Re: HP pavilion dv5 1110ew - no hdmi sound

["Bartłomiej Holdenmayer" <bh@habah.com>]

Dnia 2009-02-14, sob o godzinie 16:15 +0100, Vedran Miletić pisze:
> Yes. but you should try a snapshot instead.
> 
> http://ftp.kernel.org/pub/linux/kernel/people/tiwai/alsa/alsa-driver/alsa-driver-unstable-snapshot.tar.bz2
> 
> Vedran Miletić
> 
> 
> 
> On Sat, Feb 14, 2009 at 3:53 PM, Bartłomiej Holdenmayer <bh@habah.com> wrote:
> > Dnia 2009-02-14, sob o godzinie 15:28 +0100, Vedran Miletić pisze:
> >> On Sat, Feb 14, 2009 at 3:22 PM, Bartłomiej Holdenmayer <bh@habah.com> wrote:
> >> > I am not sure if do everything properly.
> >> >
> >> > 1. I did installation of alsa snap with script
> >> > AlsaUpgrade-1.0.x-rev-1.16.sh;
> >> >
> >> > 2. After that, I changed last line in /etc/modprobe.d/alsa-base from:
> >> > options snd-hda-intel enable_msi=1
> >> >
> >> > into:
> >> > options snd-hda-intel enable_msi=1 probe_mask=0x1ff
> >> >
> >> >
> >> > 3. After I restarted alsa with  /etc/init.d/alsasound stop
> >> > and
> >> > /etc/init.d/alsasound start
> >> >
> >> > and get message:
> >> > Starting sound driver: snd-hda-intel done
> >> >
> >> > Am I doing that properly? What should I do (what command) to see
> >> > hda_intel: codec_mask forced to 0xff
> >> >
> >> >
> >> > --
> >> > Pozdrawiam / Regards
> >> > Bartłomiej Holdenmayer
> >> >
> >> > GG:541634; ICQ:33920811; skypename:bartlomiejholdenmayer
> >> >
> >> > _______________________________________________
> >> > Alsa-devel mailing list
> >> > Alsa-devel@alsa-project.org
> >> > http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
> >> >
> >>
> >> Did you try installing snapshot manually? Script could be bad.
> >>
> >> Vedran
> >> _______________________________________________
> >> Alsa-devel mailing list
> >> Alsa-devel@alsa-project.org
> >> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
> >
> > I checked script. It is downloading good snapshot.
> >
> > There are other options in script:
> > ./configure --with-kernel=/usr/src/linux-headers-$KERNEL
> > --with-cards=all --with-card-options=all --with-sequencer=yes
> > --with-oss=yes --prefix=/usr || die "$DRIVER configure failed"
> >
> > I guess everything is ok. I attach the script.
> >
> > --
> > Pozdrawiam / Regards
> > Bartłomiej Holdenmayer
> >
> > GG:541634; ICQ:33920811; skypename:bartlomiejholdenmayer
> >
I did not noticed before there are 2 of them:
alsa-driver-snapshot
alsa-driver-unstable-snapshot
-- 
Pozdrawiam / Regards
Bartłomiej Holdenmayer

GG:541634; ICQ:33920811; skypename:bartlomiejholdenmayer

_______________________________________________
Alsa-devel mailing list
Alsa-devel@alsa-project.org
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel