[PATCH 22/22] mmc: dw_mmc: fix the transfer termination in IDMAC mode

[PATCH 22/22] mmc: dw_mmc: fix the transfer termination in IDMAC mode

[Seungwon Jeon]

In IDMAC mode EVENT_XFER_COMPLETE is set when RI/TI of last descriptor
is done. So if errors are happened in the middle of data transfers,
'dw_mci_stop_dma' during error handing can be called and eventually
prevents this flag to be set.
This results in permanent wait for EVENT_XFER_COMPLETE in 'dw_mci_tasklet_func'.
Therefore, if dma running is stopped forcibly, EVENT_XFER_COMPLETE should be set.

Reported-by: Bing Zhao <bzhao@marvell.com>
Signed-off-by: Doug Anderson <dianders@chromium.org>
Signed-off-by: Seungwon Jeon <tgih.jun@samsung.com>
Tested-by: Alim Akhtar <alim.akhtar@samsung.com>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
---
 drivers/mmc/host/dw_mmc.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 5d9c7e5..10e39ba 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c
@@ -345,10 +345,10 @@ static void dw_mci_stop_dma(struct dw_mci *host)
 	if (host->using_dma) {
 		host->dma_ops->stop(host);
 		host->dma_ops->cleanup(host);
-	} else {
-		/* Data transfer was stopped by the interrupt handler */
-		set_bit(EVENT_XFER_COMPLETE, &host->pending_events);
 	}
+
+	/* Data transfer was stopped by the interrupt handler */
+	set_bit(EVENT_XFER_COMPLETE, &host->pending_events);
 }
 
 static int dw_mci_get_dma_dir(struct mmc_data *data)
-- 
1.7.0.4