[U-Boot] [PATCH v3 08/12] i2c: s3c24x0: reduce transmission status timeout

[Przemyslaw Marczak <p.marczak@samsung.com>]

If no device is connected to I2C bus, the i2c probe command
can take a lot of time for probe each address. This commit
reduces the busy timeout to 10ms for standard and high speed
modes. This doesn't break the transmission an also allow for
properly probe the devices.

Signed-off-by: Przemyslaw Marczak <p.marczak@samsung.com>

Changes v3:
- new commit, after split the next one
---
 drivers/i2c/s3c24x0_i2c.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/s3c24x0_i2c.c b/drivers/i2c/s3c24x0_i2c.c
index fd328f0..3129c7f 100644
--- a/drivers/i2c/s3c24x0_i2c.c
+++ b/drivers/i2c/s3c24x0_i2c.c
@@ -111,9 +111,9 @@
 #define I2C_START_STOP	0x20	/* START / STOP */
 #define I2C_TXRX_ENA	0x10	/* I2C Tx/Rx enable */
 
-#define I2C_TIMEOUT_MS 1000		/* 1 second */
+#define I2C_TIMEOUT_MS 10		/* 10 ms */
 
-#define	HSI2C_TIMEOUT_US 100000 /* 100 ms, finer granularity */
+#define	HSI2C_TIMEOUT_US 10000 /* 10 ms, finer granularity */
 
 
 /* To support VCMA9 boards and other who dont define max_i2c_num */
-- 
1.9.1