[U-Boot] [PATCH] sunxi: bpi-m3: Enable eMMC

[U-Boot] [PATCH] sunxi: bpi-m3: Enable eMMC

[Jagan Teki]

From: Jagan Teki <jagan@amarulasolutions.com>

Add CONFIG_MMC_SUNXI_SLOT_EXTRA=2 to use eMMC on
BPI_M3 board.

Cc: Chen-Yu Tsai <wens@csie.org>
Cc: Maxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Tested-by: Jagan Teki <jagan@amarulasolutions.com>
---
 configs/Sinovoip_BPI_M3_defconfig | 1 +
 1 file changed, 1 insertion(+)

diff --git a/configs/Sinovoip_BPI_M3_defconfig b/configs/Sinovoip_BPI_M3_defconfig
index 45eadcb..c53ade0 100644
--- a/configs/Sinovoip_BPI_M3_defconfig
+++ b/configs/Sinovoip_BPI_M3_defconfig
@@ -12,6 +12,7 @@ CONFIG_USB0_ID_DET="PH11"
 CONFIG_USB1_VBUS_PIN="PD24"
 CONFIG_AXP_GPIO=y
 CONFIG_SATAPWR="PD25"
+CONFIG_MMC_SUNXI_SLOT_EXTRA=2
 CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-sinovoip-bpi-m3"
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_CONSOLE_MUX=y
-- 
2.7.4

[U-Boot] [PATCH] sunxi: bpi-m3: Enable eMMC

[Jagan Teki]

On Mon, Aug 28, 2017 at 2:33 PM, Jagan Teki <jagannadh.teki@gmail.com> wrote:
> From: Jagan Teki <jagan@amarulasolutions.com>
>
> Add CONFIG_MMC_SUNXI_SLOT_EXTRA=2 to use eMMC on
> BPI_M3 board.
>
> Cc: Chen-Yu Tsai <wens@csie.org>
> Cc: Maxime Ripard <maxime.ripard@free-electrons.com>
> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
> Tested-by: Jagan Teki <jagan@amarulasolutions.com>

Since for eMMC fixes to test on A83T in Mainline, this patch need to
enable eMMC on BPI-M3.

So,
Applied to u-boot-sunxi/master because

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.