[PATCH 02/10] PCI: perform dbi regs write lock towards the end

[Vidya Sagar <vidyas@nvidia.com>]

Remove multiple write enable and disable sequences of dbi registers as
Tegra194 implements writes to BAR-0 register (offset: 0x10) controlled by
DBI write-lock enable bit thereby not allowing any further writes to BAR-0
register in config space to take place. Hence disabling write permission
only towards the end.

Signed-off-by: Vidya Sagar <vidyas@nvidia.com>
---
 drivers/pci/controller/dwc/pcie-designware-host.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/drivers/pci/controller/dwc/pcie-designware-host.c b/drivers/pci/controller/dwc/pcie-designware-host.c
index 15add3cf3945..e17213f2217e 100644
--- a/drivers/pci/controller/dwc/pcie-designware-host.c
+++ b/drivers/pci/controller/dwc/pcie-designware-host.c
@@ -670,7 +670,6 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
 	val &= 0xffff00ff;
 	val |= 0x00000100;
 	dw_pcie_writel_dbi(pci, PCI_INTERRUPT_LINE, val);
-	dw_pcie_dbi_ro_wr_dis(pci);
 
 	/* Setup bus numbers */
 	val = dw_pcie_readl_dbi(pci, PCI_PRIMARY_BUS);
@@ -710,8 +709,6 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
 
 	dw_pcie_wr_own_conf(pp, PCI_BASE_ADDRESS_0, 4, 0);
 
-	/* Enable write permission for the DBI read-only register */
-	dw_pcie_dbi_ro_wr_en(pci);
 	/* Program correct class for RC */
 	dw_pcie_wr_own_conf(pp, PCI_CLASS_DEVICE, 2, PCI_CLASS_BRIDGE_PCI);
 	/* Better disable write permission right after the update */
-- 
2.7.4