[GIT PULL] thermal material for v6.6-rc1

* [GIT PULL] thermal material for v6.6-rc1
@ 2023-08-29 13:09 Daniel Lezcano
  2023-08-29 16:51 ` Rafael J. Wysocki
  0 siblings, 1 reply; 2+ messages in thread
From: Daniel Lezcano @ 2023-08-29 13:09 UTC (permalink / raw)
  To: Rafael J. Wysocki
  Cc: Mikko Perttunen, Yinbo Zhu, Li Zetao, Andrei Coardos,
	Nícolas F. R. A. Prado, Krzysztof Kozlowski, Ruan Jinjie,
	Chen Jiahao, Mark Brown, Yangtao Li, Min-Hua Chen, Ahmad Fatoum,
	Minjie Du, Linux Kernel Mailing List, Linux PM mailing list

Hi Rafael,

please consider this pull request for the thermal material

Thanks

The following changes since commit f6a756e8fb12923f0e3996a575e935e94f3594eb:

   thermal: Explicitly include correct DT includes (2023-07-31 20:03:42 
+0200)

are available in the Git repository at:

ssh://git@gitolite.kernel.org/pub/scm/linux/kernel/git/thermal/linux.git 
tags/thermal-v6.6-rc1

for you to fetch changes up to 1ef5a9f61457b921158ef03f3a2b3e789b41be9f:

   thermal/drivers/tegra-bpmp: Check if BPMP supports trip points 
(2023-08-22 19:10:28 +0200)

----------------------------------------------------------------
- Check if the Tegra BPMP supports the trip points in order to set the
   .set_trips callback (Mikko Perttunen)

- Add the new Loongson-2 thermal sensor along with the DT bindings
   (Yinbo Zhu)

- Use IS_ERR_OR_NULL helper to replace a double test on the TI bandgap
   sensor (Li Zetao)

- Remove the call to platform_set_drvdata() as there is no call to
   platform_get_drvdata() in a bunch of drivers where that happens
   (Andrei Coardos)

- Switch the Mediatek LVTS mode to filtered in order to enable the
   interrupts (Nícolas F. R. A. Prado)

- Fix Wvoid-pointer-to-enum-cast warning on the Exynos TMU (Krzysztof
   Kozlowski)

- Remove redundant usage of of_match_ptr() as the driver db8500
   already depends on CONFIG_OF (Ruan Jinjie)

- Remove redundant dev_err_probe() because the underlying function
   already called it in the Mediatek sensor (Chen Jiahao)

- Free calibration nvmem after reading it on sun8i (Mark Brown)

- Remove useless comment in the code on sun8i (Yangtao Li)

- Make tsens_xxxx_nvmem static to fix sparse warning on QCom tsens 
(Min-Hua Chen)

- Remove error message at probe deferral on imx8mm (Ahmad Fatoum)

- Fix parameter check in lvts_debugfs_init with IS_ERR on Mediatek
   LVTS (Minjie Du)

- Fix the interrupt routine and configuratoin for the Mediatek LVTS
   (Nícolas F. R. A. Prado)

----------------------------------------------------------------
Ahmad Fatoum (1):
       thermal/drivers/imx8mm: Suppress log message on probe deferral

Andrei Coardos (8):
       thermal/drivers/broadcom/sr-thermal: Removed call to 
platform_set_drvdata()
       thermal/drivers/k3_j72xx_bandgap: Removed unneeded call to 
platform_set_drvdata()
       thermal/drivers/k3_bandgap: Remove unneeded call to 
platform_set_drvdata()
       thermal/drivers/broadcom/brcstb_thermal: Removed unneeded 
platform_set_drvdata()
       thermal/drivers/sun8i_thermal: Remove unneeded call to 
platform_set_drvdata()
       thermal/drivers/mediatek/auxadc_thermal: Removed call to 
platform_set_drvdata()
       thermal/drivers/max77620_thermal: Removed unneeded call to 
platform_set_drvdata()
       thermal/drivers/generic-adc: Removed unneeded call to 
platform_set_drvdata()

Chen Jiahao (1):
       thermal/drivers/mediatek: Clean up redundant dev_err_probe()

Krzysztof Kozlowski (1):
       thermal/drivers/samsung: Fix Wvoid-pointer-to-enum-cast warning

Li Zetao (1):
       thermal/drivers/ti-soc-thermal: Use helper function IS_ERR_OR_NULL()

Mark Brown (1):
       thermal/drivers/sun8i: Free calibration nvmem after reading it

Mikko Perttunen (1):
       thermal/drivers/tegra-bpmp: Check if BPMP supports trip points

Min-Hua Chen (1):
       thermal/drivers/tsens: Make tsens_xxxx_nvmem static

Minjie Du (1):
       thermal/drivers/mediatek/lvts: Fix parameter check in 
lvts_debugfs_init()

Nícolas F. R. A. Prado (7):
       thermal/drivers/mediatek/lvts_thermal: Handle IRQ on all controllers
       thermal/drivers/mediatek/lvts_thermal: Honor sensors in immediate 
mode
       thermal/drivers/mediatek/lvts_thermal: Use offset threshold for IRQ
       thermal/drivers/mediatek/lvts_thermal: Disable undesired interrupts
       thermal/drivers/mediatek/lvts_thermal: Don't leave threshold zeroed
       thermal/drivers/mediatek/lvts_thermal: Manage threshold between 
sensors
       thermal/drivers/mediatek/lvts_thermal: Make readings valid in 
filtered mode

Ruan Jinjie (1):
       thermal/drivers/db8500: Remove redundant of_match_ptr()

Yangtao Li (1):
       thermal/drivers/sun8i: Remove unneeded comments

Yinbo Zhu (2):
       thermal/drivers/loongson-2: Add thermal management support
       thermal: dt-bindings: add loongson-2 thermal

  Documentation/devicetree/bindings/thermal/loongson,ls2k-thermal.yaml | 
  44 +++++++++++++
  MAINTAINERS                                                          | 
   8 +++
  drivers/thermal/Kconfig                                              | 
  12 ++++
  drivers/thermal/Makefile                                             | 
   1 +
  drivers/thermal/broadcom/brcmstb_thermal.c                           | 
   1 -
  drivers/thermal/broadcom/sr-thermal.c                                | 
   1 -
  drivers/thermal/db8500_thermal.c                                     | 
   2 +-
  drivers/thermal/imx8mm_thermal.c                                     | 
   6 +-
  drivers/thermal/k3_bandgap.c                                         | 
   1 -
  drivers/thermal/k3_j72xx_bandgap.c                                   | 
   2 -
  drivers/thermal/loongson2_thermal.c                                  | 
169 ++++++++++++++++++++++++++++++++++++++++++++++++
  drivers/thermal/max77620_thermal.c                                   | 
   2 -
  drivers/thermal/mediatek/auxadc_thermal.c                            | 
   2 -
  drivers/thermal/mediatek/lvts_thermal.c                              | 
175 +++++++++++++++++++++++++++++++++++++-------------
  drivers/thermal/qcom/tsens-v0_1.c                                    | 
   6 +-
  drivers/thermal/qcom/tsens-v1.c                                      | 
   2 +-
  drivers/thermal/samsung/exynos_tmu.c                                 | 
   2 +-
  drivers/thermal/sun8i_thermal.c                                      | 
   8 +--
  drivers/thermal/tegra/tegra-bpmp-thermal.c                           | 
  52 ++++++++++++++-
  drivers/thermal/thermal-generic-adc.c                                | 
   1 -
  drivers/thermal/ti-soc-thermal/ti-bandgap.c                          | 
   2 +-
  21 files changed, 426 insertions(+), 73 deletions(-)
  create mode 100644 
Documentation/devicetree/bindings/thermal/loongson,ls2k-thermal.yaml
  create mode 100644 drivers/thermal/loongson2_thermal.c

-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog

^ permalink raw reply	[flat|nested] 2+ messages in thread