ --cc=samuel@sholland.org \ --cc=tiny.windzz@gmail.com \ --cc=wens@csie.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.