* [PATCH net] gianfar: Reject out-of-range RX NFC locations
@ 2011-12-17 0:56 Ben Hutchings
0 siblings, 0 replies; 4+ messages in thread
From: Ben Hutchings @ 2011-12-17 0:56 UTC (permalink / raw)
To: David Miller, Sebastian Poehn; +Cc: netdev
Currently the driver only uses location values to maintain an ordered
list of filters. There is nothing to stop the list becoming longer
than the filer hardware can support - the driver will report an error,
but will not roll back the change!
Make it reject location values >= MAX_FILER_IDX, consistent with the
range that gfar_get_cls_all() reports.
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
---
This has not been tested in any way, as I don't have a suitable compiler
installed. Sebastian, please could you review this?
Ben.
drivers/net/ethernet/freescale/gianfar_ethtool.c | 5 +++--
1 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/freescale/gianfar_ethtool.c b/drivers/net/ethernet/freescale/gianfar_ethtool.c
index 5890f4b..5a3b2e5 100644
--- a/drivers/net/ethernet/freescale/gianfar_ethtool.c
+++ b/drivers/net/ethernet/freescale/gianfar_ethtool.c
@@ -1692,8 +1692,9 @@ static int gfar_set_nfc(struct net_device *dev, struct ethtool_rxnfc *cmd)
ret = gfar_set_hash_opts(priv, cmd);
break;
case ETHTOOL_SRXCLSRLINS:
- if (cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
- cmd->fs.ring_cookie >= priv->num_rx_queues) {
+ if ((cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
+ cmd->fs.ring_cookie >= priv->num_rx_queues) ||
+ cmd->fs.location >= MAX_FILER_IDX) {
ret = -EINVAL;
break;
}
--
1.7.4.4
--
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.
^ permalink raw reply related [flat|nested] 4+ messages in thread* [PATCH net] gianfar: Reject out-of-range RX NFC locations
@ 2011-12-17 1:05 Ben Hutchings
2011-12-17 8:39 ` Sebastian Pöhn
0 siblings, 1 reply; 4+ messages in thread
From: Ben Hutchings @ 2011-12-17 1:05 UTC (permalink / raw)
To: David Miller, Sebastian Pöhn; +Cc: netdev
Currently the driver only uses location values to maintain an ordered
list of filters. There is nothing to stop the list becoming longer
than the filer hardware can support - the driver will report an error,
but will not roll back the change!
Make it reject location values >= MAX_FILER_IDX, consistent with the
range that gfar_get_cls_all() reports.
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
---
[Re-sent to what I hope is a current address for Sebastian.]
This has not been tested in any way, as I don't have a suitable compiler
installed. Sebastian, please could you review this?
Ben.
drivers/net/ethernet/freescale/gianfar_ethtool.c | 5 +++--
1 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/freescale/gianfar_ethtool.c b/drivers/net/ethernet/freescale/gianfar_ethtool.c
index 5890f4b..5a3b2e5 100644
--- a/drivers/net/ethernet/freescale/gianfar_ethtool.c
+++ b/drivers/net/ethernet/freescale/gianfar_ethtool.c
@@ -1692,8 +1692,9 @@ static int gfar_set_nfc(struct net_device *dev, struct ethtool_rxnfc *cmd)
ret = gfar_set_hash_opts(priv, cmd);
break;
case ETHTOOL_SRXCLSRLINS:
- if (cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
- cmd->fs.ring_cookie >= priv->num_rx_queues) {
+ if ((cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
+ cmd->fs.ring_cookie >= priv->num_rx_queues) ||
+ cmd->fs.location >= MAX_FILER_IDX) {
ret = -EINVAL;
break;
}
--
1.7.4.4
--
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.
^ permalink raw reply related [flat|nested] 4+ messages in thread* Re: [PATCH net] gianfar: Reject out-of-range RX NFC locations
2011-12-17 1:05 Ben Hutchings
@ 2011-12-17 8:39 ` Sebastian Pöhn
2011-12-19 15:51 ` Ben Hutchings
0 siblings, 1 reply; 4+ messages in thread
From: Sebastian Pöhn @ 2011-12-17 8:39 UTC (permalink / raw)
To: Ben Hutchings, David Miller; +Cc: netdev
On Sat, 2011-12-17 at 01:05 +0000, Ben Hutchings wrote:
> Currently the driver only uses location values to maintain an ordered
> list of filters. There is nothing to stop the list becoming longer
> than the filer hardware can support - the driver will report an error,
> but will not roll back the change!
Sure that it does not do the rollback?
In case of to much filters it should work this way:
# Convert all in temp table
# Compress temp table
# Write out temp table => not enough space => discard temp table &
remove filter from list
>
> Make it reject location values >= MAX_FILER_IDX, consistent with the
> range that gfar_get_cls_all() reports.
>
> Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Reviewed-by: Sebastian Pöhn <sebastian.poehn@googlemail.com>
> ---
> [Re-sent to what I hope is a current address for Sebastian.]
>
> This has not been tested in any way, as I don't have a suitable compiler
> installed. Sebastian, please could you review this?
Unfortunately I haven't too ...
>
> Ben.
>
> drivers/net/ethernet/freescale/gianfar_ethtool.c | 5 +++--
> 1 files changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/net/ethernet/freescale/gianfar_ethtool.c b/drivers/net/ethernet/freescale/gianfar_ethtool.c
> index 5890f4b..5a3b2e5 100644
> --- a/drivers/net/ethernet/freescale/gianfar_ethtool.c
> +++ b/drivers/net/ethernet/freescale/gianfar_ethtool.c
> @@ -1692,8 +1692,9 @@ static int gfar_set_nfc(struct net_device *dev, struct ethtool_rxnfc *cmd)
> ret = gfar_set_hash_opts(priv, cmd);
> break;
> case ETHTOOL_SRXCLSRLINS:
> - if (cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
> - cmd->fs.ring_cookie >= priv->num_rx_queues) {
> + if ((cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
> + cmd->fs.ring_cookie >= priv->num_rx_queues) ||
> + cmd->fs.location >= MAX_FILER_IDX) {
> ret = -EINVAL;
> break;
> }
> --
> 1.7.4.4
>
>
^ permalink raw reply [flat|nested] 4+ messages in thread* Re: [PATCH net] gianfar: Reject out-of-range RX NFC locations
2011-12-17 8:39 ` Sebastian Pöhn
@ 2011-12-19 15:51 ` Ben Hutchings
0 siblings, 0 replies; 4+ messages in thread
From: Ben Hutchings @ 2011-12-19 15:51 UTC (permalink / raw)
To: Sebastian Pöhn; +Cc: David Miller, netdev
On Sat, 2011-12-17 at 09:39 +0100, Sebastian Pöhn wrote:
> On Sat, 2011-12-17 at 01:05 +0000, Ben Hutchings wrote:
> > Currently the driver only uses location values to maintain an ordered
> > list of filters. There is nothing to stop the list becoming longer
> > than the filer hardware can support - the driver will report an error,
> > but will not roll back the change!
> Sure that it does not do the rollback?
> In case of to much filters it should work this way:
> # Convert all in temp table
> # Compress temp table
> # Write out temp table => not enough space => discard temp table &
> remove filter from list
You're right, I must have misread the code previously. Therefore, I
withdraw this patch for the time being.
> > Make it reject location values >= MAX_FILER_IDX, consistent with the
> > range that gfar_get_cls_all() reports.
I do however think that this should be consistent, and I would like to
reserve some 'special' location values. But, for compatibility, it may
be necessary to use some other method to distinguish them (e.g. another
flow_type flag.)
Ben.
> > Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
> Reviewed-by: Sebastian Pöhn <sebastian.poehn@googlemail.com>
> > ---
> > [Re-sent to what I hope is a current address for Sebastian.]
> >
> > This has not been tested in any way, as I don't have a suitable compiler
> > installed. Sebastian, please could you review this?
> Unfortunately I haven't too ...
> >
> > Ben.
> >
> > drivers/net/ethernet/freescale/gianfar_ethtool.c | 5 +++--
> > 1 files changed, 3 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/net/ethernet/freescale/gianfar_ethtool.c b/drivers/net/ethernet/freescale/gianfar_ethtool.c
> > index 5890f4b..5a3b2e5 100644
> > --- a/drivers/net/ethernet/freescale/gianfar_ethtool.c
> > +++ b/drivers/net/ethernet/freescale/gianfar_ethtool.c
> > @@ -1692,8 +1692,9 @@ static int gfar_set_nfc(struct net_device *dev, struct ethtool_rxnfc *cmd)
> > ret = gfar_set_hash_opts(priv, cmd);
> > break;
> > case ETHTOOL_SRXCLSRLINS:
> > - if (cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
> > - cmd->fs.ring_cookie >= priv->num_rx_queues) {
> > + if ((cmd->fs.ring_cookie != RX_CLS_FLOW_DISC &&
> > + cmd->fs.ring_cookie >= priv->num_rx_queues) ||
> > + cmd->fs.location >= MAX_FILER_IDX) {
> > ret = -EINVAL;
> > break;
> > }
> > --
> > 1.7.4.4
> >
> >
>
>
--
Ben Hutchings, Staff Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.
^ permalink raw reply [flat|nested] 4+ messages in thread
end of thread, other threads:[~2011-12-19 15:51 UTC | newest]
Thread overview: 4+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2011-12-17 0:56 [PATCH net] gianfar: Reject out-of-range RX NFC locations Ben Hutchings
2011-12-17 1:05 Ben Hutchings
2011-12-17 8:39 ` Sebastian Pöhn
2011-12-19 15:51 ` Ben Hutchings
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.