[PATCH V4 4/4] ARM64: dts: imx: add i.MX8QXP thermal support

[Anson Huang <anson.huang@nxp.com>]

Add i.MX8QXP CPU thermal zone support.

Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
---
ChangeLog:
V3->V4:
  *move the tsens node to inside of SCU node as it is belonging to SCU.
---
 arch/arm64/boot/dts/freescale/imx8qxp.dtsi | 27 +++++++++++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8qxp.dtsi b/arch/arm64/boot/dts/freescale/imx8qxp.dtsi
index 9b08688..48f622c 100644
--- a/arch/arm64/boot/dts/freescale/imx8qxp.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8qxp.dtsi
@@ -9,6 +9,7 @@
 #include <dt-bindings/firmware/imx/rsrc.h>
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/pinctrl/pads-imx8qxp.h>
+#include <dt-bindings/thermal/thermal.h>
 
 #include "imx8-ca35.dtsi"
 
@@ -87,6 +88,12 @@
 		rtc: rtc {
 			compatible = "fsl,imx8qxp-sc-rtc";
 		};
+
+		tsens: thermal-sensor {
+			compatible = "fsl,imx8qxp-sc-thermal";
+			tsens-num = <1>;
+			#thermal-sensor-cells = <1>;
+		};
 	};
 
 	adma_subsys: bus@59000000 {
@@ -410,4 +417,24 @@
 		#size-cells = <1>;
 		ranges = <0x5f000000 0x0 0x5f000000 0x1000000>;
 	};
+
+	thermal_zones: thermal-zones {
+		cpu-thermal0 {
+			polling-delay-passive = <250>;
+			polling-delay = <2000>;
+			thermal-sensors = <&tsens 355>;
+			trips {
+				cpu_alert0: trip0 {
+					temperature = <107000>;
+					hysteresis = <2000>;
+					type = "passive";
+				};
+				cpu_crit0: trip1 {
+					temperature = <127000>;
+					hysteresis = <2000>;
+					type = "critical";
+				};
+			};
+		};
+	};
 };
-- 
2.7.4