Re: Multipath issues with kernel device errors

* Re: Multipath issues with kernel device errors
       [not found]     ` <1188338656.12737.18.camel@linuxchandra>
@ 2007-08-29  6:14       ` Hannes Reinecke
  2007-08-29 13:29         ` Jeffry Bilder
  2007-08-29 16:58         ` Jeffry Bilder
  0 siblings, 2 replies; 4+ messages in thread
From: Hannes Reinecke @ 2007-08-29  6:14 UTC (permalink / raw)
  To: device-mapper development

Chandra Seetharaman wrote:
> You do not have the latest table. 
> Try with the table below (converted from 0.4.8 version's hwtable.c)
> devices {
> 	device {
> 		vendor 		"COMPAQ"
> 		product		"MSA1000"
> 		path_grouping_policy	group_by_prio
> 		path_checker	tur
> 		prio_callout	"/sbin/mpath_prio_alua /dev/%n"
> 		getuid_callout	"/sbin/scsi_id -g -u -s /block/%n"
> 		failback	immediate
> 	}
> }
> 
Errm. Not quite. My sources indicate that this machine
runs the older active/passive firmware, which requires
the 'hp_sw' hardware handler to run properly.

So better use this:
devices {
	device {
		vendor 		"COMPAQ"
		product		"MSA1000"
		hardware_handler	"1 hp_sw"
		path_grouping_policy	group_by_prio
		path_checker	hp_sw
 		prio_callout	"/sbin/mpath_prio_hp_sw /dev/%n"
 		getuid_callout	"/sbin/scsi_id -g -u -s /block/%n"
 		failback	manual
 	}
}

if mpath_prio_hp_sw is missing complain to Ben Marzinski :-)
Alternatively you can use

path_grouping_policy	failover

and omit the prio_callout altogether. But then only one path
per SP are used.

Cheers,

Hannes
-- 
Dr. Hannes Reinecke		      zSeries & Storage
hare@suse.de			      +49 911 74053 688
SUSE LINUX Products GmbH, Maxfeldstr. 5, 90409 Nürnberg
GF: Markus Rex, HRB 16746 (AG Nürnberg)

^ permalink raw reply	[flat|nested] 4+ messages in thread