[PATCH] ASoC: wm8994: Don't allow reconfiguration of FLL when it provides SYSCLK

[PATCH] ASoC: wm8994: Don't allow reconfiguration of FLL when it provides SYSCLK

[Mark Brown]

Rather than trying to work around machine drivers which try to reprogram
the FLL while it is providing SYSCLK just return an error if they try.
This will avoid audio glitches during FLL reconfiguration, or at least
move the introduction of the glitches to the machine driver.

Since disabling the source for an active SYSCLK is not supported in the
first place systems shouldn't be doing this in the first place.

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
---
 sound/soc/codecs/wm8994.c |   35 +++++++++++++++++------------------
 1 files changed, 17 insertions(+), 18 deletions(-)

diff --git a/sound/soc/codecs/wm8994.c b/sound/soc/codecs/wm8994.c
index cc6023c..f43b2ec 100644
--- a/sound/soc/codecs/wm8994.c
+++ b/sound/soc/codecs/wm8994.c
@@ -1903,24 +1903,20 @@ static int _wm8994_set_fll(struct snd_soc_codec *codec, int id, int src,
 	struct wm8994 *control = wm8994->wm8994;
 	int reg_offset, ret;
 	struct fll_div fll;
-	u16 reg, aif1, aif2;
+	u16 reg, clk1, aif_reg, aif_src;
 	unsigned long timeout;
 	bool was_enabled;
 
-	aif1 = snd_soc_read(codec, WM8994_AIF1_CLOCKING_1)
-		& WM8994_AIF1CLK_ENA;
-
-	aif2 = snd_soc_read(codec, WM8994_AIF2_CLOCKING_1)
-		& WM8994_AIF2CLK_ENA;
-
 	switch (id) {
 	case WM8994_FLL1:
 		reg_offset = 0;
 		id = 0;
+		aif_src = 0x10;
 		break;
 	case WM8994_FLL2:
 		reg_offset = 0x20;
 		id = 1;
+		aif_src = 0x18;
 		break;
 	default:
 		return -EINVAL;
@@ -1962,11 +1958,20 @@ static int _wm8994_set_fll(struct snd_soc_codec *codec, int id, int src,
 	if (ret < 0)
 		return ret;
 
-	/* Gate the AIF clocks while we reclock */
-	snd_soc_update_bits(codec, WM8994_AIF1_CLOCKING_1,
-			    WM8994_AIF1CLK_ENA, 0);
-	snd_soc_update_bits(codec, WM8994_AIF2_CLOCKING_1,
-			    WM8994_AIF2CLK_ENA, 0);
+	/* Make sure that we're not providing SYSCLK right now */
+	clk1 = snd_soc_read(codec, WM8994_CLOCKING_1);
+	if (clk1 & WM8994_SYSCLK_SRC)
+		aif_reg = WM8994_AIF2_CLOCKING_1;
+	else
+		aif_reg = WM8994_AIF1_CLOCKING_1;
+	reg = snd_soc_read(codec, aif_reg);
+
+	if ((reg & WM8994_AIF1CLK_ENA) &&
+	    (reg & WM8994_AIF1CLK_SRC_MASK) == aif_src) {
+		dev_err(codec->dev, "FLL%d is currently providing SYSCLK\n",
+			id + 1);
+		return -EBUSY;
+	}
 
 	/* We always need to disable the FLL while reconfiguring */
 	snd_soc_update_bits(codec, WM8994_FLL1_CONTROL_1 + reg_offset,
@@ -2052,12 +2057,6 @@ static int _wm8994_set_fll(struct snd_soc_codec *codec, int id, int src,
 	wm8994->fll[id].out = freq_out;
 	wm8994->fll[id].src = src;
 
-	/* Enable any gated AIF clocks */
-	snd_soc_update_bits(codec, WM8994_AIF1_CLOCKING_1,
-			    WM8994_AIF1CLK_ENA, aif1);
-	snd_soc_update_bits(codec, WM8994_AIF2_CLOCKING_1,
-			    WM8994_AIF2CLK_ENA, aif2);
-
 	configure_clock(codec);
 
 	return 0;
-- 
1.7.9.1